Label-controlled optical switching nodes

Optical networks are evolving from initially static optical circuits and subsequently optical circuit switching towards optical packet switching in order to take advan- tage of the high transport capacity made available by WDM systems in a more °exible and e±cient way. Optically labeling of packets and routing the packets's payload optically under control of its label allows the network nodes to route and forward IP data without having to process the payload, thus keeping it in the optical domain; this is a promising solution to avoid electronic bottlenecks in routers. All-optical label switching can therefore be used to route and forward packets independent of their length and payload bitrate. Several optical signal labeling techniques have been proposed in previous re- search reported in literature; orthogonal labeling and time-serial labeling have been studied in this thesis. This thesis studies two orthogonal modulation label- ing techniques: one based on FSK labels with an IM payload, and another one on SCM labeling for a DPSK modulated payload. A time-serial labeling method based on IM labels with IM or DPSK payload is also presented and studied. The ¯rst two techniques assume electronic processing of the labels in the node, and hence assume that labels can be transmitted at a much lower bitrate than the payload data rate. The third technique assumes all-optical signal processing in the nodes, capable of handling a label at the same bitrate or slightly lower than the payload data. Labels at low bitrate in comparison with the payload bitrate are desirable in systems where the label processing will be conducted in the electrical domain, while labels at the same bitrate as the payload can be used in systems where the processing is conducted in the optical domain, exploiting all-optical processing techniques. These three techniques have been chosen because they are compatible with the existing networks, since the modulation format, bitrates, transmission properties, and other features of the signals are similar to the ones used for commercially available applications. Thus, they can be considered important candidates for migration scenarios from optical circuit switching towards optical burst switching networking. Orthogonal labeling based on FSK/IM is a promising scheme for implementing the labeling of optical signals, and it is the technology of choice in the STOLAS project. This technique o®ers advantageous features such as a relaxed timing de- lineation between payload and label, and ease of label erasure and re-writing of new labels. By using wavelength-agile tunable laser sources with FSK modula- tion capability, wavelength converters, and passive wavelength routing elements, a scalable modular label-controlled router featuring high reliability can be built. In this thesis, several aspects of the physical parameters of an FSK/IM labeling scheme within a routing node have been studied and presented. Optical ¯ltering requires special care, since the combined FSK/IM scheme has a broader spectrum than that of pure intensity modulated signals. The requirements on the limited extinction ratio for the IM signal can be relaxed at low bitrates of the label signal or, alternatively, by introducing data encoding. Optical labeling by using FSK/IM represents a simple and attractive way of implementing hybrid optical circuit and burst switching in optical networks. Architecturally, similar advantages can be mentioned for the second orthogo- nal labeling technique studied in this thesis, based on SCM labels and a DPSK payload. In-band subcarriers carrying low bitrate labels located at a frequency equal to half the bitrate of the payload signal can be inserted introducing only low power penalties. Wavelength conversion can be implemented by using passive highly nonlinear ¯bers and exploiting the four-wave mixing e®ect. This thesis also studies the design of two functional blocks of an all-optical core node proposed in the LASAGNE project, namely the all-optical label and payload separator and the wavelength converter unit for a time-serial labeling scheme. The label and payload processor can be realized exploiting nonlinear e®ects in SOAs. An implementation using polarization division multiplexing to transport the external control light for an IM/IM time-serial scheme was demon- strated. Label and payload processors with self-contained control signals were also demonstrated, either using a DPSK signal to simultaneously transport the payload data and the control signal or inserting a CW dummy in between the label and the payload, which were based on IM-RZ format. A study on single- and multi- wavelength conversion based on FWM in a HNLF was presented. This approach allows transparent wavelength conversion (independent of the data format used) at high bitrates (the nonlinear e®ects in a ¯ber are obtained at ultrafast speeds). The labeling techniques explored have indicated a viable way of migration towards optical burst packet switched networks while signi¯cantly improving the throughput of the routing nodes

Performance of a SOA-MZI wavelength converter for label swapping using combined FSK/IM modulation format

This paper presents a theoretical and experimental assessment of the performance of a wavelength converter based on semiconductor optical amplifiers (SOA) in a MZI configuration for optical label swapping. The optical labeling of the signal is based on an FSK/IM combined modulation format for the header/payload, respectively. Experimental results are presented for a signaling scheme with payload data at 10 Gbit/s and an FSK label at 312 Mbit/s. Simulation results and measurements of the chirp properties of converted signals operating at data rates of 2.5 and 10 Gbit/s are presented. Conclusions and design guidelines are presented regarding the implications of the wavelength converter performance on the quality of the label and payload signals for fast packet/burst forwarding in optically labeled switched networks

Time-Frequency Quantum Key Distribution: Numerical Assessment and Implementation over a Free-Space Link

Die Quantenschlüsselverteilung (QKD), die erste anwendbare Quantentechnologie, verspricht informationstheoretisch sichere Kommunikation. In der vorliegenden Arbeit wurde das Zeit-Frequenz (TF)-QKD-Protokoll untersucht, das Zeit und Frequenz, nämlich Puls-Positionsmodulation (PPM) im Zeitbereich und Frequenzumtastung (FSK) im Frequenzbereich als die beiden komplementären Basen verwendet. Seine Sicherheit beruht den Quanteneigenschaften von Licht und auf der Zeit-Frequenz-Unschärferelation. TF-QKD kann mit größtenteils Standard-Telekommunikationstechnologie im 1550-nm-Band implementiert werden. Die PPM-Basis kann mit Modulatoren und die FSK-Basis mit Hilfe der Wellenlängenmultiplex-Technologie realisiert werden. Das TF-QKD-Protokoll ist in der Lage, ein beliebig großes Alphabet bereitzustellen, was mehr als 1 bit/Photon ermöglicht. Darüber hinaus ist es robust gegenüber athmosphärischen Störungen und somit für die Übertragung über den Freiraumkanal geeignet. In der vorliegenden Arbeit wird das TF-QKD-Protokoll theoretisch bewertet, mit Standardkomponenten für 1 bit/Photon implementiert und die Freiraumübertragung mit optischem Tracking über eine 388 m Teststrecke wird bei Tageslicht demonstriert. Unter Verwendung der vorhandenen Komponenten konnte eine sichere Schlüsselrate von 364 kbit/s back-to-back und 9 kbit/s über den Freiraumkanal demonstriert werden.Quantum key distribution (QKD), the first applicable quantum technology, promises information theoretically secure communication. In the presented work the time-frequency (TF)-QKD protocol was examined, which uses time and frequency, namely pulse position modulation (PPM) in the time domain and frequency shift keying (FSK) in the frequency domain as the two complementary bases. Its security relies on the quantum properties of light and the time-frequency uncertainty relation. TF-QKD can be implemented mostly with standard telecom-technology in the 1550 nm band. The PPM basis can be implemented with modulators and the FSK basis with help of wavelength-division multiplexing technology. The TF-QKD protocol is capable of providing an arbitrarily large alphabet enabling more than 1 bit/photon. Moreover, it is robust in the atmosphere making it suitable for transmission over the free-space channel. In the present work the TF-QKD protocol is assessed theoretically, implemented with off-the-shelf components for 1 bit/photon and free-space transmission with optical tracking over a 388 m testbed is demonstrated in daylight. Using components at hand, secret key rates of 364 kbit/s back-to-back and 9 kbit/s over the free-space channel could be demonstrated

Comparison of direct and heterodyne detection optical intersatellite communication links

The performance of direct and heterodyne detection optical intersatellite communication links are evaluated and compared. It is shown that the performance of optical links is very sensitive to the pointing and tracking errors at the transmitter and receiver. In the presence of random pointing and tracking errors, optimal antenna gains exist that will minimize the required transmitter power. In addition to limiting the antenna gains, random pointing and tracking errors also impose a power penalty in the link budget. This power penalty is between 1.6 to 3 dB for a direct detection QPPM link, and 3 to 5 dB for a heterodyne QFSK system. For the heterodyne systems, the carrier phase noise presents another major factor of performance degradation that must be considered. In contrast, the loss due to synchronization error is small. The link budgets for direct and heterodyne detection systems are evaluated. It is shown that, for systems with large pointing and tracking errors, the link budget is dominated by the spatial tracking error, and the direct detection system shows a superior performance because it is less sensitive to the spatial tracking error. On the other hand, for systems with small pointing and tracking jitters, the antenna gains are in general limited by the launch cost, and suboptimal antenna gains are often used in practice. In which case, the heterodyne system has a slightly higher power margin because of higher receiver sensitivity

Colorless FSK Demodulation and Detection With Integrated Fabry-Perot-Type SOA/REAM

A receiver for optical frequency modulated signals, based on colorless demodulation and detection, is presented. An integrated combination of semiconductor optical amplifier (SOA) and reflective electroabsorption modulator (REAM) is designed to obtain a comb-like spectral detection function, replacing the typically required costly frequency discrimination filter. The spectral properties of the designed SOA/REAM chip are discussed and the reception of a 10-Gb/s optical frequency modulated downstream signal is demonstrated, proving the applicability as receiving optical subsystem in the customer premises equipment of fiber-to-the-home access networks with wavelength reuse for upstream transmission and no downstream crosstalk.Peer ReviewedPostprint (published version