331 research outputs found

    Impacts of offshore oil spill accidents on island bird communities: A test run study around Orkney and Svalbard archipelagos

    Get PDF
    The sea area around the Orkney archipelago, Scotland is subjected to substantial maritime shipping activities. By contract, the Svalbard archipelago, Norway currently has a rather low marine traffic profile. Future projections, however, indicate that the Trans-Arctic route might change the whole transportation picture and Svalbard may be at the centre of maritime activities. Both archipelagos have sensitive environmental resources at sea and inland, including bird communities. There are, for instance, 13 Red Listed species present in Orkney and 2 in Svalbard. In this regard, it is important to address oil spill risks along existing and projected shipping routes. Hypothetical spills were simulated in twelve scenarios for both the Orkney and Svalbard archipelagos with the OpenDrift open-source software. The results indicate risks to seabird communities. For Orkney, the spills resulted in the most extensive contamination of the sea and land environments in autumn. For Svalbard, autumn spills on the contrary presented the lowest risk to seabirds. Based on the simulations, we recommend increased caution for shipping activities in the problematic seasons, improved local readiness for ship accidents and sufficient preincident planning

    Yield, Quality and Nitrogen Use of Forage Maize under Different Nitrogen Application Rates in Two Boreal Locations

    Get PDF
    Research focusing on the nitrogen (N) application and N use of forage maize (Zea mays L.) in the boreal region is either limited or non-existent. The aim of this study was to investigate the response of yield, quality and N recovery efficiency (NRE) of forage maize to an increase in the N application rate and different climatic conditions in two locations in Finland. The field experiment was conducted in southern (Helsinki; 60° N) and central (Maaninka; 63° N) Finland in 2019 and 2020. Dry matter (DM) yield, forage quality and NRE were determined for N application rates of 100, 150 and 200 N kg ha−1. The DM yield was similar to all studied N application rates. Moreover, there were no marked differences in the studied forage quality traits or the NRE following the N application rates. However, the NRE of maize was generally low at 45%. The current study recommends a N application rate of 100–150 N kg ha−1 for forage maize in the boreal region. There is no need to increase the N application from current recommendations since climate conditions seem to limit the growth, development and NRE of forage maize. The observed low NRE of forage maize warrants further research in the future

    Yield, Quality and Nitrogen Use of Forage Maize under Different Nitrogen Application Rates in Two Boreal Locations

    Get PDF
    Research focusing on the nitrogen (N) application and N use of forage maize (Zea mays L.) in the boreal region is either limited or non-existent. The aim of this study was to investigate the response of yield, quality and N recovery efficiency (NRE) of forage maize to an increase in the N application rate and different climatic conditions in two locations in Finland. The field experiment was conducted in southern (Helsinki; 60° N) and central (Maaninka; 63° N) Finland in 2019 and 2020. Dry matter (DM) yield, forage quality and NRE were determined for N application rates of 100, 150 and 200 N kg ha−1. The DM yield was similar to all studied N application rates. Moreover, there were no marked differences in the studied forage quality traits or the NRE following the N application rates. However, the NRE of maize was generally low at 45%. The current study recommends a N application rate of 100–150 N kg ha−1 for forage maize in the boreal region. There is no need to increase the N application from current recommendations since climate conditions seem to limit the growth, development and NRE of forage maize. The observed low NRE of forage maize warrants further research in the future

    Sustainability of cellulose dissolution and regeneration in 1,5-diazabicyclo[4.3.0]non-5-enium acetate : a batch simulation of the IONCELL-F process

    Get PDF
    The recyclability of 1,5-diazabicyclo[4.3.0] non-5-enium acetate ([DBNH][OAc]), as a direct dissolution solvent for cellulose, was evaluated during laboratory scale recycling trials. The main objective was to simulate the conditions of a spinning bath from a Lyocell-type air-gap spinning process, called the IONCELL-F process. The saline solution was then concentrated, recycled and reused as many times as possible before cellulose dissolution was no longer possible. The chemical compositions of the ionic liquid and pulp were recorded throughout the experiments. The results of the experiments showed that [DBNH][OAc] can be recycled from aqueous media with an average recovery rate of 95.6 wt% using basic laboratory equipment, without any further process intensification or optimisation. The recycling of the ionic liquid did not change the chemical composition or degree of polymerisation of the recovered pulp but the colour of the regenerated pulps gradually darkened as the recycling times increased. The ionic liquid was found to hydrolyse 6.0-13.6 mol% per cycle, under these conditions. The build-up of the hydrolysis product, 3-( aminopropyl)-2-pyrrolidonium acetate, killed the dissolution feature at between 30.6-45.6 wt% hydrolysis product. The enzymatic digestibility of the regenerated pulp samples was studied with both a monocomponent endoglucanase and a cellulase mixture. The amount of residual [DBNH][OAc] in the regenerated pulps was determined, by both NMR and capillary electrophoresis. Although hydrolysis of the ionic liquid occurs, this study clearly shows potential for industrial application, with appropriate process equipment and recycling conditions.Peer reviewe

    ‘Give courage to the ladies’: expansive apprenticeship for women in rural Malawi

    Get PDF
    Apprenticeship in developed and industrialised nations is increasingly understood as a theory of learning which connects workplace activity and formal study. The concept of ‘expansive apprenticeship’ defines frameworks for workforce development where participants acquire knowledge and skills which will help them in the future as well as in their current roles, whilst ‘restrictive’ apprenticeships limit opportunities for wider, lifelong learning. In developing nations apprenticeship is a traditional route to learning and employment, but apprenticeships in these contexts tend to reflect a restrictive approach characterized by narrowly defined roles and weak educational outcomes. This paper examines a project in Malawi which uses concepts of expansive apprenticeship to address barriers to female continuing education and chronic teacher shortages. The Malawi Access to Teaching Scholarship recruited one thousand women to follow a year-long combined programme of academic distance study and practical work experience in rural primary schools. The aim is to increase the numbers of women teachers in Malawi, especially in rural areas. The Scholarship materials and support structures are designed to move participants from restrictive to expansive contexts for learning so that Scholars develop hybrid roles as students, community workers and apprentice pedagogues. The programme’s resources and approach offer an innovative model of expansive apprenticeship in Sub Saharan Africa

    Improving Photoelectron Counting and Particle Identification in Scintillation Detectors with Bayesian Techniques

    Full text link
    Many current and future dark matter and neutrino detectors are designed to measure scintillation light with a large array of photomultiplier tubes (PMTs). The energy resolution and particle identification capabilities of these detectors depend in part on the ability to accurately identify individual photoelectrons in PMT waveforms despite large variability in pulse amplitudes and pulse pileup. We describe a Bayesian technique that can identify the times of individual photoelectrons in a sampled PMT waveform without deconvolution, even when pileup is present. To demonstrate the technique, we apply it to the general problem of particle identification in single-phase liquid argon dark matter detectors. Using the output of the Bayesian photoelectron counting algorithm described in this paper, we construct several test statistics for rejection of backgrounds for dark matter searches in argon. Compared to simpler methods based on either observed charge or peak finding, the photoelectron counting technique improves both energy resolution and particle identification of low energy events in calibration data from the DEAP-1 detector and simulation of the larger MiniCLEAN dark matter detector.Comment: 16 pages, 16 figure

    Radon backgrounds in the DEAP-1 liquid-argon-based Dark Matter detector

    Full text link
    The DEAP-1 \SI{7}{kg} single phase liquid argon scintillation detector was operated underground at SNOLAB in order to test the techniques and measure the backgrounds inherent to single phase detection, in support of the \mbox{DEAP-3600} Dark Matter detector. Backgrounds in DEAP are controlled through material selection, construction techniques, pulse shape discrimination and event reconstruction. This report details the analysis of background events observed in three iterations of the DEAP-1 detector, and the measures taken to reduce them. The 222^{222}Rn decay rate in the liquid argon was measured to be between 16 and \SI{26}{\micro\becquerel\per\kilogram}. We found that the background spectrum near the region of interest for Dark Matter detection in the DEAP-1 detector can be described considering events from three sources: radon daughters decaying on the surface of the active volume, the expected rate of electromagnetic events misidentified as nuclear recoils due to inefficiencies in the pulse shape discrimination, and leakage of events from outside the fiducial volume due to imperfect position reconstruction. These backgrounds statistically account for all observed events, and they will be strongly reduced in the DEAP-3600 detector due to its higher light yield and simpler geometry

    In-situ characterization of the Hamamatsu R5912-HQE photomultiplier tubes used in the DEAP-3600 experiment

    Get PDF
    The Hamamatsu R5912-HQE photomultiplier-tube (PMT) is a novel high-quantum efficiency PMT. It is currently used in the DEAP-3600 dark matter detector and is of significant interest for future dark matter and neutrino experiments where high signal yields are needed. We report on the methods developed for in-situ characterization and monitoring of DEAP's 255 R5912-HQE PMTs. This includes a detailed discussion of typical measured single-photoelectron charge distributions, correlated noise (afterpulsing), dark noise, double, and late pulsing characteristics. The characterization is performed during the detector commissioning phase using laser light injected through a light diffusing sphere and during normal detector operation using LED light injected through optical fibres

    Measurement of the scintillation time spectra and pulse-shape discrimination of low-energy beta and nuclear recoils in liquid argon with DEAP-1

    Get PDF
    The DEAP-1 low-background liquid argon detector was used to measure scintillation pulse shapes of electron and nuclear recoil events and to demonstrate the feasibility of pulse-shape discrimination (PSD) down to an electron-equivalent energy of 20 keV. In the surface dataset using a triple-coincidence tag we found the fraction of beta events that are misidentified as nuclear recoils to be <1.4×10−7<1.4\times 10^{-7} (90% C.L.) for energies between 43-86 keVee and for a nuclear recoil acceptance of at least 90%, with 4% systematic uncertainty on the absolute energy scale. The discrimination measurement on surface was limited by nuclear recoils induced by cosmic-ray generated neutrons. This was improved by moving the detector to the SNOLAB underground laboratory, where the reduced background rate allowed the same measurement with only a double-coincidence tag. The combined data set contains 1.23×1081.23\times10^8 events. One of those, in the underground data set, is in the nuclear-recoil region of interest. Taking into account the expected background of 0.48 events coming from random pileup, the resulting upper limit on the electronic recoil contamination is <2.7×10−8<2.7\times10^{-8} (90% C.L.) between 44-89 keVee and for a nuclear recoil acceptance of at least 90%, with 6% systematic uncertainty on the absolute energy scale. We developed a general mathematical framework to describe PSD parameter distributions and used it to build an analytical model of the distributions observed in DEAP-1. Using this model, we project a misidentification fraction of approx. 10−1010^{-10} for an electron-equivalent energy threshold of 15 keV for a detector with 8 PE/keVee light yield. This reduction enables a search for spin-independent scattering of WIMPs from 1000 kg of liquid argon with a WIMP-nucleon cross-section sensitivity of 10−4610^{-46} cm2^2, assuming negligible contribution from nuclear recoil backgrounds.Comment: Accepted for publication in Astroparticle Physic

    Pre-Exposure to 50 Hz Magnetic Fields Modifies Menadione-Induced Genotoxic Effects in Human SH-SY5Y Neuroblastoma Cells

    Get PDF
    BACKGROUND: Extremely low frequency (ELF) magnetic fields (MF) are generated by power lines and various electric appliances. They have been classified as possibly carcinogenic by the International Agency for Research on Cancer, but a mechanistic explanation for carcinogenic effects is lacking. A previous study in our laboratory showed that pre-exposure to ELF MF altered cancer-relevant cellular responses (cell cycle arrest, apoptosis) to menadione-induced DNA damage, but it did not include endpoints measuring actual genetic damage. In the present study, we examined whether pre-exposure to ELF MF affects chemically induced DNA damage level, DNA repair rate, or micronucleus frequency in human SH-SY5Y neuroblastoma cells. METHODOLOGY/PRINCIPAL FINDINGS: Exposure to 50 Hz MF was conducted at 100 µT for 24 hours, followed by chemical exposure for 3 hours. The chemicals used for inducing DNA damage and subsequent micronucleus formation were menadione and methyl methanesulphonate (MMS). Pre-treatment with MF enhanced menadione-induced DNA damage, DNA repair rate, and micronucleus formation in human SH-SY5Y neuroblastoma cells. Although the results with MMS indicated similar effects, the differences were not statistically significant. No effects were observed after MF exposure alone. CONCLUSIONS: The results confirm our previous findings showing that pre-exposure to MFs as low as 100 µT alters cellular responses to menadione, and show that increased genotoxicity results from such interaction. The present findings also indicate that complementary data at several chronological points may be critical for understanding the MF effects on DNA damage, repair, and post-repair integrity of the genome
    • …
    corecore