Yellow fever in Asia - a risk analysis

Background There is concern about the risk of yellow fever (YF) establishment in Asia, owing to rising numbers of urban outbreaks in endemic countries and globalisation. Following an outbreak in Angola in 2016, YF cases were introduced into China. Prior to this, YF had never been recorded in Asia, despite climatic suitability and the presence of mosquitoes. An outbreak in Asia could result in widespread fatalities and huge economic impact. Therefore, quantifying the potential risk of YF outbreaks in Asia is a public health priority. Methods Using international flight data and YF incidence estimates from 2016, we quantified the risk of YF introduction via air travel into Asia. In locations with evidence of a competent mosquito population, the potential for autochthonous YF transmission was estimated using a temperature-dependent model of the reproduction number and a branching process model assuming a negative binomial distribution. Results In total, 25 cities across Asia were estimated to be at risk of receiving at least one YF viraemic traveller during 2016. At their average temperatures, we estimated the probability of autochthonous transmission to be <50% in all cities, which was primarily due to the limited number of estimated introductions that year. Conclusion Despite the rise in air travel, we found low support for travel patterns between YF endemic countries and Asia resulting in autochthonous transmission during 2016. This supports the historic absence of YF in Asia and suggests it could be due to a limited number of introductions in previous years. Future increases in travel volumes or YF incidence can increase the number of introductions and the risk of autochthonous transmission. Given the high proportion of asymptomatic or mild infections and the challenges of YF surveillance, our model can be used to estimate the introduction and outbreak risk and can provide useful information to surveillance systems

Monitoring of underground coal fires using thermal infrared data

The potential utility of thermal infrared and short wavelength infrared data for detecting and mapping sub-surface high temperature sources is analysed. In this study, NOAA-9 AVHRR data and Landsat-5 TM data were used to detect and map sub-surface coal fires. Brightness temperature depicted by AVHRR band 3 illustrated high thermal anomalies in the suspected area. Due to the relatively low spatial resolution of the AVHRR data, only TM data is used in detailed analysis. The short wavelength infrared sensors (bands 5 and 7) have been used to locate the positions of the most intense burning. The thermal band (band 6) has been useful in distinguishing gross thermal anomalies from the background of solar warming, The resultant surface temperature anomalies are compared to surface temperatures derived from thermal infrared aerial survey and ground measurements. Correlation of these data indicate that the relatively coarse resolution of the thermal TM data enabled the detection, delineation and quantifying of sub-surface coal fire zones. However, the capability of the short wavelength infrared bands to locate the position of the fire fronts is only preliminary. The research shows that the information gathered from the TM data could only be used as a basis for planning the detailed ground geothermal operation. The investigation also reveals the potential capability of the AVHRR band 3 to detect sub-surface high temperature sources such as coal fires

Conductance of a tunnel point-contact of noble metals in the presence of a single defect

In paper [1] (Avotina et al. Phys. Rev. B,74, 085411 (2006)) the effect of Fermi surface anisotropy to the conductance of a tunnel point contact, in the vicinity of which a single point-like defect is situated, has been investigated theoretically. The oscillatory dependence of the conductance on the distance between the contact and the defect has been found for a general Fermi surface geometry. In this paper we apply the method developed in [1] to the calculation of the conductance of noble metal contacts. An original algorithm, which enables the computation of the conductance for any parametrically given Fermi surface, is proposed. On this basis a pattern of the conductance oscillations, which can be observed by the method of scanning tunneling microscopy, is obtained for different orientations of the surface for the noble metals.Comment: 8 pages, 5 figure

Little groups of irreps of O(3), SO(3), and the infinite axial subgroups

Little groups are enumerated for the irreps and their components in any basis of O(3) and SO(3) up to rank 9, and for all irreps of C$_{\infty}$, C$_{\infty h}$, C$_{\infty v}$, D$_{\infty}$ and D$_{\infty h}$. The results are obtained by a new chain criterion, which distinguishes massive (rotationally inequivalent) irrep basis functions and allows for multiple branching paths, and are verified by inspection. These results are relevant to the determination of the symmetry of a material from its linear and nonlinear optical properties and to the choices of order parameters for symmetry breaking in liquid crystals.Comment: 28 pages and 3 figure

Fermi Surface of the Electron-doped Cuprate Superconductor Nd_{2-x}Ce_xCuO_{4} Probed by High-Field Magnetotransport

We report on the study of the Fermi surface of the electron-doped cuprate superconductor Nd$_{2-x}$Ce$_x$CuO$_{4}$ by measuring the interlayer magnetoresistance as a function of the strength and orientation of the applied magnetic field. We performed experiments in both steady and pulsed magnetic fields on high-quality single crystals with Ce concentrations of $x=0.13$ to 0.17. In the overdoped regime of $x > 0.15$ we found both semiclassical angle-dependent magnetoresistance oscillations (AMRO) and Shubnikov-de Haas (SdH) oscillations. The combined AMRO and SdH data clearly show that the appearance of fast SdH oscillations in strongly overdoped samples is caused by magnetic breakdown. This observation provides clear evidence for a reconstructed multiply-connected Fermi surface up to the very end of the overdoped regime at $x\simeq 0.17$. The strength of the superlattice potential responsible for the reconstructed Fermi surface is found to decrease with increasing doping level and likely vanishes at the same carrier concentration as superconductivity, suggesting a close relation between translational symmetry breaking and superconducting pairing. A detailed analysis of the high-resolution SdH data allowed us to determine the effective cyclotron mass and Dingle temperature, as well as to estimate the magnetic breakdown field in the overdoped regime.Comment: 23 pages, 8 figure

Complex magnetic ordering in the oxide selenide Sr2Fe3Se2O3

Sr2Fe3Se2O3 is a localised-moment iron oxide selenide in which two unusual coordinations for Fe2+ ions form two sublattices in a 2:1 ratio. In the paramagnetic region at room temperature the compound adopts the crystal structure first reported for Sr2Co3S2O3, crystallising in space group Pbam with a = 7.8121 Å, b = 10.2375 Å, c = 3.9939 Å and Z = 2. The sublattice occupied by two thirds of the iron ions (Fe2 site) is formed by a network of distorted mer-[FeSe3O3] octahedra linked via shared Se2 edges and O vertices forming layers, which connect to other layers by shared Se vertices. As shown by magnetometry, neutron powder diffraction and Mössbauer spectroscopy measurements, these moments undergo long range magnetic ordering below TN1 = 118 K, initially adopting a magnetic structure with a propagation vector (½–δ, 0, ½) (0 ≤ ≤ 0.1) which is incommensurate with the nuclear structure and described in the Pbam1’(a01/2)000s magnetic superspace group, until at 92 K (TINC) there is a first order lock-in transition to a structure in which these Fe2 moments form a magnetic structure with a propagation vector (½ , 0, ½) which may be modelled using a 2a × b × 2c expansion of the nuclear cell in space group 36.178 Bab21m (BNS notation). Below TN2 = 52 K the remaining third of the Fe2+ moments (Fe1 site) which are in a compressed trans-[FeSe4O2] octahedral environment undergo long range ordering, as is evident from the magnetometry, the Mössbauer spectra and the appearance of new magnetic Bragg peaks in the neutron diffractograms. The ordering of the second set of moments on the Fe1 sites results in a slight re-orientation of the majority moments on the Fe2 sites. The magnetic structure at 1.5 K is described by a 2a × 2b × 2c expansion of the nuclear cell in space group 9.40 Iab (BNS notation)

A Robust Cross-Linking Strategy for Block Copolymer Worms Prepared via Polymerization-Induced Self-Assembly

A poly(glycerol monomethacrylate) (PGMA) chain transfer agent is chain-extended by reversible addition-fragmentation chain transfer (RAFT) statistical copolymerization of 2-hydroxypropyl methacrylate (HPMA) with glycidyl methacrylate (GlyMA) in concentrated aqueous solution via polymerization-induced self-assembly (PISA). A series of five free-standing worm gels is prepared by fixing the overall degree of polymerization of the core-forming block at 144 while varying its GlyMA content from 0 to 20 mol %. 1H NMR kinetics indicated that GlyMA is consumed much faster than HPMA, producing a GlyMA-rich sequence close to the PGMA stabilizer block. Temperature-dependent oscillatory rheological studies indicate that increasing the GlyMA content leads to progressively less thermoresponsive worm gels, with no degelation on cooling being observed for worms containing 20 mol % GlyMA. The epoxy groups in the GlyMA residues can be ring-opened using 3-aminopropyltriethoxysilane (APTES) in order to prepare core cross-linked worms via hydrolysis-condensation with the siloxane groups and/or hydroxyl groups on the HPMA residues. Perhaps surprisingly, 1H NMR analysis indicates that the epoxy-amine reaction and the intermolecular cross-linking occur on similar time scales. Cross-linking leads to stiffer worm gels that do not undergo degelation upon cooling. Dynamic light scattering studies and TEM analyses conducted on linear worms exposed to either methanol (a good solvent for both blocks) or anionic surfactant result in immediate worm dissociation. In contrast, cross-linked worms remain intact under such conditions, provided that the worm cores comprise at least 10 mol % GlyMA

Order parameter symmetry in ferromagnetic superconductors

We analyze the symmetry and the nodal structure of the superconducting order parameter in a cubic ferromagnet, such as ZrZn$_2$. We demonstrate how the order parameter symmetry evolves when the electromagnetic interaction of the conduction electrons with the internal magnetic induction and the spin-orbit coupling are taken into account. These interactions break the cubic symmetry and lift the degeneracy of the order parameter. It is shown that the order parameter which appears immediately below the critical temperature has two components, and its symmetry is described by {\em co-representations} of the magnetic point groups. This allows us to make predictions about the location of the gap nodes.Comment: 12 pages, ReVTeX, submitted to PR