14,839 research outputs found

    Energy Efficient Relay-Assisted Cellular Network Model using Base Station Switching

    Get PDF
    Cellular network planning strategies have tended to focus on peak traffic scenarios rather than energy efficiency. By exploiting the dynamic nature of traffic load profiles, the prospect for greener communications in cellular access networks is evolving. For example, powering down base stations (BS) and applying cell zooming can significantly reduce energy consumption, with the overriding design priority still being to uphold a minimum quality of service (QoS). Switching off cells completely can lead to both coverage holes and performance degradation in terms of increased outage probability, greater transmit power dissipation in the up and downlinks, and complex interference management, even at low traffic loads. In this paper, a cellular network model is presented where certain BS rather than being turned off, are switched to low-powered relay stations (RS) during zero-to-medium traffic periods. Neighbouring BS still retain all the baseband signal processing and transmit signals to corresponding RS via backhaul connections, under the assumption that the RS covers the whole cell. Experimental results demonstrate the efficacy of this new BS-RS Switching technique from both an energy saving and QoS perspective, in the up and downlinks

    Efficient DSP and Circuit Architectures for Massive MIMO: State-of-the-Art and Future Directions

    Full text link
    Massive MIMO is a compelling wireless access concept that relies on the use of an excess number of base-station antennas, relative to the number of active terminals. This technology is a main component of 5G New Radio (NR) and addresses all important requirements of future wireless standards: a great capacity increase, the support of many simultaneous users, and improvement in energy efficiency. Massive MIMO requires the simultaneous processing of signals from many antenna chains, and computational operations on large matrices. The complexity of the digital processing has been viewed as a fundamental obstacle to the feasibility of Massive MIMO in the past. Recent advances on system-algorithm-hardware co-design have led to extremely energy-efficient implementations. These exploit opportunities in deeply-scaled silicon technologies and perform partly distributed processing to cope with the bottlenecks encountered in the interconnection of many signals. For example, prototype ASIC implementations have demonstrated zero-forcing precoding in real time at a 55 mW power consumption (20 MHz bandwidth, 128 antennas, multiplexing of 8 terminals). Coarse and even error-prone digital processing in the antenna paths permits a reduction of consumption with a factor of 2 to 5. This article summarizes the fundamental technical contributions to efficient digital signal processing for Massive MIMO. The opportunities and constraints on operating on low-complexity RF and analog hardware chains are clarified. It illustrates how terminals can benefit from improved energy efficiency. The status of technology and real-life prototypes discussed. Open challenges and directions for future research are suggested.Comment: submitted to IEEE transactions on signal processin

    An airborne remote sensing system for urban air quality

    Get PDF
    Several NASA sponsored remote sensors and possible airborne platforms were evaluated. Outputs of dispersion models for SO2 and CO pollution in the Washington, D.C. area were used with ground station data to establish the expected performance and limitations of the remote sensors. Aircraft/sensor support requirements are discussed. A method of optimum flight plan determination was made. Cost trade offs were performed. Conclusions about the implementation of various instrument packages as parts of a comprehensive air quality monitoring system in Washington are presented

    Position location and data collection system and method Patent

    Get PDF
    Development of telemetry system for position location and data acquisitio

    Simulation and Optimization of Hybrid Diesel Power Generation System for GSM Base Station Site in Nigeria

    Get PDF
    The telecommunications industry requires efficient, reliable and cost-effective hybrid systems as alternatives to the power supplied by diesel generators. This investigation proposes a solar - photovoltaic (PV)/diesel hybrid power generation system suitable for Global System for Mobile communication (GSM) base station site. The study is based on simulation and optimization of a hybrid system for a GSM base station site located in Abuja (FCT), Nigeria with a daily load of 318 kWh d-1. Solar radiation for the design of the system was obtained from NASA surface Meteorology and solar energy website at a location of 9° 00’ N latitude and 7° 00’ E longitude, with annual average solar radiation of 5.45 kWh m-2d-1. Hybrid Optimization Model for Electrical Renewables (HOMER) software was used for the design of the proposed power system. The study evaluates savings associated with conversion of the diesel powered system to a PV/diesel hybrid power system. From the simulation results, the proposed system has total Net Present Cost (NPC) and amount of CO2 as (995,774;65.270tonnes),andsaves(995,774; 65.270 tonnes), and saves (716,397; 57.835 tonnes) when compared with the diesel only system ($1,712,171; 123.105 tonnes). A control system for the hybrid PV-diesel energy system with battery storage was developed to coordinate when power should be generated by PV panels and when it should be generated by diesel generator. This hybrid system could be applied in any other electrical system

    Spectrum Management: Property Rights, Markets, and The Commons

    Get PDF
    Gerald Faulhaber and David Farberconsider alternatives to the current licensing regime for spectrum, which appears to lead to substantial inefficiencies in spectrum allocation.Specifically, they examine two property rights regimes and a commons regime.Theynote that economists have favored a market-based regime while engineers have favored a commons-based regime to promote new technologies. Mr. Faulhaber and Mr. Farbershow that thereis aproperty rights market-based regime that unleashes the power of the market andthe power of the new technologies to efficiently allocate spectrum, and that is likely to meet our needs for the near-term future. This regime resolves the presumed dichotomy between the market-based and the commons-based views, so that both objectives can be realized.The authorsalso outline a transition processfor achieving the desired regime outcome that is a "win-win" for all stakeholders, and that could be politically feasible. The change to a property rights regime is likely to lower the cost of spectrum substantially, in many cases to zero.Mr. Faulhaber and Mr. Farberassert that a commons model and a market model can co-exist, at least until spectrum becomes truly scarce.

    Contemporary achievements in astronautics: Salyut-7, the Vega Project and Spacelab

    Get PDF
    The latest achievements in Soviet aeronautics are described; the new stage in the space program to study Venus using Soviet automated space probes, and the next space mission by cosmonauts to the Salyut-7 station. Information is also presented on the flight of the Spacelab orbiting laboratory created by Western European specialists

    Low energy indoor network : deployment optimisation

    Get PDF
    This article considers what the minimum energy indoor access point deployment is in order to achieve a certain downlink quality-of-service. The article investigates two conventional multiple-access technologies, namely: LTE-femtocells and 802.11n Wi-Fi. This is done in a dynamic multi-user and multi-cell interference network. Our baseline results are reinforced by novel theoretical expressions. Furthermore, the work underlines the importance of considering optimisation when accounting for the capacity saturation of realistic modulation and coding schemes. The results in this article show that optimising the location of access points both within a building and within the individual rooms is critical to minimise the energy consumption
    corecore