Reference Measurements of the Longitudinal Impedance in the CERN SPS

First reference measurements of the longitudinal impedance were made with beam in the SPS machine in 1999 to quantify the results of the impedance reduction programme, completed in 2001. The 2001 data showed that the low-frequency inductive impedance had been reduced by a factor 2.5 and that bunch lengthening due to the microwave instability was absent up to the ultimate LHC bunch intensity. Measurements of the quadrupole frequency shift with intensity in the following years suggest a significant increase in impedance (which nevertheless remains below the 1999 level) due to the installation of eight extraction kickers for beam transfer to the LHC. The experimental results are compared with expectations based on the known longitudinal impedance of the SPS

Ballistic Performance of Porous Ceramic Thermal Protection Systems at 9 km/s

Porous-ceramic, thermal-protection-systems are used heavily in current reentry vehicles like the Orbiter, and they are currently being proposed for the next generation of manned spacecraft, Orion. These materials insulate the structural components and sensitive electronic components of a spacecraft against the intense thermal environments of atmospheric reentry. Furthermore, these materials are also highly exposed to space environmental hazards like meteoroid and orbital debris impacts. This paper discusses recent impact testing up to 9 km/s on ceramic tiles similar to those used on the Orbiter. These tiles have a porous-batting of nominally 8 lb/cubic ft alumina-fiber-enhanced-thermal-barrier (AETB8) insulating material coated with a damage-resistant, toughened-unipiece-fibrous-insulation (TUFI) layer

Measurements of the LHC longitudinal resistive impedance with beam

The resistive part of the longitudinal impedance contributes to the heat deposition on different elements in the LHC ring including the beam screens, where it has to be absorbed by the cryogenic system and can be a practical limitation for the maximum beam intensity. In this paper, we present the first measurements of the LHC longitudinal resistive impedance with beam, done through synchronous phase shift measurements duringMachine Development sessions in 2012. Synchronous phase shift is measured for different bunch intensities and lengths using the high-precision LHC Beam Phase Module and then data are post-processed to further increase the accuracy. The dependence of the energy loss per particle on bunch length is then obtained and compared with the expected values found using the LHC impedance model

In-facility transport code review

The following computer codes were reviewed by the In-Facility Transport Working Group for application to the in-facility transport of radioactive aerosols, flammable gases, and/or toxic gases: (1) CONTAIN, (2) FIRAC, (3) GASFLOW, (4) KBERT, and (5) MELCOR. Based on the review criteria as described in this report and the versions of each code available at the time of the review, MELCOR is the best code for the analysis of in-facility transport when multidimensional effects are not significant. When multi-dimensional effects are significant, GASFLOW should be used

Progress with the Upgrade of the SPS for the HL-LHC Era

The demanding beam performance requirements of the High Luminosity (HL-) LHC project translate into a set of requirements and upgrade paths for the LHC injector complex. In this paper the performance requirements for the SPS and the known limitations are reviewed in the light of the 2012 operational experience. The various SPS upgrades in progress and still under consideration are described, in addition to the machine studies and simulations performed in 2012. The expected machine performance reach is estimated on the basis of the present knowledge, and the remaining decisions that still need to be made concerning upgrade options are detailed.Comment: 3 p. Presented at 4th International Particle Accelerator Conference (IPAC 2013

Low-lying, Rydberg states of polycyclic aromatic hydrocarbons (PAHs) and cyclic alkanes

TD-DFT calculations of low-lying, Rydberg states of a series of polycyclic hydrocarbons and cyclic alkanes are presented. Systematic variations in binding energies and photoelectron angular distributions for the first members of the s, p and d Rydberg series are predicted for increasing molecular complexity. Calculated binding energies are found to be in very good agreement with literature values where they exist for comparison. Experimental angle-resolved photoelectron spectroscopy results are presented for coronene, again showing very good agreement with theoretical predictions of binding energies and also for photoelectron angular distributions. The Dyson orbitals for the small "hollow" carbon structures, cubane, adamantane and dodecahedrane, are shown to have close similarities to atomic s, p and d orbitals, similar to the superatom molecular orbitals (SAMOs) reported for fullerenes, indicating that these low-lying, diffuse states are not restricted to π-conjugated molecules. © 2017 the Owner Societies

CERN SPS Impedance in 2007

Each year several measurements of the beam coupling impedance are performed in both longitudinal and transverse planes of the CERN Super Proton Synchrotron to keep track of its evolution. In parallel, after the extensive and successful campaign of identification, classification and cure of the possible sources of (mainly longitudinal) impedance between 1998 and 2001, a new campaign (essentially for the transverse impedance this time) has started few years ago, in view of the operation of the SPS with higher intensity for the LHC luminosity upgrade. The present paper summarizes the results obtained from the measurements performed over the last few years and compares them to our predictions. In particular, it reveals that the longitudinal impedance is reasonably well understood and the main contributors have already been identified. However, the situation is quite different in the transverse plane: albeit the relative evolution of the transverse impedance over the last few years can be well explained by the introduction of the nine MKE kickers necessary for beam extraction towards the LHC, significant contributors to the SPS transverse impedance have not been identified yet

A Comparative Research on the Parliamentary Power of Special Criminal Prosecution

议会特别刑事追究权，是指议会通过弹劾、追诉等手段对以政府首脑或其他高级政治和行政官员为主的公职人员因其实施违法行为或失职行为予以追究特别刑事责任，从而保证高级官员依法并合理地行使公权力，从而维护国家政治和法律秩序的良好运转。在近现代宪政国家，宪法通常创设特别刑事追究权并将其授予议会，这构成议会监督和制衡其他国家机构的重要手段。在宪政实践中，议会特别刑事追究权的正常行使为维护宪法体制的正常运转发挥了重要作用。我国宪法虽规定了人大的质询权和罢免权，但对特别刑事追究权却未作规定。事实上，特别刑事追究权不仅有利于加强代表机关的宪法地位，而且对于我国的人大监督制度也有重要参考价值。因此，本文将从比较法的...The system of parliamentary power of special criminal prosecution aims at the constitutional exercise of administrative powers by accusing the state head and leader on their failure to fulfill their duty. In modern constitutional state, the Constitution created Parliamentary Power of Special Criminal Prosecution to supervise other state organs such as administrative and judicial organs. In the con...学位：法学博士院系专业：法学院法律系_宪法学和行政法学学号：1292006015298

Proton acceleration by irradiation of isolated spheres with an intense laser pulse

We report on experiments irradiating isolated plastic spheres with a peak laser intensity of 2-3 x 10(20) W cm(-2). With a laser focal spot size of 10 mu m full width half maximum (FWHM) the sphere diameter was varied between 520 nm and 19.3 mu m. Maximum proton energies of similar to 25 MeV are achieved for targets matching the focal spot size of 10 mu m in diameter or being slightly smaller. For smaller spheres the kinetic energy distributions of protons become nonmonotonic, indicating a change in the accelerating mechanism from ambipolar expansion towards a regime dominated by effects caused by Coulomb repulsion of ions. The energy conversion efficiency from laser energy to proton kinetic energy is optimized when the target diameter matches the laser focal spot size with efficiencies reaching the percent level. The change of proton acceleration efficiency with target size can be attributed to the reduced cross-sectional overlap of subfocus targets with the laser. Reported experimental observations are in line with 3D3V particle in cell simulations. They make use of well-defined targets and point out pathways for future applications and experiments.DFG via the Cluster of Excellence Munich-Centre for Advanced Photonics (MAP) Transregio SFB TR18NNSA DE-NA0002008Super-MUC pr48meIvo CermakCGC Instruments in design and realization of the Paul trap systemIMPRS-APSLMUexcellent Junior Research FundDAAD|ToIFEEuropean Union's Horizon research and innovation programme 633053Physic