88 research outputs found
CMOS Data Converters for Closed-Loop mmWave Transmitters
With the increased amount of data consumed in mobile communication systems, new solutions for the infrastructure are needed. Massive multiple input multiple output (MIMO) is seen as a key enabler for providing this increased capacity. With the use of a large number of transmitters, the cost of each transmitter must be low. Closed-loop transmitters, featuring high-speed data converters is a promising option for achieving this reduced unit cost.In this thesis, both digital-to-analog (D/A) and analog-to-digital (A/D) converters suitable for wideband operation in millimeter wave (mmWave) massive MIMO transmitters are demonstrated. A 2
76 bit radio frequency digital-to-analog converter (RF-DAC)-based in-phase quadrature (IQ) modulator is demonstrated as a compact building block, that to a large extent realizes the transmit path in a closed-loop mmWave transmitter. The evaluation of an successive-approximation register (SAR) analog-to-digital converter (ADC) is also presented in this thesis. Methods for connecting simulated and measured performance has been studied in order to achieve a better understanding about the alternating comparator topology.These contributions show great potential for enabling closed-loop mmWave transmitters for massive MIMO transmitter realizations
Radio-Communications Architectures
Wireless communications, i.e. radio-communications, are widely used for our different daily needs. Examples are numerous and standard names like BLUETOOTH, WiFI, WiMAX, UMTS, GSM and, more recently, LTE are well-known [Baudoin et al. 2007]. General applications in the RFID or UWB contexts are the subject of many papers. This chapter presents radio-frequency (RF) communication systems architecture for mobile, wireless local area networks (WLAN) and connectivity terminals. An important aspect of today's applications is the data rate increase, especially in connectivity standards like WiFI and WiMAX, because the user demands high Quality of Service (QoS). To increase the data rate we tend to use wideband or multi-standard architecture. The concept of software radio includes a self-reconfigurable radio link and is described here on its RF aspects. The term multi-radio is preferred. This chapter focuses on the transmitter, yet some considerations about the receiver are given. An important aspect of the architecture is that a transceiver is built with respect to the radio-communications signals. We classify them in section 2 by differentiating Continuous Wave (CW) and Impulse Radio (IR) systems. Section 3 is the technical background one has to consider for actual applications. Section 4 summarizes state-of-the-art high data rate architectures and the latest research in multi-radio systems. In section 5, IR architectures for Ultra Wide Band (UWB) systems complete this overview; we will also underline the coexistence and compatibility challenges between CW and IR systems
Millimeter-wave Communication and Radar Sensing — Opportunities, Challenges, and Solutions
With the development of communication and radar sensing technology, people are able to seek for a more convenient life and better experiences. The fifth generation (5G) mobile network provides high speed communication and internet services with a data rate up to several gigabit per second (Gbps). In addition, 5G offers great opportunities of emerging applications, for example, manufacture automation with the help of precise wireless sensing. For future communication and sensing systems, increasing capacity and accuracy is desired, which can be realized at millimeter-wave spectrum from 30 GHz to 300 GHz with several tens of GHz available bandwidth. Wavelength reduces at higher frequency, this implies more compact transceivers and antennas, and high sensing accuracy and imaging resolution. Challenges arise with these application opportunities when it comes to realizing prototype or demonstrators in practice. This thesis proposes some of the solutions addressing such challenges in a laboratory environment.High data rate millimeter-wave transmission experiments have been demonstrated with the help of advanced instrumentations. These demonstrations show the potential of transceiver chipsets. On the other hand, the real-time communication demonstrations are limited to either low modulation order signals or low symbol rate transmissions. The reason for that is the lack of commercially available high-speed analog-to-digital converters (ADCs); therefore, conventional digital synchronization methods are difficult to implement in real-time systems at very high data rates. In this thesis, two synchronous baseband receivers are proposed with carrier recovery subsystems which only require low-speed ADCs [A][B].Besides synchronization, high-frequency signal generation is also a challenge in millimeter-wave communications. The frequency divider is a critical component of a millimeter-wave frequency synthesizer. Having both wide locking range and high working frequencies is a challenge. In this thesis, a tunable delay gated ring oscillator topology is proposed for dual-mode operation and bandwidth extension [C]. Millimeter-wave radar offers advantages for high accuracy sensing. Traditional millimeter-wave radar with frequency-modulated continuous-wave (FMCW), or continuous-wave (CW), all have their disadvantages. Typically, the FMCW radar cannot share the spectrum with other FMCW radars.\ua0 With limited bandwidth, the number of FMCW radars that could coexist in the same area is limited. CW radars have a limited ambiguous distance of a wavelength. In this thesis, a phase-modulated radar with micrometer accuracy is presented [D]. It is applicable in a multi-radar scenario without occupying more bandwidth, and its ambiguous distance is also much larger than the CW radar. Orthogonal frequency-division multiplexing (OFDM) radar has similar properties. However, its traditional fast calculation method, fast Fourier transform (FFT), limits its measurement accuracy. In this thesis, an accuracy enhancement technique is introduced to increase the measurement accuracy up to the micrometer level [E]
An FPGA implementation of OFDM transceiver for LTE applications
The paper presents a real-time transceiver using an
Orthogonal Frequency-Division Multiplexing (OFDM)
signaling scheme. The transceiver is implemented on a
Field-
Programmable Gate Array (FPGA) through Xilinx System
Generator for DSP and includes all the blocks needed
for the
transmission path of OFDM. The transmitter frame can be
reconfigured for different pilot and data schemes. In the
receiver, time-domain synchronization is achieved thr
ough a
joint maximum likelihood (ML) symbol arrival-time and
carrier frequency offset (CFO) estimator through the
redundant information contained in the cyclic prefix (CP).
A
least-squares channel estimation retrieves the channel
state
information and a simple zero-forcing scheme has been
implemented for channel equalization. Results show that a
rough implementation of the signal path can be impleme
nted
by using only Xilinx System Generator for DSP
Design and implementation of an ETSI-SDR OFDM transmitter with power amplifier linearizer
Satellite radio has attained great popularity because of its wide range of geographical coverage and high signal quality as compared to the terrestrial broadcasts. Most Satellite Digital Radio (SDR) based systems favor multi-carrier transmission schemes, especially, orthogonal frequency division multiplexing (OFDM) transmission because of high data transfer rate and spectral efficiency.
It is a challenging task to find a suitable platform that supports fast data rates and superior processing capabilities required for the development and deployment of the new SDR standards. Field programmable gate array (FPGA) devices have the potential to become suitable development platform for such standards. Another challenging factor in SDR systems is the distortion of variable envelope signals used in OFDM transmission by the nonlinear RF power amplifiers (PA) used in the base station transmitters. An attractive option is to use a linearizer that would compensate for the nonlinear effects of the PA.
In this research, an OFDM transmitter, according to European Telecommunications Standard Institute (ETSI) SDR Technical Specifications 2007-2008, was designed and implemented on a low-cost Xilinx FPGA platform. A weakly nonlinear PA, operating in the L-band SDR frequency (1.450-1.490GHz), was used for signal transmission. An FPGA-based, low-cost, adaptive linearizer was designed and implemented based on the digital predistortion (DPD) reference design from Xilinx, to correct the distortion effects of the PA on the transmitted signal
SATELLITE COMMUNICATIONS STUDY
Satellite communication systems have become an essential part of the world's
telecommunication infrastructure, serving billions of people with telephone, data and
video services. Despite the growth of fiber optic links, which have much greater capacity
than satellite systems and a lower cost per bit, satellite systems continue to thrive and
investment in new systems, continues. Satellite services have shifted away from
telephony toward video and data delivery, with television broadcasting directly to the
home emerging as oneof themost powerful applications.
The objective of this project is to study satellite communications study through
experiments and MATLAB simulation for QPSK as satellite modulation techniques. The
experiments carried out were on TVRO board and weather satellites. Factors involved in
determining actual signals from a broadcast television signal and tuning foreign
television channels. Satellite footprints prediction is also has been carried on weather
satellite experiments. It also shows the location of satellite within a certain time interval
and indicates the area covered by asatellite. Besides that, the study on Global Positioning
Systems (GPS) using Earth.Google also been conducted. It shows satellite images
combined with maps and aerial photographs depends on medium or high resolution
terrain data. In satellite modulation techniques which are QPSK, aMATLAB coding has
been developed and the study on demodulator and modulator has also been considered.
Geostationary Earth Orbit (GEO) satellites carry the majority services, because
the use of high gain fixed antennas at earth stations maximizes the capacity of the
satellites. Over the years, there has been atrend away from trunk communications using
very large earth station antennas toward delivery from more powerful satellites to
individual users using much smaller antennas. Low Earth orbit (LEO) and Medium Earth
Orbit (MEO) satellites are used for mobile communications and navigation system and,
as the need for Geographic Information Systems grows with a variety of applications,
LEO earth imaging satellites have the potential to provide strong revenue streams
- …