Enhanced circuit for linear ring VCO-ADCs

Recently an extremely linear voltage-controlled ring-oscillator for use in VCO-ADCs was proposed by Babaie-Fishani and Rombouts. In this current Letter, a circuit-level technique to improve the bandwidth and noise performance of such a linear VCO is proposed. The key element is the modified delay cell, where the traditional cross-coupled inverters are modified into ` feed-forward' coupling inverters that pre-charge the subsequent elements in the ring. The resulting circuit maintains the excellent linearity, but has greatly enhanced bandwidth (up to 3 times higher) and considerably reduced power for the same circuit noise level (up to 2.5 times lower)

DESIGN OF A FOUR STAGES VCO USING A NOVEL DELAY CIRCUIT FOR OPERATION IN DISTRIBUTED BAND FREQUENCIES

The manuscript proposes a novel architecture of a delay cell that is implemented in 4-stage VCO which has the ability to operate in two distributed frequency bands. The operating frequency is chosen based on the principle of carrier mobility and the transistor resistance. The VCO uses dual delay input techniques to improve the frequency of operation. The design is implemented in Cadence 90nm GPDK CMOS technology and simulated results show that it is capable of operating in dual frequency bands of 55 MHz to 606 MHz and 857 MHz to 1049 MHz. At normal temperature (270) power consumption of the circuit is found to be 151μW at 606 MHz and 157μW at 1049 MHz respectively and consumes an area of 171.42µm2. The design shows good tradeoff between the parameters-operating frequency, phase noise and power consumption

Time-encoding analog-to-digital converters : bridging the analog gap to advanced digital CMOS? Part 2: architectures and circuits

The scaling of CMOS technology deep into the nanometer range has created challenges for the design of highperformance analog ICs: they remain large in area and power consumption in spite of process scaling. Analog circuits based on time encoding [1], [2], where the signal information is encoded in the waveform transitions instead of its amplitude, have been developed to overcome these issues. While part one of this overview article [3] presented the basic principles of time encoding, this follow-up article describes and compares the main time-encoding architectures for analog-to-digital converters (ADCs) and discusses the corresponding design challenges of the circuit blocks. The focus is on structures that avoid, as much as possible, the use of traditional analog blocks like operational amplifiers (opamps) or comparators but instead use digital circuitry, ring oscillators, flip-flops, counters, an so on. Our overview of the state of the art will show that these circuits can achieve excellent performance. The obvious benefit of this highly digital approach to realizing analog functionality is that the resulting circuits are small in area and more compatible with CMOS process scaling. The approach also allows for the easy integration of these analog functions in systems on chip operating at "digital" supply voltages as low as 1V and lower. A large part of the design process can also be embedded in a standard digital synthesis flow