653 research outputs found
Design of Optical/IR Blocking Filters for the Lynx X-Ray Microcalorimeter
The Lynx mission concept, under development ahead of the 2020 Astrophysics Decadal Review, includes the Lynx X-ray Microcalorimeter (LXM) as one of its primary instruments. The LXM uses a microcalorimeter array at the focus of a high-throughput soft x-ray telescope to enable high-resolution nondispersive spectroscopy in the soft x-ray waveband (0.2 to 15 keV) with exquisite angular resolution. Similar to other x-ray microcalorimeters, the LXM uses a set of blocking filters mounted within the dewar that pass the photons of interest (x-rays) while attenuating the out-of-band long-wavelength radiation. Such filters have been successfully used on previous orbital and suborbital instruments; however, the Lynx science objectives, which emphasize observations in the soft x-ray band (<1keV), pose more challenging requirements on the set of LXM blocking filters. We present an introduction to the design of the LXM optical/IR blocking filters and discuss recent advances in filter capability targeted at LXM. In addition, we briefly describe the external filters and the modulated x-ray sources to be used for onboard detector calibration
Generalizing, deleting and distorting information about the experience and communication of chronic pain
Magnetic Calorimeter Option for the Lynx X-Ray Microcalorimeter
One option for the detector technology to implement the Lynx x-ray microcalorimeter (LXM) focal plane arrays is the metallic magnetic calorimeter (MMC). Two-dimensional imaging arrays of MMCs measure the energy of x-ray photons by using a paramagnetic sensor to detect the temperature rise in a microfabricated x-ray absorber. While small arrays of MMCs have previously been demonstrated that have energy resolution better than the 3 eV requirement for LXM, we describe LXM prototype MMC arrays that have 55,800 x-ray pixels, thermally linked to 5688 sensors in hydra configurations, and that have sensor inductance increased to avoid signal loss from the stray inductance in the large-scale arrays when the detectors are read out with microwave superconducting quantum interference device multiplexers, and that use multilevel planarized superconducting wiring to provide low-inductance, low-crosstalk connections to each pixel. We describe the features of recently tested MMC prototype devices and simulations of expected performance in designs opti- mized for the three subarray types in LXM
Solar Neutrinos: Radiative Corrections in Neutrino-Electron Scattering Experiments
Radiative corrections to the electron recoil-energy spectra and to total
cross sections are computed for neutrino-electron scattering by solar
neutrinos. Radiative corrections change monotonically the electron recoil
spectrum for incident \b8 neutrinos, with the relative probability of observing
recoil electrons being reduced by about 4 \% at the highest electron energies.
For and \be7 neutrinos, the recoil spectra are not affected
significantly. Total cross sections for solar neutrino-electron scattering are
reduced by about 2 \% compared to previously computed values. We also calculate
the recoil spectra from N and O neutrinos including radiative
corrections.Comment: 40 pages, uuencoded, Z-compress file
Proximity Effects and Nonequilibrium Superconductivity in Transition-Edge Sensors
We have recently shown that normal-metal/superconductor (N/S) bilayer TESs
(superconducting Transition-Edge Sensors) exhibit weak-link behavior.1 Here we
extend our understanding to include TESs with added noise-mitigating
normal-metal structures (N structures). We find TESs with added Au structures
also exhibit weak-link behavior as evidenced by exponential temperature
dependence of the critical current and Josephson-like oscillations of the
critical current with applied magnetic field. We explain our results in terms
of an effect converse to the longitudinal proximity effect (LoPE)1, the lateral
inverse proximity effect (LaiPE), for which the order parameter in the N/S
bilayer is reduced due to the neighboring N structures. Resistance and critical
current measurements are presented as a function of temperature and magnetic
field taken on square Mo/Au bilayer TESs with lengths ranging from 8 to 130
{\mu}m with and without added N structures. We observe the inverse proximity
effect on the bilayer over in-plane distances many tens of microns and find the
transition shifts to lower temperatures scale approximately as the inverse
square of the in- plane N-structure separation distance, without appreciable
broadening of the transition width. We also present evidence for nonequilbrium
superconductivity and estimate a quasiparticle lifetime of 1.8 \times 10-10 s
for the bilayer. The LoPE model is also used to explain the increased
conductivity at temperatures above the bilayer's steep resistive transition.Comment: 10 pages, 8 figure
Particle Detection by Evaporation from Superfluid Helium
We report the first experiments in which 5-MeV alpha particles are detected via evaporation from a bath of superfluid helium. The α excites phonons and rotons in the liquid helium, and these excitations are sufficiently energetic to evaporate helium atoms when they reach the free surface of the liquid. The approximate overall efficiency of this process has been determined, and we compare this with expectations. We have also been able to detect evaporation induced by a flux of γ’s from a 137Cs source
Longitudinal Proximity Effects in Superconducting Transition-Edge Sensors
We have found experimentally that the critical current of a square superconducting transition-edge sensor (TES) depends exponentially upon the side length L and the square root of the temperature T. As a consequence, the effective transition temperature T(sub c) of the TES is current-dependent and at fixed current scales as 1/L(sup 2). We also have found that the critical current can show clear Fraunhofer-like oscillations in an applied magnetic field, similar to those found in Josephson junctions. The observed behavior has a natural theoretical explanation in terms of longitudinal proximity effects if the TES is regarded as a weak link between superconducting leads. We have observed the proximity effect in these devices over extraordinarily long lengths exceeding 100 microns
Removal of superfluid helium films from surfaces below 0.1 K
We have constructed an apparatus that is able to maintain a helium‐free surface at low temperature (T≤0.1 K) in a cell containing superfluid helium. We discuss the considerations involved in the design of this device, and describe tests that we have made to confirm that a film‐free surface has been produced
Future Development Trajectories for Imaging X-rays Spectrometers Based on Microcalorimeters
Future development trajectories for imaging x-ray spectrometers based on microcalorimeters. Since their invention 30 years ago, the capability of X-ray microcalorimeters has increased steadily, with continual improvements in energy resolution, speed, and array size. Arrays of up to 1024 pixels have been produced, and resolution better than 1 eV at 1.5 keV has been achieved. These detectors can be optimized for the highest priority science, such as designing for the highest resolving power at low energies at the expense of dynamic range, or the greatest focal-plane coverage at the expense of speed. Three types of X-ray microcalorimeters presently dominate the field, each characterized by the thermometer technology. The first two types use temperature-sensitive resistors: semiconductors in the metal-insulator transition and superconductors operated in the superconducting-normal transition. The third type uses a magnetically coupled thermometer, and is at an earlier stage of development than the other two. The Soft X-ray Spectrometer (SXS) on Astro-H, expected to launch in 2015, will use an array of silicon thermistors with HgTe X-ray absorbers that will operate at 50 mK. Both the semiconductor and superconductor calorimeters have been implemented in small arrays. Kilopixel arrays of the superconducting calorimeters are being produced, and much larger arrays may require the non-dissipative advantage of magnetically coupled thermometers. I will project the development trajectories of these detectors and their read-out technologies and assess what their capabilities and limitations will be 10 - 20 years from now
- …