7,570 research outputs found
Laminar boundary-layer heat transfer from a partially-ionized monatomic gas by the similarity approach
Laminar boundary layer heat transfer from ionized monatomic gas to wind tunnel wal
Prediction of heat transfer from laminar boundary layers, with emphasis on large free- stream velocity gradients and highly cooled walls
Prediction of heat transfer and shear stress from laminar boundary laye
Convective heat transfer in a convergent- divergent nozzle
Turbulent flow convective heat transfer in convergent-divergent nozzle
Equine digital tendons show breed‐specific differences in their mechanical properties that may relate to athletic ability and predisposition to injury
Background Throughout the ages, human subjects have selected horse breeds for their locomotor capacities. Concurrently, tissue properties may have diversified because of specific requirements of different disciplines. Objectives The aim of this study was to compare the biomechanical properties of tendons with different functions between equine breeds traditionally selected for racing or sport. Study design This study used ex vivo tendons and compared the mechanical properties of the common digital extensor tendon (CDET) and superficial digital flexor tendon (SDFT) between racehorses (Thoroughbred [TB]) and sports horses (Friesian Horse [FH], Warmblood [WB]). Methods The SDFT and CDET of FH (n = 12), WBs (n = 12) and TBs (n = 8) aged 3-12 years were harvested. The cross sectional area (cm(2)), maximal load (N), ultimate strain (%), ultimate stress (MPa) and elastic modulus (MPa) were determined and tested for significant differences between the breeds (P<0.05). Results The SDFT from WB horses had a significantly lower elastic modulus than TB horses and failed at a higher strain and load than both FHs and TBs. The mechanical properties of the CDET did not differ between breeds. In agreement with previous studies, the CDET failed at a higher stress and had a higher elastic modulus than the SDFT and, for the WB group of horses only, failed at a significantly lower strain. Interestingly, the mode of failure differed between breeds, particularly with respect to the FHs. Main limitations The exercise history of horses used in this study was unknown and the age-range was relatively large; both these factors may have influenced the absolute properties reported in this study. Conclusions This study shows for the first time that mechanical properties of the SDFT differ between breeds. These properties are likely to be related to selection for high-speed vs. an extravagant elastic gait and may be an important indicator of performance ability. The is available in Spanish - see Supporting Informatio
Explosive propulsion applications
The feasibility and application of an explosive propulsion concept capable of supporting future unmanned missions in the post-1980 era were examined and recommendations made for advanced technology development tasks. The Venus large lander mission was selected as the first in which the explosive propulsion concept can find application. A conceptual design was generated and its performance, weight, costs, and interaction effects determined. Comparisons were made with conventional propulsion alternatives. The feasibility of the explosive propulsion system was verified for planetology experiments within the dense atmosphere of Venus as well as the outer planets. Additionally, it was determined that the Venus large lander mission could be augmented ballistically with a significant delivery margin
Fundamental study of flow field generated by rotorcraft blades using wide-field shadowgraph
The vortex trajectory and vortex wake generated by helicopter rotors are visualized using a wide-field shadowgraph technique. Use of a retro-reflective Scotchlite screen makes it possible to investigate the flow field generated by full-scale rotors. Tip vortex trajectories are visible in shadowgraphs for a range of tip Mach number of 0.38 to 0.60. The effect of the angle of attack is substantial. At an angle of attack greater than 8 degrees, the visibility of the vortex core is significant even at relatively low tip Mach numbers. The theoretical analysis of the sensitivity is carried out for a rotating blade. This analysis demonstrates that the sensitivity decreases with increasing dimensionless core radius and increases with increasing tip Mach number. The threshold value of the sensitivity is found to be 0.0015, below which the vortex core is not visible and above which it is visible. The effect of the optical path length is also discussed. Based on this investigation, it is concluded that the application of this wide-field shadowgraph technique to a large wind tunnel test should be feasible. In addition, two simultaneous shadowgraph views would allow three-dimensional reconstruction of vortex trajectories
An Experimental Investigation of Fluid Flow and Heating in Various Resonance Tube Modes
Experiments have been performed to study resonance phenomena in tubes excited by underexpanded jet flows. This investigation comprised the following: Study of the various resonance tube modes under a wide range of nozzle pressure, spacing between nozzle and tube mouth, and different tube length; the effects of these modes on the endwall pressure and gas temperature; flow visualization of both jet and tube flows by spark shadowgraph technique; and measurement of wave speed inside the tube by the laser-schlieren techniques. An extensive study of the free-jet flow was undertaken to explain important aspects of various modes of operation of resonance tube flows
Kaon and production vs Participants in Nuclear Collisions
Data on kaon and production in nuclear collisions as a function of
centrality are analysed both at AGS and SPS energy range. We compare the
results of several experiments, looking for common trend in `participant
scaling' of production yields. We find a smooth description of scaled kaon and
yields as a function of participant density. We also show a participant
density dependence of kaons and produced in the forward hemisphere for
proton-nucleus collisions.Comment: Proceedings of the International Conference on Strangeness in Quark
Matter, 20-25 July 2000, Berkeley, CA. To appear in Journal of Physics G:
Nuclear and Particle Physic
Investigation of spray dispersion and particulate formation in diesel fuel flames
An experimental study of electrostatical atomized and dispersed diesel fuel jets was conducted at various back pressures to 40 atm. A new electrostatic injection technique was utilized to generate continuous, stable fuel sprays at charge densities of 1.5 to 2.0 C/m3 of fluid at one atm, and about 1.0 C/m3 at 40 atm. Flowrates were varied from 0.5 to 2.5 ml/s and electric potentials to -18 kV. Visual observations showed that significant enhanced dispersion of charged fuel jets occurred at high back pressures compared to aerodynamic breakup and dispersion. The average drop size was about the same as the spray triode orifice diameter, and was between the Kelly theory and the Rayleigh limit. The ignition tests, done only at one atm, indicated stable combustion of the electrostatically dispersed fuel jets
- …