Methods of power line interference elimination in EMG signals

Electromyogram (EMG) recordings are often corrupted by the wide range of artifacts, which one of them is power line interference (PLI). The study focuses on some of the well-known signal processing approaches used to eliminate or attenuate PLI from EMG signal. The results are compared using signal-to-noise ratio (SNR), correlation coefficients and Bland-Altman analysis for each tested method: notch filter, adaptive noise canceller (ANC) and wavelet transform (WT). Thus, the power of the remaining noise and shape of the output signal are analysed. The results show that the ANC method gives the best output SNR and lowest shape distortion compared to the other methods.Web of Science40706

Notch Filtering Suitable for Real Time Removal of Power Line Interference

This paper presents a high performance notch filtering for real time suppression of power line interference in a general signal. The disturbing signal is suppressed using an optimal notch FIR filter with tunable notch frequency. The tuning of the filter preserves its selectivity, most importantly the specified attenuation at the notch frequency. One example and two Matlab functions demonstrate the performance, robustness and usefulness of the proposed procedure for the design and tuning of optimal notch FIR filters suitable in the real time notch filtering

Review on Power Line Interference Removal from ECG Signal Using Adaptive and Error Filter

An ECG signal is basically an index of the functionality of the heart. For example, a physician can detect arrhythmia by studying abnormalities in the ECG signal. Since very fine features present in an ECG signal may convey important information, it is important to have the signal as clean as possible. Power line interference may be significant in electrocardiography. Often, a proper recording environment is not sufficient to avoid this interference. ECG signals polluted by power line noise of relatively large amplitude were the frequency of power line interference accurately at 50 Hz or 60 Hz, a sharp notch filter would be able to separate and eliminate the noise. The major difficulty is that the frequency can vary about fractions of a Hertz, or even a few Hertz. Two different approaches have been proposed in literature for this purpose notch filters and adaptive interference cancellers. Notch filters reduce the power line interference by suppressing predetermined frequencies. One of the possible alternatives to take frequency variations into account is the use of an external reference power line signal. An ideal EMI filter for ECG should act as a sharp notch filter to eliminate only the undesirable power line interference while automatically adapting itself to variations in the frequency and level of the noise. This technique, available by the use of adaptive filters only, is reported in literature and present serious practical difficulties and is difficult to implement

Removal of Power Line Interference from Electrocardiograph (ECG) using Proposed Adaptive Filter Algorithm

ECG signals in measurements are contaminated by noises including power line interference. In recent years, adaptive filters with different approaches have been investigated to remove power line interference in ECG.In this paper, an adaptive filter is proposed to cancel power line interference in ECG signals. The proposed algorithm is experimented with MIT-BIH ECG signals data base. The algorithm2019;s results are compared with the results of other adaptive filter algorithms using Least Mean Square (LMS), Normalized Least Mean Square (NLMS) by Signal to Noise (SNR). Theses works are performed by LabVIEW software

A comprehensive model for power line interference in biopotential measurements

Power line interference is a major problem in high-resolution biopotential measurements. Because interference coupling is mostly capacitive, shielding electrode leads and a high common-mode rejection ratio (CMRR) are quite effective in reducing power-line interference but do not completely eliminate it. We propose a model that includes both interference external to the measuring system and interference coming from its internal power supply. Moreover, the model considers interference directly coupled to the measuring electrodes, because, as opposed to connecting leads, electrodes are not usually shielded. Experimental results confirm that reducing interference coupled through electrodes yields a negligible interference. The proposed model can be applied to other differential measurement systems, particulary those involving electrodes or sensors placed far apart.Peer Reviewe

Effects of Power Line Communication on Radio Communication Equipment

Radio communication is a wireless transfer of information via power cable by Power Line Communication (PLC) and its dissemination through radio communication equipment.. However, this information causes signal interference, noise and distortion with the power line communication. This work analyzed the effect of PLC on radio communication equipment by interconnecting two high-speed PLC modems communicating with a data rate of up to 250 Mbit/s using telephone distribution wiring for radio spectrum to reduce the interference radiation that emanates from a power line. The measurements were made using a reference antenna at a distance of 3 m from the power line. The peak field-strength values were measured and recorded in the 30-350 MHz frequency range in horizontal and vertical polarization. The result shows that interference radiation occurring at frequencies up to 305 MHz, includes the FM band as well as the Digital Audio Broadcasting (DAB) band. It is expected that as the data rate of high speed modems increases, a corresponding increase in the interference radiation occurs at frequencies above 300 MHz. To this regard, administrations should take all practicable and necessary steps to ensure that the operation of power and telecommunication distribution networks do not cause harmful interference to a radio communication service. Keywords: PLC, Radio Communication, Interference, Noise, Distortion, Communication Equipment, Field Strength, DAB DOI: 10.7176/JNSR/9-16-04 Publication date: August 31st 201

Removing non-stationary, non-harmonic external interference from gravitational wave interferometer data

We describe a procedure to identify and remove a class of non-stationary and non-harmonic interference lines from gravitational wave interferometer data. These lines appear to be associated with the external electricity main supply, but their amplitudes are non-stationary and they do not appear at harmonics of the fundamental supply frequency. We find an empirical model able to represent coherently all the non-harmonic lines we have found in the power spectrum, in terms of an assumed reference signal of the primary supply input signal. If this signal is not available then it can be reconstructed from the same data by making use of the coherent line removal algorithm that we have described elsewhere. All these lines are broadened by frequency changes of the supply signal, and they corrupt significant frequency ranges of the power spectrum. The physical process that generates this interference is so far unknown, but it is highly non-linear and non-stationary. Using our model, we cancel the interference in the time domain by an adaptive procedure that should work regardless of the source of the primary interference. We have applied the method to laser interferometer data from the Glasgow prototype detector, where all the features we describe in this paper were observed. The algorithm has been tuned in such a way that the entire series of wide lines corresponding to the electrical interference are removed, leaving the spectrum clean enough to detect signals previously masked by them. Single-line signals buried in the interference can be recovered with at least 75 % of their original signal amplitude.Comment: 14 pages, 5 figures, Revtex, psfi

Cancelling Harmonic Power Line Interference in Biopotentials

Biopotential signals, like the electrocardiogram (ECG), electroencephalogram (EEG), electromyogram (EMG), and so on, contain vital information about the health state of human body. The morphology and time/frequency parameters of the biopotentials are of interest when diagnostic information is extracted and analyzed. The powerline interference (PLI), with the fundamental PLI component of 50 Hz/60 Hz and its harmonics, is one of the most disturbing noise sources in biopotential recordings that hampers the analysis of the electrical signals generated by the human body. The aim of this chapter is to review the existing methods to eliminate harmonics PLI from biopotential signals and to analyze the distortion introduced by some of the most basic approaches for PLI cancelation and whether this distortion affects the diagnostic performance in biopotentials investigations