Adaptive Neural Back-Stepping Control with Constrains for a Flexible Air-Breathing Hypersonic Vehicle

The design of an adaptive neural back-stepping control for a flexible air-breathing hypersonic vehicle (AHV) in the presence of input constraint and aerodynamic uncertainty is discussed. Based on functional decomposition, the dynamics can be decomposed into the velocity subsystem and the altitude subsystem. To guarantee the exploited controller’s robustness with respect to parametric uncertainties, neural network (NN) is applied to approximate the lumped uncertainty of each subsystem of AHV model. The exceptional contribution is that novel auxiliary systems are introduced to compensate both the tracking errors and desired control laws, based on which the explored controller can still provide effective tracking of velocity and altitude commands when the actuators are saturated. Finally, simulation studies are made to illustrate the effectiveness of the proposed control approach in spite of the flexible effects, system uncertainties, and varying disturbances

Robust Adaptive Neural Control of Morphing Aircraft with Prescribed Performance

This study proposes a low-computational composite adaptive neural control scheme for the longitudinal dynamics of a swept-back wing aircraft subject to parameter uncertainties. To efficiently release the constraint often existing in conventional neural designs, whose closed-loop stability analysis always necessitates that neural networks (NNs) be confined in the active regions, a smooth switching function is presented to conquer this issue. By integrating minimal learning parameter (MLP) technique, prescribed performance control, and a kind of smooth switching strategy into back-stepping design, a new composite switching adaptive neural prescribed performance control scheme is proposed and a new type of adaptive laws is constructed for the altitude subsystem. Compared with previous neural control scheme for flight vehicle, the remarkable feature is that the proposed controller not only achieves the prescribed performance including transient and steady property but also addresses the constraint on NN. Two comparative simulations are presented to verify the effectiveness of the proposed controller

Observer-Based Nonlinear Dynamic Inversion Adaptive Control with State Constraints

Hypersonic vehicle research and development has grown recently in the aerospace industry due to the powerful potential of operating a vehicle that flies at substantially higher speeds than typical aircraft. From a guidance, navigation and control perspective, hypersonic vehicles are particularly interesting due both to inherent vehicle complexities as well as practical concerns that only arise at high Mach numbers. Challenges inherent to the vehicle include nonlinearities, a wide range of operating conditions, high elasticity, high temperatures and parametric uncertainty. Although these challenges have by no means fully been explored in the literature, in the realm of control theory, they are somewhat common. Hypersonic vehicle control is difficult however, because in addition to these more traditional complexities a control designer must also deal with problems very specific to flying at high speeds such as: inlet unstart, overcoming sensing deficiencies at high speeds and creating an implementable digital control framework for a plant with extremely fast dynamics. This dissertation develops three novel theoretical approaches for addressing these challenges through advances in the nonlinear dynamic inversion adaptive control technique. Although hypersonic vehicle control is the motivation and often the application that the control algorithms in this dissertation are tested on, several of the theoretical developments apply to a general class of nonlinear continuous time systems. First, in order to address the problem of inlet unstart, two state constraint mechanisms which integrate into the nonlinear dynamic inversion adaptive control framework are presented. These state constraining control laws require full state feedback and are capable of restricting the outputs of nonlinear systems containing parameter uncertainty to specific regions of the state-space. The first state constraint mechanism achieves this objective using sliding mode control and the second uses bounding functions to smoothly adjust the control and adaptive laws and drive the states toward the origin when constraints are approached. Stability is proven using Lyapunov analysis and these techniques are demonstrated in a nonlinear simulation of a hypersonic vehicle. Second, an observer-based feedback controller is developed that allows for a nonlinear system to track a reference trajectory with bounded errors and without measuring multiple states. Again, the technique used is nonlinear dynamic inversion adaptive control, but because of uncertainty in the system state, it is not assumed that the nonlinear control effectiveness matrix can be canceled perfectly. A nonlinear observer is implemented to estimate the values of the unknown states. This observer allows for the closed-loop stability of the system to be proven through Lyapunov analysis. It is shown that parametric uncertainty can successfully be accounted for using an adaptive mechanism and that all tracking and estimation errors are uniformly ultimately bounded. Finally, a sampled-data nonlinear dynamic inversion adaptive control architecture is introduced. Despite the prevalence of digital controllers in practice, a nonlinear dynamic inversion adaptive control scheme in a sampled-data setting has not previously been developed. The method presented in this dissertation has the capability of extending the benefits of nonlinear dynamic inversion adaptive control - robust control of nonlinear systems with respect to model uncertainty - to more practical platforms

Aeronautical engineering: A continuing bibliography with indexes (supplement 293)

This bibliography lists 476 reports, articles, and other documents introduced into the NASA scientific and technical information system in July, 1992. Subject coverage includes: design, construction and testing of aircraft and aircraft engines; aircraft components, equipment, and systems; ground support systems; and theoretical and applied aspects of aerodynamics and general fluid dynamics

Backstepping control with fixed-time prescribed performance for fixed wing UAV under model uncertainties and external disturbances

In this paper, a novel backstepping control scheme with fixed-time prescribed performance is proposed for the longitudinal model of fixed wing UAV subject to model uncertainties and external disturbances. The novel performance function with arbitrarily preassigned fixed-time convergence property is developed, which imposes priori performance envelops on both altitude and airspeed tracking errors. By using error transformed technology, the constrained fixed-time performance envelops are changed into unconstrained equivalent errors. Based on modified error compensation mechanism, a novel backstepping approach is proposed to guarantee altitude tracking equivalent error converges to the specified small neighborhood and presents excellent robustness against model uncertainties and external disturbances, and airspeed controller with fixed-time prescribed performance is designed. The proposed methodology guarantees the transient and steady-state performance of altitude and airspeed tracking errors within constrained fixed-time performance envelops in spite of lumped disturbances. Finally, numerical simulations are used to verify the effectiveness of the proposed control schem

Nonlinear Adaptive Dynamic Inversion Control for Hypersonic Vehicles

Because of the widely varying flight conditions in which hypersonic vehicles operate and certain aspects unique to hypersonic flight, the development of control architectures for these vehicles presents a challenge. Previous work on control design for hypersonic vehicles often has involved linearized or simplified nonlinear dynamical models of the aircraft. This dissertation retains the nonlinear dynamics in the design of the controller for a generic hypersonic vehicle model and develops nonlinear adaptive dynamic inversion control architecture with a control allocation scheme. A robustness analysis is performed on the initial controller design, which shows that the controller is able to handle time delays, perturbations in stability derivatives, and reduced control surface effectiveness while maintaining tracking performance. One particular safety concern in hypersonic flight is inlet unstarts, which not only produce a significant decrease in the thrust but also can lead to loss of control and possibly the loss of the vehicle. This dissertation focuses on the prevention of inlet unstarts that are triggered by an altered flow that fails to pass through the throat of the engine because the aircraft has exceeded limits on angle-of-attack and sideslip angle. To prevent undesirable inlet unstart events, the nonlinear adaptive dynamic inversion control architecture is given the ability to enforce state constraints. Because several phenomena can cause inlet unstarts, the control architecture also is tested to determine if the controller is able to maintain reference trajectory tracking and to prevent the loss of the vehicle should an inlet unstart occur. Additionally, a fault- tolerant control capability is added to the control architecture so that the vehicle can handle the failure of one or more control surfaces. The tracking performance of the nonlinear adaptive dynamic inversion control architecture is analyzed for the cases of enforcement of state constraints, control surface failures, and inlet unstarts. In all three cases, the control architecture is able to track reference trajectories with minimal to no degradation in performance. Limitations were discovered in the case of the controller that enforces state constraints in terms of the trajectories that can be tracked when combined with fault-tolerant control. However, the results indicate that the nonlinear adaptive dynamic inversion controller is able to achieve tracking performance in the presence of the uncertainties and inlet unstarts conditions studied in this dissertation

Observer-Based Nonlinear Dynamic Inversion Adaptive Control with State Constraints

Hypersonic vehicle research and development has grown recently in the aerospace industry due to the powerful potential of operating a vehicle that flies at substantially higher speeds than typical aircraft. From a guidance, navigation and control perspective, hypersonic vehicles are particularly interesting due both to inherent vehicle complexities as well as practical concerns that only arise at high Mach numbers. Challenges inherent to the vehicle include nonlinearities, a wide range of operating conditions, high elasticity, high temperatures and parametric uncertainty. Although these challenges have by no means fully been explored in the literature, in the realm of control theory, they are somewhat common. Hypersonic vehicle control is difficult however, because in addition to these more traditional complexities a control designer must also deal with problems very specific to flying at high speeds such as: inlet unstart, overcoming sensing deficiencies at high speeds and creating an implementable digital control framework for a plant with extremely fast dynamics. This dissertation develops three novel theoretical approaches for addressing these challenges through advances in the nonlinear dynamic inversion adaptive control technique. Although hypersonic vehicle control is the motivation and often the application that the control algorithms in this dissertation are tested on, several of the theoretical developments apply to a general class of nonlinear continuous time systems. First, in order to address the problem of inlet unstart, two state constraint mechanisms which integrate into the nonlinear dynamic inversion adaptive control framework are presented. These state constraining control laws require full state feedback and are capable of restricting the outputs of nonlinear systems containing parameter uncertainty to specific regions of the state-space. The first state constraint mechanism achieves this objective using sliding mode control and the second uses bounding functions to smoothly adjust the control and adaptive laws and drive the states toward the origin when constraints are approached. Stability is proven using Lyapunov analysis and these techniques are demonstrated in a nonlinear simulation of a hypersonic vehicle. Second, an observer-based feedback controller is developed that allows for a nonlinear system to track a reference trajectory with bounded errors and without measuring multiple states. Again, the technique used is nonlinear dynamic inversion adaptive control, but because of uncertainty in the system state, it is not assumed that the nonlinear control effectiveness matrix can be canceled perfectly. A nonlinear observer is implemented to estimate the values of the unknown states. This observer allows for the closed-loop stability of the system to be proven through Lyapunov analysis. It is shown that parametric uncertainty can successfully be accounted for using an adaptive mechanism and that all tracking and estimation errors are uniformly ultimately bounded. Finally, a sampled-data nonlinear dynamic inversion adaptive control architecture is introduced. Despite the prevalence of digital controllers in practice, a nonlinear dynamic inversion adaptive control scheme in a sampled-data setting has not previously been developed. The method presented in this dissertation has the capability of extending the benefits of nonlinear dynamic inversion adaptive control - robust control of nonlinear systems with respect to model uncertainty - to more practical platforms

Design Of An Adaptive Autopilot For An Expendable Launch Vehicle

This study investigates the use of a Model Reference Adaptive Control (MRAC) direct approach to solve the attitude control problem of an Expendable Launch Vehicle (ELV) during its boost phase of flight. The adaptive autopilot design is based on Lyapunov Stability Theory and provides a useful means for controlling the ELV in the presence of environmental and dynamical uncertainties. Several different basis functions are employed to approximate the nonlinear parametric uncertainties in the system dynamics. The control system is designed so that the desire dresponse to a reference model would be tracked by the closed-loop system. The reference model is obtained via the feedback linearization technique applied to the nonlinear ELV dynamics. The adaptive control method is then applied to a representative ELV longitudinal motion, specifically the 6th flight of Atlas-Centaur launch vehicle (AC-6) in 1965. The simulation results presented are compared to that of the actual AC-6 post-flight trajectory reconstruction. Recommendations are made for modification and future applications of the method for several other ELV dynamics issues, such as control saturation, engine inertia, flexible body dynamics, and sloshing of liquid fuels

Survey on Flight Control Technology for Large-Scale Helicopter

A literature review of flight control technology is presented for large-scale helicopter. Challenges of large-scale helicopter flight control system (FCS) design are illustrated. Following this, various flight control methodologies are described with respect to their engineering implementation and theoretical developments, whose advantages and disadvantages are also analyzed. Then, the challenging research issues on flight control technology are identified, and future directions are highlighted

Optimized state feedback regulation of 3DOF helicopter system via extremum seeking

In this paper, an optimized state feedback regulation of a 3 degree of freedom (DOF) helicopter is designed via extremum seeking (ES) technique. Multi-parameter ES is applied to optimize the tracking performance via tuning State Vector Feedback with Integration of the Control Error (SVFBICE). Discrete multivariable version of ES is developed to minimize a cost function that measures the performance of the controller. The cost function is a function of the error between the actual and desired axis positions. The controller parameters are updated online as the optimization takes place. This method significantly decreases the time in obtaining optimal controller parameters. Simulations were conducted for the online optimization under both fixed and varying operating conditions. The results demonstrate the usefulness of using ES for preserving the maximum attainable performance