Next generation communications satellites: multiple access and network studies

Efficient resource allocation and network design for satellite systems serving heterogeneous user populations with large numbers of small direct-to-user Earth stations are discussed. Focus is on TDMA systems involving a high degree of frequency reuse by means of satellite-switched multiple beams (SSMB) with varying degrees of onboard processing. Algorithms for the efficient utilization of the satellite resources were developed. The effect of skewed traffic, overlapping beams and batched arrivals in packet-switched SSMB systems, integration of stream and bursty traffic, and optimal circuit scheduling in SSMB systems: performance bounds and computational complexity are discussed

Design of a multicast router for network-on-chip architectures with irregular topologies

As chip complexity keeps increasing in system-on-chip (SoC), the on-chip interconnect has become a critical issue for large-scale chip design.It has been proposed that the packet-switched network exchanging messages between intellectual property (IP) cores is a viable solution for the SoC interconnect problem.The design of the router in such network-on-chip (NoC) architectures is the key to high-performance communication for the IP cores in SoC. In this paper, we present the design and implementation of a multicast router for NoC with irregular topologies.The router employs our previously proposed tree-based routing algorithm for irregular networks.Our experiment results show that the multicast router has a slightly lower clock rate and moderately larger chip area than the unicast router in NoC.Since multicasting is a technique providing superior network performance, especially for large networks, such multicast router design is an effective routing solution for large-scale network-on-chip architectures

Scheduling and reconfiguration of interconnection network switches

Interconnection networks are important parts of modern computing systems, facilitating communication between a system\u27s components. Switches connecting various nodes of an interconnection network serve to move data in the network. The switch\u27s delay and throughput impact the overall performance of the network and thus the system. Scheduling efficient movement of data through a switch and configuring the switch to realize a schedule are the main themes of this research. We consider various interconnection network switches including (i) crossbar-based switches, (ii) circuit-switched tree switches, and (iii) fat-tree switches. For crossbar-based input-queued switches, a recent result established that logarithmic packet delay is possible. However, this result assumes that packet transmission time through the switch is no less than schedule-generation time. We prove that without this assumption (as is the case in practice) packet delay becomes linear. We also report results of simulations that bear out our result for practical switch sizes and indicate that a fast scheduling algorithm reduces not only packet delay but also buffer size. We also propose a fast mesh-of-trees based distributed switch scheduling (maximal-matching based) algorithm that has polylog complexity. A circuit-switched tree (CST) can serve as an interconnect structure for various computing architectures and models such as the self-reconfigurable gate array and the reconfigurable mesh. A CST is a tree structure with source and destination processing elements as leaves and switches as internal nodes. We design several scheduling and configuration algorithms that distributedly partition a given set of communications into non-conflicting subsets and then establish switch settings and paths on the CST corresponding to the communications. A fat-tree is another widely used interconnection structure in many of today\u27s high-performance clusters. We embed a reconfigurable mesh inside a fat-tree switch to generate efficient connections. We present an R-Mesh-based algorithm for a fat-tree switch that creates buses connecting input and output ports corresponding to various communications using that switch

Survey of unified approaches to integrated-service networks

The increasing demand for communication services, coupled with recent technological advances in communication media and switching techniques, has resulted in a proliferation of new and expanded services. Currently, networks are needed which can transmit voice, data, and video services in an application-independent fashion. Unified approaches employ a single switching technique across the entire network bandwidth, thus, allowing services to be switched in an application-independent manner. This paper presents a taxonomy of integrated-service networks including a look at N-ISDN, while focusing on unified approaches to integrated-service networks.The two most promising unified approaches are burst and fast packet switching. Burst switching is a circuit switching-based approach which allocates channel bandwidth to a connection only during the transmission of "bursts" of information. Fast packet switching is a packet switching-based approach which can be characterized by very high transmission rates on network links and simple, hardwired protocols which match the rapid channel speed of the network. Both approaches are being proposed as possible implementations for integrated-service networks. We survey these two approaches, and also examine the key performance issues found in fast packet switching. We then present the results of a simulation study of a fast packet switching network

Packet scheduling under imperfect channel conditions in Long Term Evolution (LTE)

University of Technology, Sydney. Faculty of Engineering and Information Technology.The growing demand for high speed wireless data services, such as Voice Over Internet Protocol (VoIP), web browsing, video streaming and gaming, with constraints on system capacity and delay requirements, poses new challenges in future mobile cellular systems. Orthogonal Frequency Division Multiple Access (OFDMA) is the preferred access technology for downlink Long Term Evolution (LTE) standardisation as a solution to the challenges. As a network based on an all-IP packet switched architecture, LTE employs packet scheduling to satisfy Quality of Service (QoS) requirements. Therefore, efficient design of packet scheduling becomes a fundamental issue. The aim of this thesis is to propose a novel packet scheduling algorithm to improve system performance for practical downlink LTE system. This thesis first focuses on time domain packet scheduling algorithms. A number of time domain packet scheduling algorithms are studied and some well-known time domain packet scheduling algorithms are compared in downlink LTE. A packet scheduling algorithm is identified that it is able to provide a better trade-off between maximizing the system performance and guaranteeing the fairness. Thereafter, some frequency domain packet schemes are introduced and examples of QoS aware packet scheduling algorithms employing these schemes are presented. To balance the scheduling performance and computational complexity and be tolerant to the time-varying wireless channel, a novel scheduling scheme and a packet scheduling algorithm are proposed. Simulation results show this proposed algorithm achieves an overall reasonable system performance. Packet scheduling is further studied in a practical channel condition environment which assumes imperfect Channel Quality Information (CQI). To alleviate the performance degradation due to simultaneous multiple imperfect channel conditions, a packet scheduling algorithm based on channel prediction and the proposed scheduling scheme is developed in downlink LTE system for GBR services. It was shown in simulation results that the Kalman filter based channel predictor can effectively recover the correct CQI from erroneous channel quality feedback, therefore, the system performance is significantly improved

An Energy and Performance Exploration of Network-on-Chip Architectures

In this paper, we explore the designs of a circuit-switched router, a wormhole router, a quality-of-service (QoS) supporting virtual channel router and a speculative virtual channel router and accurately evaluate the energy-performance tradeoffs they offer. Power results from the designs placed and routed in a 90-nm CMOS process show that all the architectures dissipate significant idle state power. The additional energy required to route a packet through the router is then shown to be dominated by the data path. This leads to the key result that, if this trend continues, the use of more elaborate control can be justified and will not be immediately limited by the energy budget. A performance analysis also shows that dynamic resource allocation leads to the lowest network latencies, while static allocation may be used to meet QoS goals. Combining the power and performance figures then allows an energy-latency product to be calculated to judge the efficiency of each of the networks. The speculative virtual channel router was shown to have a very similar efficiency to the wormhole router, while providing a better performance, supporting its use for general purpose designs. Finally, area metrics are also presented to allow a comparison of implementation costs

Architecture, design, and modeling of the OPSnet asynchronous optical packet switching node

An all-optical packet-switched network supporting multiple services represents a long-term goal for network operators and service providers alike. The EPSRC-funded OPSnet project partnership addresses this issue from device through to network architecture perspectives with the key objective of the design, development, and demonstration of a fully operational asynchronous optical packet switch (OPS) suitable for 100 Gb/s dense-wavelength-division multiplexing (DWDM) operation. The OPS is built around a novel buffer and control architecture that has been shown to be highly flexible and to offer the promise of fair and consistent packet delivery at high load conditions with full support for quality of service (QoS) based on differentiated services over generalized multiprotocol label switching

Synchronization of a WDM Packet-Switched Slotted Ring

In this paper, we present two different strategies of slot synchronization in wavelength-division-multiplexing (WDM) packet-switched slotted-ring networks. Emphasis is given to the architecture behind the WDM Optical Network Demonstrator over Rings (WONDER) project, which is based on tunable transmitters and fixed receivers. The WONDER experimental prototype is currently being developed at the laboratories of Politecnico di Torino. In the former strategy, a slotsynchronization signal is transmitted by the master station on a dedicated control wavelength; in the latter, slave nodes achieve slot synchronization aligning on data packets that are received from the master. The performance of both synchronization strategies, particularly in terms of packet-collision probability, was evaluated by simulation. The technique based on transmitting a timing signal on a dedicated control wavelength achieves better performance, although it is more expensive due to the need for an additional wavelength. However, the technique based on aligning data packets that are received from the master, despite attaining lower timing stability, still deserves further study, particularly if limiting the number of wavelengths and receivers is a major requirement. Some experimental results, which were measured on the WONDER prototype, are also shown. Measurement results, together with theoretical findings, demonstrate the good synchronization performance of the prototype

Cycle-accurate evaluation of reconfigurable photonic networks-on-chip

There is little doubt that the most important limiting factors of the performance of next-generation Chip Multiprocessors (CMPs) will be the power efficiency and the available communication speed between cores. Photonic Networks-on-Chip (NoCs) have been suggested as a viable route to relieve the off- and on-chip interconnection bottleneck. Low-loss integrated optical waveguides can transport very high-speed data signals over longer distances as compared to on-chip electrical signaling. In addition, with the development of silicon microrings, photonic switches can be integrated to route signals in a data-transparent way. Although several photonic NoC proposals exist, their use is often limited to the communication of large data messages due to a relatively long set-up time of the photonic channels. In this work, we evaluate a reconfigurable photonic NoC in which the topology is adapted automatically (on a microsecond scale) to the evolving traffic situation by use of silicon microrings. To evaluate this system's performance, the proposed architecture has been implemented in a detailed full-system cycle-accurate simulator which is capable of generating realistic workloads and traffic patterns. In addition, a model was developed to estimate the power consumption of the full interconnection network which was compared with other photonic and electrical NoC solutions. We find that our proposed network architecture significantly lowers the average memory access latency (35% reduction) while only generating a modest increase in power consumption (20%), compared to a conventional concentrated mesh electrical signaling approach. When comparing our solution to high-speed circuit-switched photonic NoCs, long photonic channel set-up times can be tolerated which makes our approach directly applicable to current shared-memory CMPs

Optically-Connected Memory: Architectures and Experimental Characterizations

Growing demands on future data centers and high-performance computing systems are driving the development of processor-memory interconnects with greater performance and flexibility than can be provided by existing electronic interconnects. A redesign of the systems' memory devices and architectures will be essential to enabling high-bandwidth, low-latency, resilient, energy-efficient memory systems that can meet the challenges of exascale systems and beyond. By leveraging an optics-based approach, this thesis presents the design and implementation of an optically-connected memory system that exploits both the bandwidth density and distance-independent energy dissipation of photonic transceivers, in combination with the flexibility and scalability offered by optical networks. By replacing the electronic memory bus with an optical interconnection network, novel memory architectures can be created that are otherwise infeasible. With remote optically-connected memory nodes accessible to processors as if they are local, programming models can be designed to utilize and efficiently share greater amounts of data. Processors that would otherwise be idle, being starved for data while waiting for scarce memory resources, can instead operate at high utilizations, leading to drastic improvements in the overall system performance. This work presents a prototype optically-connected memory module and a custom processor-based optical-network-aware memory controller that communicate transparently and all-optically across an optical interconnection network. The memory modules and controller are optimized to facilitate memory accesses across the optical network using a packet-switched, circuit-switched, or hybrid packet-and-circuit-switched approach. The novel memory controller is experimentally demonstrated to be compatible with existing processor-memory access protocols, with the memory controller acting as the optics-computing interface to render the optical network transparent. Additionally, the flexibility of the optical network enables additional performance benefits including increased memory bandwidth through optical multicasting. This optically-connected architecture can further enable more resilient memory system realizations by expanding on current error dectection and correction memory protocols. The integration of optics with memory technology constitutes a critical step for both optics and computing. The scalability challenges facing main memory systems today, especially concerning bandwidth and power consumption, complement well with the strengths of optical communications-based systems. Additionally, ongoing efforts focused on developing low-cost optical components and subsystems that are suitable for computing environments may benefit from the high-volume memory market. This work therefore takes the first step in merging the areas of optics and memory, developing the necessary architectures and protocols to interface the two technologies, and demonstrating potential benefits while identifying areas for future work. Future computing systems will undoubtedly benefit from this work through the deployment of high-performance, flexible, energy-efficient optically-connected memory architectures