Control of the responsivity and the detectivity of superconductive edge-transition YBa2Cu3O7-x bolometers through substrate properties

Cataloged from PDF version of article.The detectivity D* limits of YBa2Cu3O7-x bolometer on 0.05-cm-thick crystalline substrates are investigated, and a method to increase D* to greater than 10(9) (cm Hz(1/2))/W at a 20-mu m wavelength is proposed. Because the response increases proportionally with the bias current I-b, whereas the noise near T-c (the transition or critical temperature) of our MgO and SrTiO3 substrate samples does not, an increase in D* of these samples is obtained by an increase in I-b. Another limiting factor is the de thermal conductance G(0) of the device, which, although controlled by the substrate-holder thermal boundary resistance for our samples, can be changed by means of thinning the substrate to increase D*. The optimal amount of thinning depends on the substrate's thermal parameters and the radiation modulation frequency. D* in our samples is also found to follow the spectral-radiation absorption of the substrate material. (C) 1999 Optical Society of America

Relaxation Dynamics of Photoinduced Changes in the Superfluid Weight of High-Tc Superconductors

In the transient state of d-wave superconductors, we investigate the temporal variation of photoinduced changes in the superfluid weight. We derive the formula that relates the nonlinear response function to the nonequilibrium distribution function. The latter qunatity is obtained by solving the kinetic equation with the electron-electron and the electron-phonon interaction included. By numerical calculations, a nonexponential decay is found at low temperatures in contrast to the usual exponential decay at high temperatures. The nonexponential decay originates from the nonmonotonous temporal variation of the nonequilibrium distribution function at low energies. The main physical process that causes this behavior is not the recombination of quasiparticles as previous phenomenological studies suggested, but the absorption of phonons.Comment: 18 pages, 12 figures; to be published in J. Phys. Soc. Jpn. Vol. 80, No.

Non-equilibrium Superconductivity and Quasiparticle Dynamics studied by Photo Induced Activation of Mm-Wave Absorption (PIAMA)

We present a study of non-equilibrium superconductivity in DyBa2Cu3O7-d using photo induced activation of mm-wave absorption (PIAMA). We monitor the time evolution of the thin film transmissivity at 5 cm-1 subject to pulsed infrared radiation. In addition to a positive bolometric signal we observe a second, faster, decay with a sign opposite to the bolometric signal for T>40 K. We attribute this to the unusual properties of quasi-particles residing near the nodes of an unconventional superconductor, resulting in a strong enhancement of the recombination time.Comment: 4 pages, REVTeX, Submitted to Phys. Rev. Letter

A superconducting-nanowire 3-terminal electronic device

In existing superconducting electronic systems, Josephson junctions play a central role in processing and transmitting small-amplitude electrical signals. However, Josephson-junction-based devices have a number of limitations including: (1) sensitivity to magnetic fields, (2) limited gain, (3) inability to drive large impedances, and (4) difficulty in controlling the junction critical current (which depends sensitively on sub-Angstrom-scale thickness variation of the tunneling barrier). Here we present a nanowire-based superconducting electronic device, which we call the nanocryotron (nTron), that does not rely on Josephson junctions and can be patterned from a single thin film of superconducting material with conventional electron-beam lithography. The nTron is a 3-terminal, T-shaped planar device with a gain of ~20 that is capable of driving impedances of more than 100 k{\Omega}, and operates in typical ambient magnetic fields at temperatures of 4.2K. The device uses a localized, Joule-heated hotspot formed in the gate to modulate current flow in a perpendicular superconducting channel. We have characterized the nTron, matched it to a theoretical framework, and applied it both as a digital logic element in a half-adder circuit, and as a digital amplifier for superconducting nanowire single-photon detectors pulses. The nTron has immediate applications in classical and quantum communications, photon sensing and astronomy, and its performance characteristics make it compatible with existing superconducting technologies. Furthermore, because the hotspot effect occurs in all known superconductors, we expect the design to be extensible to other materials, providing a path to digital logic, switching, and amplification in high-temperature superconductors

Calculation of magnetic anisotropy energy in SmCo5

SmCo5 is an important hard magnetic material, due to its large magnetic anisotropy energy (MAE). We have studied the magnetic properties of SmCo5 using density functional theory (DFT) calculations where the Sm f-bands, which are difficult to include in DFT calculations, have been treated within the LDA+U formalism. The large MAE comes mostly from the Sm f-shell anisotropy, stemming from an interplay between the crystal field and the spin-orbit coupling. We found that both are of similar strengths, unlike some other Sm compounds, leading to a partial quenching of the orbital moment (f-states cannot be described as either pure lattice harmonics or pure complex harmonics), an optimal situation for enhanced MAE. A smaller portion of the MAE can be associated with the Co-d band anisotropy, related to the peak in the density of states at the Fermi energy. Our result for the MAE of SmCo5, 21.6 meV/f.u., agrees reasonably with the experimental value of 13-16 meV/f.u., and the calculated magnetic moment (including the orbital component) of 9.4 mu_B agrees with the experimental value of 8.9 mu_B.Comment: Submitted to Phys. Rev.

Vortex avalanches and magnetic flux fragmentation in superconductors

We report results of numerical simulations of non isothermal dendritic flux penetration in type-II superconductors. We propose a generic mechanism of dynamic branching of a propagating hotspot of a flux flow/normal state triggered by a local heat pulse. The branching occurs when the flux hotspot reflects from inhomogeneities or the boundary on which magnetization currents either vanish, or change direction. Then the hotspot undergoes a cascade of successive splittings, giving rise to a dissipative dendritic-type flux structure. This dynamic state eventually cools down, turning into a frozen multi-filamentary pattern of magnetization currents.Comment: 4 pages, 4 figures, accepted to Phys. Rev. Let

Role of deep levels and interface states in the capacitance characteristics of all‐sputtered CuInSe2/CdS solar cell heterojunctions

All‐sputtered CuInSe2/CdS solar cellheterojunctions have been analyzed by means of capacitance‐frequency (C‐F) and capacitance‐bias voltage (C‐V) measurements. Depending on the CuInSe2 layer composition, two kinds of heterojunctions were analyzed: type 1 heterojunctions (based on stoichiometric or slightly In‐rich CuInSe2 layers) and type 2 heterojunctions (based on Cu‐rich CuInSe2 layers). In type 1 heterojunctions, a 80‐meV donor level has been found. Densities of interface states in the range 101 0–101 1 cm2 eV− 1 (type 1) and in the range 101 2–101 3 cm− 2 eV− 1 (type 2) have been deduced. On the other hand, doping concentrations of 1.6×101 6 cm− 3 for stoichiometric CuInSe2 (type 1 heterojunction) and 8×101 7 cm− 3 for the CdS (type 2 heterojunction) have been deduced from C‐Vmeasurements

Analytic modeling of patterned high-Tc superconductive bolometers: Film and substrate interface effects

Superconducting film and substrate interface effects on the response of superconductive edge-transition bolometers are modeled with a one dimensional thermal model in closed form, for samples with large area patterns compared to the substrate thickness. The results from the model agree with experimental results on samples made of meander line patterned granular YBCO films on crystalline substrates, in both the magnitude and phase of the response versus modulation frequency up to about 100 KHz, the limit of the characterization setup. Using the fit of the calculated frequency response curves obtained from the model to the measured ones, values of the film-substrate and substrate-holder thermal boundary resistance, heat capacity of the superconducting film, and the thermal parameters of the substrate materials could be investigated. While the calculated magnitude and phase of the response of the SrTiO3 substrate samples obtained from the model is in a very good agreement with the measured values, the calculated response of the LaAlO3 and MgO substrate samples deviate slightly from the measured values at very low frequencies, increasing with an increase in the thermal conductivity of the substrate material. Using the fit of the calculated response to the measured values, film-substrate thermal boundary resistances in the range of 4.4* 10-3 to 4.4* 10-2 K-cm2-w-1 are obtained for different substrate materials. The effect of substrate optical absorption in the response of the samples is also investigated

The role of hybrid ubiquitin chains in the MyD88 and other innate immune signalling pathways

The adaptor protein MyD88 is required for signal transmission by Toll-like Receptors (TLRs) and receptors of the interleukin 1 (IL-1) family of cytokines. MyD88 signalling triggers the formation of Lys63-linked and Met1-linked ubiquitin (K63-Ub, M1-Ub) chains within minutes. The K63-Ub chains, which are formed by the E3 ubiquitin ligases TRAF6, Pellino1 and Pellino2, activate TAK1, the master kinase that switches on mitogen-activated protein (MAP) kinase cascades and initiates activation of the canonical IκB kinase (IKK) complex. The M1-Ub chains, which are formed by the Linear Ubiquitin chain Assembly Complex (LUBAC), bind to the NEMO component of the IKK complex and are required for TAK1 to activate IKKs, but not MAP kinases. An essential E3 ligase-independent role of TRAF6 is to recruit LUBAC into the MyD88 signalling complex, where it recognises preformed K63-Ub chains attached to protein components of these complexes, such as IRAK1, producing ubiquitin chains containing both types of linkage, termed K63/M1-Ub hybrids. The formation of K63/M1-Ub hybrids, which is a feature of several innate immune signalling pathways, permits the co-recruitment of proteins that interact with either K63-Ub or M1-Ub chains. Two likely roles for K63/M1- Ub hybrids are to facilitate the TAK1-dependent activation of the IKK complex and to prevent the hyper-activation of these kinases by recruiting A20 and A20-binding inhibitor of NF-κB1 (ABIN1). These proteins restrict activation of the TAK1 and IKK complexes, probably by competing with them for binding to K63/M1-Ub hybrids. The formation of K63/M1-Ub hybrids may also regulate the rate at which the ubiquitin linkages in these chains are hydrolysed. The IKK-catalysed phosphorylation of some of its substrates permits their recognition by the E3 ligase SCFβ TRCP, leading to their Lys48-linked ubiquitylation and proteasomal degradation. Innate immune signalling is therefore controlled by the formation and destruction of three different types of ubiquitin linkage

Protein disulphide isomerase-assisted functionalization of proteinaceous substrates

Protein disulphide isomerase (PDI) is an enzyme that catalyzes thiol-disulphide exchange reactions among a broad spectrum of substrates, including proteins and low-molecular thiols and disulphides. As the first protein-folding catalyst reported, the study of PDI has mainly involved the correct folding of several cysteine-containing proteins. Its application on the functionalization of protein-based materials has not been extensively reported. Herein, we review the applications of PDI on the modification of proteinaceous substrates and discuss its future potential. The mechanism involved in PDI functionalization of fibrous protein substrates is discussed in detail. These approaches allow innovative applications in textile dyeing and finishing, medical textiles, controlled drug delivery systems and hair or skin care products.We thank to FCT 'Fundacao para a Ciencia e Tecnologia' (scholarship SFRH/BD/38363/2007) for providing Margarida Fernandes the grant for PhD studies