Silicon-germanium BiCMOS device and circuit design for extreme environment applications

Silicon-germanium (SiGe) BiCMOS technology platforms have proven invaluable for implementing a wide variety of digital, RF, and mixed-signal applications in extreme environments such as space, where maintaining high levels of performance in the presence of low temperatures and background radiation is paramount. This work will focus on the investigation of the total-dose radiation tolerance of a third generation complementary SiGe:C BiCMOS technology platform. Tolerance will be quantified under proton and X-ray radiation sources for both the npn and pnp HBT, as well as for an operational amplifier built with these devices. Furthermore, a technique known as junction isolation radiation hardening will be proposed and tested with the goal of improving the SEE sensitivity of the npn in this platform by reducing the charge collected by the subcollector in the event of a direct ion strike. To the author's knowledge, this work presents the first design and measurement results for this form of RHBD.M.S.Committee Chair: Cressler, John; Committee Member: Papapolymerou, John; Committee Member: Ralph, Stephe

Analysis of total dose-induced dark current in CMOS image sensors from interface state and trapped charge density measurements

The origin of total ionizing dose induced dark current in CMOS image sensors is investigated by comparing dark current measurements to interface state density and trapped charge density measurements. Two types of photodiode and several thick-oxide-FETs were manufactured using a 0.18-µm CMOS image sensor process and exposed to 10-keV X-ray from 3 krad to 1 Mrad. It is shown that the radiation induced trapped charge extends the space charge region at the oxide interface, leading to an enhancement of interface state SRH generation current. Isochronal annealing tests show that STI interface states anneal out at temperature lower than 100°C whereas about a third of the trapped charge remains after 30 min at 300°C

A Radiation hard bandgap reference circuit in a standard 0.13um CMOS Technology

With ongoing CMOS evolution, the gate-oxide thickness steadily decreases, resulting in an increased radiation tolerance of MOS transistors. Combined with special layout techniques, this yields circuits with a high inherent robustness against X-rays and other ionizing radiation. In bandgap voltage references, the dominant radiation-susceptibility is then no longer associated with the MOS transistors, but is dominated by the diodes. This paper gives an analysis of radiation effects in both MOSdevices and diodes and presents a solution to realize a radiation-hard voltage reference circuit in a standard CMOS technology. A demonstrator circuit was implemented in a standard 0.13 m CMOS technology. Measurements show correct operation with supply voltages in the range from 1.4 V down to 0.85 V, a reference voltage of 405 mV 7.5 mV ( = 6mVchip-to-chip statistical spread), and a reference voltage shift of only 1.5 mV (around 0.8%) under irradiation up to 44 Mrad (Si)

Correlation between pattern density and linewidth variation in silicon photonics waveguides

We describe the correlation between the measured width of silicon waveguides fabricated with 193 nm lithography and the local pattern density of the mask layout. In the fabrication process, pattern density can affect the composition of the plasma in a dry etching process or the abrasion rate in a planarization step. Using an optical test circuit to extract waveguide width and thickness, we sampled 5841 sites over a fabricated wafer. Using this detailed sampling, we could establish the correlation between the linewidth and average pattern density around the test circuit, as a function of the radius of influence. We find that the intra-die systematic width variation correlates most with the pattern density within a radius of 200 gm, with a correlation coefficient of 0.57. No correlation between pattern density and the intra-die systematic thickness variation is observed. These findings can be used to predict photonic circuit yield or to optimize the circuit layout to minimize the effect of local pattern density. (C) 2020 Optical Society of America under the terms of the OSA Open Access Publishing Agreemen

Overview of ionizing radiation effects in image sensors fabricated in a deep-submicrometer CMOS imaging technology

An overview of ionizing radiation effects in imagers manufactured in a 0.18-μm CMOS image sensor technology is presented. Fourteen types of image sensors are characterized and irradiated by a 60Co source up to 5 kGy. The differences between these 14 designs allow us to separately estimate the effect of ionizing radiation on microlenses, on low- and zero-threshold-voltage MOSFETs and on several pixel layouts using P+ guard-rings and edgeless transistors. After irradiation, wavelength dependent responsivity drops are observed. All the sensors exhibit a large dark current increase attributed to the shallow trench isolation that surrounds the photodiodes. Saturation voltage rises and readout chain gain variations are also reported. Finally, the radiation hardening perspectives resulting from this paper are discussed

Simulation study of scaling design, performance characterization, statistical variability and reliability of decananometer MOSFETs

This thesis describes a comprehensive, simulation based scaling study – including device design, performance characterization, and the impact of statistical variability – on deca-nanometer bulk MOSFETs. After careful calibration of fabrication processes and electrical characteristics for n- and p-MOSFETs with 35 nm physical gate length, 1 nm EOT and stress engineering, the simulated devices closely match the performance of contemporary 45 nm CMOS technologies. Scaling to 25 nm, 18 nm and 13 nm gate length n and p devices follows generalized scaling rules, augmented by physically realistic constraints and the introduction of high-k/metal-gate stacks. The scaled devices attain the performance stipulated by the ITRS. Device a.c. performance is analyzed, at device and circuit level. Extrinsic parasitics become critical to nano-CMOS device performance. The thesis describes device capacitance components, analyzes the CMOS inverter, and obtains new insights into the inverter propagation delay in nano-CMOS. The projection of a.c. performance of scaled devices is obtained. The statistical variability of electrical characteristics, due to intrinsic parameter fluctuation sources, in contemporary and scaled decananometer MOSFETs is systematically investigated for the first time. The statistical variability sources: random discrete dopants, gate line edge roughness and poly-silicon granularity are simulated, in combination, in an ensemble of microscopically different devices. An increasing trend in the standard deviation of the threshold voltage as a function of scaling is observed. The introduction of high-k/metal gates improves electrostatic integrity and slows this trend. Statistical evaluations of variability in Ion and Ioff as a function of scaling are also performed. For the first time, the impact of strain on statistical variability is studied. Gate line edge roughness results in areas of local channel shortening, accompanied by locally increased strain, both effects increasing the local current. Variations are observed in both the drive current, and in the drive current enhancement normally expected from the application of strain. In addition, the effects of shallow trench isolation (STI) on MOSFET performance and on its statistical variability are investigated for the first time. The inverse-narrow-width effect of STI enhances the current density adjacent to it. This leads to a local enhancement of the influence of junction shapes adjacent to the STI. There is also a statistical impact on the threshold voltage due to random STI induced traps at the silicon/oxide interface

Damascene Double Gated Transistors and Related Manufacturing Methods

This invention provides the structure and fabrication process of a completely planar, Damascene double gated transistor. The structure has a novel self-aligned, hyper-abrupt retrograde body and a zero-parasitic, endwall gate-body connection. The structure provides for increased density and enables ultra low power to be utilized. The methods also provide for simultaneously making both four-terminal and dynamic threshold MOSFET devices

Rad Tolerant CMOS Image Sensor Based on Hole Collection 4T Pixel Pinned Photodiode

1.4μm pixel pitch CMOS Image sensors based on hole collection pinned photodiode (HPD) have been irradiated with 60Co source. The HPD sensors exhibit much lower dark current degradation than equivalent commercial sensors using an Electron collection Pinned Photodiode (EPD). This hardness improvement is mainly attributed to carrier accumulation near the interfaces induced by the generated positive charges in dielectrics. The pre-eminence of this image sensor based on hole collection pinned photodiode architectures in ionizing environments is demonstrated