The effect of electrolyte filling method on the performance of dye-sensitized solar cells

The effect of electrolyte filling method on the performance of the dye-sensitized solar cells is investigated with the segmented cell method, a recent technique which is very simple but effective as it can be used to examine all the photovoltaic characteristics. The electrolyte filling techniques compared were single injection, which is typically used in small laboratory cells, and pumping the electrolyte through the cell several times, which is often used for larger cells and modules. Significant photovoltage and photocurrent variations occur with the repeated pumping of the electrolyte in the cell preparation. Transient and charge extraction measurements confirmed that the differences in open circuit voltage were due to the shifts of the TiO2 conduction band and time correlated single photon counting confirmed that the reduction of short circuit current was largely due to reduced electron injection correlated with the increasing conduction band edge in the studied cases. This was interpreted as an effect of molecular filtering by the TiO2 causing an accumulation of electrolyte additives (4-tert-butylpyridine and benzimidazole) near the electrolyte filling hole, the concentration of which increased with repeated pumping of the electrolyte. Interestingly, spatial variations were seen not only in the relative TiO2 conduction band energy but also in the density of trap states. In this contribution it is demonstrated how the changes in the conduction band can be separated from the changes in the density of trap states which is an essential for the correct interpretation of the data.Peer reviewe

Effect of molecular filtering and electrolyte composition on the spatial variation in performance of dye solar cells

It is demonstrated that the molecular filtering effect of TiO2 has a significant influence on dye solar cell (DSC) performance. As electrolyte is injected to a DSC, some of the electrolyte components adsorb to the surface TiO2 (here 4-tert-butylpyridine and 1-methyl-benzimidazole) and accumulate near the electrolyte filling hole resulting in varying electrolyte composition and performance across the cell. The spatial performance distribution was investigated with a new method, the segment cell method. Not only is the segmented cell method simple and cheap when compared to the only other method for examining spatial variation (photocurrent mapping), it also has the major advantage of allowing the spatial variation in all other operating parameters to be assessed. Here the molecular filtering effect was to influence the cell performance in case of all the five studied electrolytes causing up to 35% losses in efficiency. Raman spectra indicated that the loss in photocurrent in the electrolyte filling was in correlation with the loss of thiocyanate ligands suggesting that dye regeneration may also be a significant factor in addition to electron injection in some of the cells. There were also shifts in the absorption spectra the photoelectrodes which further supported changes in the thiocyanate ligands. Besides absorption changes, there were additional shifts in the IPCE spectra which may relate to deprotonation of the dye. The efficiency losses were reduced to ∼10% with contemporary electrolyte compositions.Peer reviewe

Interdye Hole Transport Accelerates Recombination in Dye Sensitized Mesoporous Films

Charge recombination between oxidized dyes attached to mesoporous TiO2 and electrons in the TiO2 was studied in inert electrolytes using transient absorption spectroscopy. Simultaneously, hole transport within the dye monolayers was monitored by transient absorption anisotropy. The rate of recombination decreased when hole transport was inhibited selectively, either by decreasing the dye surface coverage or by changing the electrolyte environment. From Monte Carlo simulations of electron and hole diffusion in a particle, modeled as a cubic structure, we identify the conditions under which hole lifetime depends on the hole diffusion coefficient for the case of normal (disorder free) diffusion. From simulations of transient absorption and transient absorption anisotropy, we find that the rate and the dispersive character of hole transport in the dye monolayer observed spectroscopically can be explained by incomplete coverage and disorder in the monolayer. We show that dispersive transport in the dye monolayer combined with inhomogeneity in the TiO2 surface reactivity can contribute to the observed stretched electron-hole recombination dynamics and electron density dependence of hole lifetimes. Our experimental and computational analysis of lateral processes at interfaces can be applied to investigate and optimize charge transport and recombination in solar energy conversion devices using electrodes functionalized with molecular light absorbers and catalysts

The role of hole transport between dyes in solid-state dye-sensitized solar cells

In dye-sensitized solar cells (DSSCs) photogenerated positive charges are normally considered to be carried away from the dyes by a separate phase of hole-transporting material (HTM). We show that there can also be significant transport within the dye monolayer itself before the hole reaches the HTM. We quantify the fraction of dye regeneration in solid-state DSSCs that can be attributed to this process. By using cyclic voltammetry and transient anisotropy spectroscopy, we demonstrate that the rate of interdye hole transport is prevented both on micrometer and nanometer length scales by reducing the dye loading on the TiO₂ surface. The dye regeneration yield is quantified for films with high and low dye loadings (with and without hole percolation in the dye monolayer) infiltrated with varying levels of HTM. Interdye hole transport can account for >50% of the overall dye regeneration with low HTM pore filling. This is reduced to about 5% when the infiltration of the HTM in the pores is optimized in 2 μm thick films. Finally, we use hole transport in the dye monolayer to characterize the spatial distribution of the HTM phase in the pores of the dyed mesoporous TiO₂

Optoelectronic Studies of Methylammonium Lead Iodide Perovskite Solar Cells with Mesoporous TiO2: Separation of Electronic and Chemical Charge Storage, Understanding Two Recombination Lifetimes, and the Evolution of Band Offsets during J-V Hysteresis

Methylammonium lead iodide (MAPI) cells of the design FTO/sTiO2/ mpTiO2/MAPI/Spiro-OMeTAD/Au, where FTO is fluorine-doped tin oxide, sTiO2 indicates solid-TiO2, and mpTiO2 is mesoporous TiO2, are studied using transient photovoltage (TPV), differential capacitance, charge extraction, current interrupt, and chronophotoamperometry. We show that in mpTiO2/MAPI cells there are two kinds of extractable charge stored under operation: a capacitive electronic charge (&sim;0.2 &mu;C/ cm2) and another, larger charge (40 &mu;C/cm2), possibly related to mobile ions. Transient photovoltage decays are strongly double exponential with two time constants that differ by a factor of &sim;5, independent of bias light intensity. The fast decay (&sim;1 &mu;s at 1 sun) is assigned to the predominant charge recombination pathway in the cell. We examine and reject the possibility that the fast decay is due to ferroelectric relaxation or to the bulk photovoltaic effect. Like many MAPI solar cells, the studied cells show significant J&minus;V hysteresis. Capacitance vs open circuit voltage (Voc) data indicate that the hysteresis involves a change in internal potential gradients, likely a shift in band offset at the TiO2/MAPI interface. The TPV results show that the Voc hysteresis is not due to a change in recombination rate constant. Calculation of recombination flux at Voc suggests that the hysteresis is also not due to an increase in charge separation efficiency and that charge generation is not a function of applied bias. We also show that the J&minus;V hysteresis is not a light driven effect but is caused by exposure to electrical bias, light or dark.</div

Auditory spatial representations of the world are compressed in blind humans

Compared to sighted listeners, blind listeners often display enhanced auditory spatial abilities such as localization in azimuth. However, less is known about whether blind humans can accurately judge distance in extrapersonal space using auditory cues alone. Using virtualization techniques, we show that auditory spatial representations of the world beyond the peripersonal space of blind listeners are compressed compared to those for normally sighted controls. Blind participants overestimated the distance to nearby sources, and underestimated the distance to remote sound sources, in both reverberant and anechoic environments, and for speech, music and noise signals. Functions relating judged and actual virtual distance were well fitted by compressive power functions, indicating that the absence of visual information regarding the distance of sound sources may prevent accurate calibration of the distance information provided by auditory signals

Optoelectronic Studies of Methylammonium Lead Iodide Perovskite Solar Cells with Mesoporous TiO2: Separation of Electronic and Chemical Charge Storage

Methylammonium lead iodide (MAPI) cells of the design FTO/sTiO2/ mpTiO2/MAPI/Spiro-OMeTAD/Au, where FTO is fluorine-doped tin oxide, sTiO2 indicates solid-TiO2, and mpTiO2 is mesoporous TiO2, are studied using transient photovoltage (TPV), differential capacitance, charge extraction, current interrupt, and chronophotoamperometry. We show that in mpTiO2/MAPI cells there are two kinds of extractable charge stored under operation: a capacitive electronic charge (&sim;0.2 &mu;C/ cm2) and another, larger charge (40 &mu;C/cm2), possibly related to mobile ions. Transient photovoltage decays are strongly double exponential with two time constants that differ by a factor of &sim;5, independent of bias light intensity. The fast decay (&sim;1 &mu;s at 1 sun) is assigned to the predominant charge recombination pathway in the cell. We examine and reject the possibility that the fast decay is due to ferroelectric relaxation or to the bulk photovoltaic effect. Like many MAPI solar cells, the studied cells show significant J&minus;V hysteresis. Capacitance vs open circuit voltage (Voc) data indicate that the hysteresis involves a change in internal potential gradients, likely a shift in band offset at the TiO2/MAPI interface. The TPV results show that the Voc hysteresis is not due to a change in recombination rate constant. Calculation of recombination flux at Voc suggests that the hysteresis is also not due to an increase in charge separation efficiency and that charge generation is not a function of applied bias. We also show that the J&minus;V hysteresis is not a light driven effect but is caused by exposure to electrical bias, light or dark.</div

The Mechanism of Iodine Reduction by TiO₂ Electrons and the Kinetics of Recombination in Dye-Sensitized Solar Cells

Electron transfer from TiO₂ to iodine/iodide electrolytes proceeds via reduction of either I₃^– or uncomplexed I₂ (free iodine), but which route predominates has not previously been determined. By measurement of the electron lifetime while independently varying free iodine or I₃^– concentrations, we find the lifetime is correlated with free-iodine concentration and independent of I₃^– concentration. This trend supports the hypothesis that electron recombination to the electrolyte occurs predominantly by iodine reduction rather than reduction of triiodide