8,892 research outputs found
Low-speed longitudinal orbiter qualities
The shuttle program took on the challenge of providing a manual landing capability for an operational vehicle returning from orbit. Some complex challenges were encountered in developing the longitudinal flying qualities required to land the orbiter manually in an operational environment. Approach and landing test flights indicated a tendency for pilot-induced oscillation near landing. Changes in the operational procedures reduced the difficulty of the landing task, and an adaptive stick filter was incorporated to reduce the severity of any pilot-induced oscillatory motions. Fixed-base, movingbase, and in-flight simulations were used for the evaluations, and in general, flight simulation was the only reliable means of assessing the low-speed longitudinal flying qualities problems. Overall, the orbiter control system and operational procedures have produced a good capability to routinely perform precise landings with a large, unpowered vehicle with a low lift-to-drag ratio
Phugoid characteristics of a YF-12 airplane with variable-geometry inlets obtained in flight tests at a Mach number of 2.9
Flight tests were conducted with the YF-12 airplane to examine the airplane's longitudinal characteristics at a Mach number of approximately 2.9. Phugoid oscillations as well as short period pulses were analyzed with the variable geometry engine inlets in the fixed and the automatic configurations. Stability and control derivatives for the velocity and altitude degrees of freedom and the standard short period derivatives were obtained. Inlet bypass door position was successfully used to represent the total inlet system, and the effect of the inlets on the velocity and altitude derivatives was determined. The phugoid mode of the basic airplane (fixed inlet configuration) had neutral damping, and the height mode was stable. With the addition of the inlets in the automatic configuration, the phugoid mode was slightly divergent and the height mode was divergent with a time to double amplitude of about 114 seconds. The results of the derivative estimation indicated that the change in the height mode characteristics was primarily the result of the change in the longitudinal force derivative with respect to velocity
Active Control Technology Experience with the Space Shuttle in the Landing Regime
The shuttle program took on the challenge of providing a manual landing capability for an operational vehicle returning from orbit. Some complex challenges were encountered in developing the longitudinal flying qualities required to land the orbiter manually in an operational environmental. Approach and landing test flights indicated a tendency for pilot-induced oscillation near landing. Changes in the operational procedures reduced the difficulty of the landing task, and an adaptive stick filter was incorporated to reduce the severity of any pilot-induced oscillatory motions. Fixed-base, moving-base, and in-flight simulations were used for the evaluations, and in general, flight simulation was the only reliable means of assessing the low-speed longitudinal flying qualities problems. Overall, the orbiter control system and operational procedures have produced a good capability for routinely performing precise landings in a large, unpowered vehicle with a low lift-to-drag ratio
Space shuttle pilot-induced-oscillation research testing
The simulation requirements for investigation of pilot-induced-oscillation (PIO) characteristics during the landing phase are discussed. Orbiters simulations and F-8 digital fly-by-wire aircraft tests are addressed
Application of frequency domain handling qualities criteria to the longitudinal landing task
Under NASA sponsorship, an in-flight simulation of the longitudinal handling qualities of several configurations for the approach and landing tasks was performed on the USAF/AFWAL Total In-Flight Simulator by the Calspan Corporation. The basic configuration was a generic transport airplane with static instability. The control laws included proportional plus integral gain loops to produce pitch-rate and angle-of-attack feedback loops. The evaluation task was a conventional visual approach to a flared touchdown at a designated spot on the runway with a lateral offset. The general conclusions were that the existing criteria are based on pitch-attitude response and that these characteristics do not adequately discriminate between the good and bad configurations of this study. This paper describes the work that has been done to further develop frequency-based criteria in an effort to provide better correlation with the observed data
Feasibility study of LITVC for shuttle SRB
A liquid injection thrust vector control (LITVC) system for the shuttle solid rocket booster (SRB) was analyzed. The LITVC was compared with the SRB baseline flexible seal. A table of LITVC advantages and disadvantages is presented. It is concluded that the LITVC performs well at low to moderate duty cycles, but not for high duty cycle requirements
Simulation studies of alternate longitudinal control systems for the space shuttle orbiter in the landing regime
Simulations of the space shuttle orbiter in the landing task were conducted by the NASA Ames-Dryden Flight Research Facility using the Ames Research Center vertical motion simulator (VMS) and the total in-flight simulator (TIFS) variable-stability aircraft. Several new control systems designed to improve the orbiter longitudinal response characteristics were investigated. These systems improved the flightpath response by increasing the amount of pitch-rate overshoot. Reduction in the overall time delay was also investigated. During these evaluations, different preferences were noted for the baseline or the new systems depending on the pilot background. The trained astronauts were quite proficient with the baseline system and found the new systems to be less desirable than the baseline. On the other hand, the pilots without extensive flight training with the orbiter had a strong preference for the new systems. This paper presents the results of the VMS and TIFS simulations. A hypothesis is presented regarding the control strategies of the two pilot groups and how this influenced their control systems preferences. Interpretations of these control strategies are made in terms of open-loop aircraft response characteristics as well as pilot-vehicle closed-loop characteristics
Recommended from our members
The climate change double whammy: Flood damage and the determinants of flood insurance coverage, the case of post-Katrina New Orleans
This paper advances scholarly debate on the contradictions of environmental risk management measures by analyzing the determinants of flood insurance coverage among a sample of 403 residents in New Orleans, a city undergoing rapid transformation due to post-Katrina rebuilding efforts and anthropogenic modifications of climate, hydrology, and ecology. The paper focuses on several predictors including subjective flood risk perception, trust in government officials, sociodemographic characteristics, and experience with flood damage. Using binary logistic regression, the results show that the likelihood of having flood insurance coverage is associated with past flood damage and socioeconomic status. Older people (over age 65) are more likely to have flood insurance than younger residents. Race, gender, trust, and perceived flood risk are not statistically significant predictors of flood insurance. We connect our findings to the paradoxes and conflictual dynamics of flood insurance, a major risk mitigation measure. As we point out, in flood-prone cities like New Orleans, flood insurance operates as a double whammy: uninsured or underinsured homes face pervasive risk of both flooding and rising insurance premiums under the conditions of global climate change
Optimization of payload mass placement in a dual keel space station
In order to keep a Space Station in a stable low-Earth orbit, angular momentum storage and translational attitude control systems will have to be used. In order to minimize the size of these attitude control systems, the induced gravity gradient torque effects will have to be minimized. This can be done by minimizing the cross-products of inertia of the Station through the management of payload placement with the Station geometry. A derived and automated methodology is presented which utilizes mathematical nonlinear programming techniques. An optimal arrangement of a set of five payloads on a Dual Keel Space Station was found that minimized the cross products of inertia and thus the required controllability resources
Rhythm and rhyme at arithmetic time (A compilation of poems, finger plays, games, songs and stories that may be used in teaching arithmetic in primary grades)
Thesis (Ed.M.)--Boston Universit
- …