Influencia del Porcentaje de SiCp en el Comportamiento a la Corrosión de la Aleación AA6061 Obtenida por Compactación Isostática

Se ha estudiado el comportamiento a la corrosión de materiales compuestos A6061/SiCp obtenidos por compactación isostática y extrusión en caliente de polvos mediante ensayos de polarización cíclica. El estudio de la naturaleza de los productos de corrosión se ha llevado a cabo mediante Microscopía Electrónica de Barrido (SEM) después de la realización de los ensayos, con objeto de estudiar la influencia de la proporción de refuerzo en el comportamiento a la corrosión. El proceso de corrosión está significativamente influenciado por la adición de partículas reforzantes, debido a que las intercaras matriz/SiCp son centros preferentes de ataque localizado por picadura

Electrochemical Estimation of the Corrosion Rate of Magnesium/Aluminium Alloys

The corrosion rate of AZ31, AZ80, and AZ91D magnesium/aluminium alloys immersed in 3.5 wt.% NaCl was determined comparing gravimetric and electrochemical measurements. The findings revealed that, for all investigated materials, a fraction of the metallic surface exposed to the corrosive medium did not reveal a normal electrochemical response to the applied signal. This may be associated with phenomena such as partial disintegration of specimens into fine metallic particles, electrochemical formation of ions, and/or anomalous chemical attack occurring simultaneously with the normal electrochemical corrosion attack. The abnormal electrochemical behaviour was more evident for lower amounts of aluminium in the bulk composition of the investigated materials. Thus, the electrochemical estimates of pure Mg and the AZ31 alloy were not reliable and tended to underestimate corrosion losses.Peer Reviewe

Correlation between the surface chemistry and the atmospheric corrosion of AZ31, AZ80 and AZ91D magnesium alloys

X-ray photoelectron spectroscopy (XPS) was used in order to investigate the correlation between the surface chemistry and the atmospheric corrosion of AZ31, AZ80 and AZ91D magnesium alloys exposed to 98% relative humidity at 50 °C. Commercially pure magnesium, used as the reference material, revealed MgO, Mg(OH)2 and tracers of magnesium carbonate in the air-formed film. For the AZ80 and AZ91D alloys, the amount of magnesium carbonate formed on the surface reached similar values to those of MgO and Mg(OH)2. A linear relation between the amount of magnesium carbonate formed on the surface and the subsequent corrosion behaviour in the humid environment was found. The AZ80 alloy revealed the highest amount of magnesium carbonate in the air-formed film and the highest atmospheric corrosion resistance, even higher than the AZ91D alloy, indicating that aluminium distribution in the alloy microstructure influenced the amount of magnesium carbonate formedThanks to the MCYT for the financial support given to this work (Project MAT2006-13179-C02-01-02)Peer reviewe

A Generic Architecture for Emotion-based Recommender Systems in Cloud Learning Environments

Cloud technology has provided a set of tools to learners and tutors to create a virtual personal learning environment. As these tools only support basic tasks, users of learning environments are looking for specialized tools to exploit the uncountable learning elements available on the internet. Thus, one of the most common functionalities in cloud-based learning environments is the recommendation of learning elements and several approaches have been proposed to deploy recommender systems into an educational environment. Currently, there is an increasing interest in including affective information into the process to generate the recommendations for the learner; and services offering this functionality on cloud environments are scarce. Hence in this paper, we propose a generic cloud-based architecture for a system that recommends learning elements according to the affective state of the learner. Furthermore, we provide the description of some use cases along with the details of the implementation of one of them. We also provide a discussion on the advantages and disadvantages of the proposal.Work partially funded by the EEE project, “Plan Nacional de I+D+I TIN2011-28308-C03-01”, the “Emadrid: Investigación y desarrollo de tecnologías para el e-learning en la Comunidad de Madrid” project 2009/TIC-1650), and “Consejo Social - Universidad Carlos III de Madrid”.Publicad

Biological behavior of familial papillary thyroid microcarcinoma: Spanish multicenter study

Purpose Familial papillary thyroid microcarcinoma (FPTMC) can present a more aggressive behavior than the sporadic microcarcinoma. However, few studies have analyzed this situation. The objective is to analyze the recurrence rate of FPTMC and the prognostic factors which determine that recurrence in Spain. Methods Spanish multicenter longitudinal analytical observational study was conducted. Patients with FPTMC received treatment with curative intent and presented cure criteria 6 months after treatment. Recurrence rate and disease-free survival (DFS) were analyzed. Two groups were analyzed: group A (no tumor recurrence) vs. group B (tumor recurrence). Results Ninety-four patients were analyzed. During a mean follow-up of 73.3 +/- 59.3 months, 13 recurrences of FPTMC (13.83%) were detected and mean DFS was 207.9 +/- 11.5 months. There were multifocality in 56%, bilateral thyroid involvement in 30%, and vascular invasion in 7.5%; that is to say, they are tumors with histological factors of poor prognosis in a high percentage of cases. The main risk factors for recurrence obtained in the multivariate analysis were the tumor size (OR: 2.574, 95% CI 1.210-5.473; p = 0.014) and the assessment of the risk of recurrence of the American Thyroid Association (ATA), both intermediate risk versus low risk (OR: 125, 95% CI 10.638-1000; p < 0.001) and high risk versus low risk (OR: 45.454, 95% CI 5.405-333.333; p < 0.001). Conclusion FPTMC has a recurrence rate higher than sporadic cases. Poor prognosis is mainly associated with the tumor size and the risk of recurrence of the ATA

Gradient, UC3M

En este artículo se presenta un resumen de las líneas de investigación que se realizan en el Laboratorio Gradient perteneciente al Grupo GAST (Grupo de Aplicaciones y Servicios Telemáticos) del Departamento de Ingeniería Telemática de la Universidad Carlos III de Madrid. La temática principal de investigación es la aplicación de tecnologías para la mejora de la enseñanza y el aprendizaje. El resumen se centra en tres líneas: Personalización del aprendizaje, uso de dispositivos móviles con fines educativos y aplicaciones de Realidad Virtual y Realidad Aumentada en educación.En este artículo se presenta un resumen de las líneas de investigación que se realizan en el Laboratorio Gradient perteneciente al Grupo GAST (Grupo de Aplicaciones y Servicios Telemáticos) del Departamento de Ingeniería Telemática de la Universidad Carlos III de Madrid. La temática principal de investigación es la aplicación de tecnologías para la mejora de la enseñanza y el aprendizaje. El resumen se centra en tres líneas: Personalización del aprendizaje, uso de dispositivos móviles con fines educativos y aplicaciones de Realidad Virtual y Realidad Aumentada en educación.Publicad

Performance of the CMS Level-1 trigger during commissioning with cosmic ray muons and LHC beams

52 páginas, 25 figuras.-- Open Access.-- CMS Collaboration: et al.The CMS Level-1 trigger was used to select cosmic ray muons and LHC beam events during data-taking runs in 2008, and to estimate the level of detector noise. This paper describes the trigger components used, the algorithms that were executed, and the trigger synchronisation. Using data from extended cosmic ray runs, the muon, electron/photon, and jet triggers have been validated, and their performance evaluated. Efficiencies were found to be high, resolutions were found to be good, and rates as expected.Acknowledge support from: FMSR (Austria); FNRS and FWO (Belgium); CNPq, CAPES, FAPERJ, and FAPESP (Brazil); MES (Bulgaria); CERN; CAS, MoST, and NSFC (China); COLCIENCIAS (Colombia); MSES (Croatia); RPF (Cyprus); Academy of Sciences and NICPB (Estonia); Academy of Finland, ME, and HIP (Finland); CEA and CNRS/IN2P3 (France); BMBF, DFG, and HGF (Germany); GSRT (Greece); OTKA and NKTH (Hungary); DAE and DST (India); IPM (Iran); SFI (Ireland); INFN (Italy); NRF (Korea); LAS (Lithuania); CINVESTAV, CONACYT, SEP, and UASLP-FAI (Mexico); PAEC (Pakistan); SCSR (Poland); FCT (Portugal); JINR (Armenia, Belarus, Georgia, Ukraine, Uzbekistan); MST and MAE (Russia); MSTDS (Serbia); MICINN and CPAN (Spain); Swiss Funding Agencies (Switzerland); NSC (Taipei); TUBITAK and TAEK (Turkey); STFC (United Kingdom); DOE and NSF (USA). Individuals have received support from the Marie-Curie IEF program (European Union); the Leventis Foundation; the A. P. Sloan Foundation; and the Alexander von Humboldt Foundation.Peer reviewe

Fine synchronization of the CMS muon drift-tube local trigger using cosmic rays

33 páginas, 12 figuras.-- Open Access.-- CMS Collaboration: et al.The CMS experiment uses self-triggering arrays of drift tubes in the barrel muon trigger to perform the identification of the correct bunch crossing. The identification is unique only if the trigger chain is correctly synchronized. In this paper, the synchronization performed during an extended cosmic ray run is described and the results are reported. The random arrival time of cosmic ray muons allowed several synchronization aspects to be studied and a simple method for the fine synchronization of the Drift Tube Local Trigger at LHC to be developed.Individuals have received support from the Marie-Curie IEF program (European Union); the Leventis Foundation; the A. P. Sloan Foundation; and the Alexander von Humboldt Foundation.Peer reviewe