4,831 research outputs found

    PAR-Aware Large-Scale Multi-User MIMO-OFDM Downlink

    Full text link
    We investigate an orthogonal frequency-division multiplexing (OFDM)-based downlink transmission scheme for large-scale multi-user (MU) multiple-input multiple-output (MIMO) wireless systems. The use of OFDM causes a high peak-to-average (power) ratio (PAR), which necessitates expensive and power-inefficient radio-frequency (RF) components at the base station. In this paper, we present a novel downlink transmission scheme, which exploits the massive degrees-of-freedom available in large-scale MU-MIMO-OFDM systems to achieve low PAR. Specifically, we propose to jointly perform MU precoding, OFDM modulation, and PAR reduction by solving a convex optimization problem. We develop a corresponding fast iterative truncation algorithm (FITRA) and show numerical results to demonstrate tremendous PAR-reduction capabilities. The significantly reduced linearity requirements eventually enable the use of low-cost RF components for the large-scale MU-MIMO-OFDM downlink.Comment: To appear in IEEE Journal on Selected Areas in Communication

    On Out-of-Band Emissions of Quantized Precoding in Massive MU-MIMO-OFDM

    Full text link
    We analyze out-of-band (OOB) emissions in the massive multi-user (MU) multiple-input multiple-output (MIMO) downlink. We focus on systems in which the base station (BS) is equipped with low-resolution digital-to-analog converters (DACs) and orthogonal frequency-division multiplexing (OFDM) is used to communicate to the user equipments (UEs) over frequency-selective channels. We demonstrate that analog filtering in combination with simple frequency-domain digital predistortion (DPD) at the BS enables a significant reduction of OOB emissions, but degrades the signal-to-interference-noise-and-distortion ratio (SINDR) at the UEs and increases the peak-to-average power ratio (PAR) at the BS. We use Bussgang's theorem to characterize the tradeoffs between OOB emissions, SINDR, and PAR, and to study the impact of analog filters and DPD on the error-rate performance of the massive MU-MIMO-OFDM downlink. Our results show that by carefully tuning the parameters of the analog filters, one can achieve a significant reduction in OOB emissions with only a moderate degradation of error-rate performance and PAR.Comment: Presented at the 2017 Asilomar Conference on Signals, Systems, and Computers, 6 page

    A First-Order Primal-Dual Method for Saddle Point Optimization of PAPR Problem in MU-MIMO-OFDM Systems

    Get PDF
    This paper investigates the use of a particular splitting-based optimization technique for constrained l∞-norm based peak-to-average power ratio (PAPR) reduction problem in multiuser orthogonal frequency-division multiplexing (OFDM) based multiple-input multi-output (MIMO) systems. PAPR reduction and multi-user interference (MUI) cancelation are considered in a saddle-point formulation on the downlink of a multi-user MIMO-OFDM system and an efficient primal-dual hybrid gradient (PDHG) inspired algorithm with easy-to-evaluate proximal operators is developed. The proposed algorithm converges significantly faster to satisfactory solutions with much improved asymptotical convergence rate than existing methods. Numerical results illustrate the superior performance of the proposed algorithm over existing methods in terms of PAPR reduction for different MIMO configurations

    The Bit Error Rate (BER) Performance in Multi-Carrier (OFDM) and Single-Carrier

    Get PDF
    The spectacular growth of wireless communication tools has escalated the number of mobile subscribers from almost 700 million in 2000 to more than 4 billion in 2009. The huge number of subscribers has led to several issues with how service is provided. The high user demand has forced developers to overcome the problems of the old analog systems and to introduce OFDM as a promising technique that can fulfill users\u27 high demands. This technique matches well with high data rate connection and provides a higher capacity for the subscribers\u27 usage. The OFDM, as a multi-carrier, is more complex than the single-carrier transmission scheme. However, the OFDM technique maintains better performance for high data rate in terms of bit error rate (BER). In this thesis a comparison has been presented between the multi-carrier OFDM and the single-carrier to prove, in a simulation form, the theoretical point of view. Despite the advantages of using the OFDM scheme, there are several drawbacks. One of these negatives is the high peak to average power ratio (PAPR). To overcome this problem, there are power reduction techniques that can be applied to the signal to reduce the high power. One of these techniques is the clipping and filtering technique. A maximum level is sited for the transmitted signal to reduce the power and afterward, the signal goes through a filter to remove the influence of the in-band distortion and out-of-band radiation

    Resource Allocation-Based PAPR Analysis in Uplink SCMA-OFDM Systems

    Get PDF
    Sparse code multiple access (SCMA) is a non-orthogonal multiple access (NOMA) uplink solution that overloads resource elements (RE's) with more than one user. Given the success of orthogonal frequency division multiplexing (OFDM) systems, SCMA will likely be deployed as a multiple access scheme over OFDM, called an SCMA-OFDM system. One of the major challenges with OFDM systems is the high peak-to-average power ratio (PAPR) problem, which is typically studied through the PAPR statistics for a system with a large number of independently modulated sub-carriers (SCs). In the context of SCMA systems, the PAPR problem has been studied before through the SCMA codebook design for certain narrowband scenarios, applicable more for low-rate users. However, we show that for high-rate users in wideband systems, it is more meaningful to study the PAPR statistics. In this paper, we highlight some novel aspects to the PAPR statistics for SCMA-OFDM systems that is different from the vast body of existing PAPR literature in the context of traditional OFDM systems. The main difference lies in the fact that the SCs are not independently modulated in SCMA-OFDM systems. Instead, the SCMA codebook uses multi-dimensional constellations, leading to a statistical dependency between the data carrying SCs. Further, the SCMA codebook dictates that an UL user can only transmit on a subset of the available SCs. We highlight the joint effect of the two major factors that influence the PAPR statistics-the phase bias in the multi-dimensional constellation design along with the resource allocation strategy. The choice of modulation scheme and SC allocation strategy are static configuration options, thus allowing for PAPR reduction opportunities in SCMA-OFDM systems through the setting of static configuration parameters. Compared to the class of PAPR reduction techniques in the OFDM literature that rely on multiple signalling and probabilistic techniques, these gains come with no computational overhead. In this paper, we also examine these PAPR reduction techniques and their applicability to SCMA-OFDM systems

    An intelligent genetic algorithm for PAPR reduction in a multi-carrier CDMA wireless system

    Get PDF
    Abstract— A novel intelligent genetic algorithm (GA), called Minimum Distance guided GA (MDGA) is proposed for peak-average-power ratio (PAPR) reduction based on partial transmit sequence (PTS) scheme in a synchronous Multi-Carrier Code Division Multiple Access (MC-CDMA) system. In contrast to traditional GA, our MDGA starts with a balanced ratio of exploration and exploitation which is maintained throughout the process. It introduces a novel replacement strategy which increases significantly the convergence rate and reduce dramatically computational complexity as compared to the conventional GA. The simulation results demonstrate that, if compared to the PAPR reduction schemes using exhaustive search and traditional GA, our scheme achieves 99.52% and 50+% reduction in computational complexity respectively
    corecore