6,387 research outputs found
Reducing dynamic power consumption in next generation DS-CDMA mobile communication receivers
Reduction of the power consumption in portable wireless receivers is important for cellular systems, including UMTS and IMT2000. This paper explores the architectural design-space and methodologies for reducing the dynamic power dissipation in the Direct Sequence Code Division Multiple Access (DS-CDMA) downlink RAKE receiver. At the algorithm level, we investigate the tradeoffs of reduced precision and arithmetic complexity on the receiver performance. We then present and analyse two architectures for implementing the reference and reduced complexity receivers, with respect to dynamic power dissipation. The combined effect of reduced precision and complexity reduction leads to a 37.44% power savings.Nokia CorporationTexas Instruments Inc.National Science Foundatio
Blind adaptive constrained reduced-rank parameter estimation based on constant modulus design for CDMA interference suppression
This paper proposes a multistage decomposition for blind adaptive parameter estimation in the Krylov subspace with the code-constrained constant modulus (CCM) design criterion. Based on constrained optimization of the constant modulus cost function and utilizing the Lanczos algorithm and Arnoldi-like iterations, a multistage decomposition is developed for blind parameter estimation. A family of computationally efficient blind adaptive reduced-rank stochastic gradient (SG) and recursive least squares (RLS) type algorithms along with an automatic rank selection procedure are also devised and evaluated against existing methods. An analysis of the convergence properties of the method is carried out and convergence conditions for the reduced-rank adaptive algorithms are established. Simulation results consider the application of the proposed techniques to the suppression of multiaccess and intersymbol interference in DS-CDMA systems
Low-complexity high-performance GFSK receiver with carrier frequency offset correction
This paper presents an implementation of a GFSK receiver based on matched filtering of a sequence of K successive bits. This enables improved detection and superior BER performance but requires 2K matched filters of considerable complexity. Exploiting redundancy by performing phase propagation of successive single-bit stages, we propose an efficient receiver implementation. Results presented highlight the benefits of the proposed methd in terms of computational cost and performance compared to standard methods. We also address carrier frequency offset, and suggest a blind algorithm for its elimination. Performance results are exemplarily shown for a Bluetooth system
Massive MIMO for Ultra-reliable Communications with Constellations for Dual Coherent-noncoherent Detection
The stringent requirements of ultra-reliable low-latency communications
(URLLC) require rethinking of the physical layer transmission techniques.
Massive antenna arrays are seen as an enabler of the emerging
generation systems, due to increases in spectral efficiency and degrees of
freedom for transmissions, which can greatly improve reliability under
demanding latency requirements. Massive array coherent processing relies on
accurate channel state information (CSI) in order to achieve high reliability.
In this paper, we investigate the impact of imperfect CSI in a single-input
multiple-output (SIMO) system on the coherent receiver. An amplitude-phase
keying (APK) symbol constellation is proposed, where each two symmetric symbols
reside on distinct power levels. The symbols are demodulated using a dual-stage
non-coherent and coherent detection strategy, in order to improve symbol
reliability. By means of analysis and simulation, we find an adequate scaling
of the constellation and show that for high signal-to-noise ratio (SNR) and
inaccurate CSI regime, the proposed scheme enhances receiver performance.Comment: Accepted at WSA 2018, special session on "Massive MIMO for mobile
broadband communications and new 5G services
Preliminary Candidate Advanced Avionics System (PCAAS)
Specifications which define the system functional requirements, the subsystem and interface needs, and other requirements such as maintainability, modularity, and reliability are summarized. A design definition of all required avionics functions and a system risk analysis are presented
- …