Low-Voltage Closed Loop MEMS Actuators

An efficient electrostatic resonator is designed by adding a low voltage controller to an electrostatic actuator. The closedloop actuator shows stable, and bi-sable behaviors with bounded chaotic oscillations as large as 117% of the capacitor gap. The controller voltage is decreased from a previously designed resonator to less than 9 V thereby reducing the load on the controller circuit components. Bifurcation diagrams are obtained showing the frequency and magnitude of AC voltage required for chaotic oscillations to develop. The information entropy, a measure of chaotic characteristic, is calculated for the micro-resonator and is found to be 0.732

Measurements, Models, Systems and Design

531 s.

On the predictability of time series by metric entropy

Thesis (Master)--Izmir Institute of Technology, Mechanical Engineering, Izmir, 2006Includes bibliographical references (leaves: 48-49)Text in English; Abstract: Turkish and Englishxi, 55 leavesThe computation of the metric entropy, a measure of the loss of information along the attractor, from experimental time series is the main objective of this study. In this study, replacing the current warning systems (simple threshold based, on/off circuits), a new and promising prognosis system is tried to be achieved by the metric entropy, i.e. Kolmogorov . Sinai entropy, from chaotic time series. Additional to metric entropy, correlation dimension and time series statistical parameters were investigated.Condition monitoring of ball bearings and drill bits was achieved in the light of practical considerations of time series applications. Two different accelerated bearing run-to-failure test rigs were constructed and the prediction tests were performed.However, as a reason of shaft failure in both structures during the experiments, none of them is completed. Finally, drill bit breakage experiments were carried out. In the experiments, 10 small drill bits (1 mm ) were tested until they broke down, while vibration data were consecutively taken in equal time intervals. After the analysis, a consistent decrement in variation of metric entropy just before the breakage was observed. As a result of the experiment results, metric entropy variation could be proposed as an early warning system

A Survey on Reservoir Computing and its Interdisciplinary Applications Beyond Traditional Machine Learning

Reservoir computing (RC), first applied to temporal signal processing, is a recurrent neural network in which neurons are randomly connected. Once initialized, the connection strengths remain unchanged. Such a simple structure turns RC into a non-linear dynamical system that maps low-dimensional inputs into a high-dimensional space. The model's rich dynamics, linear separability, and memory capacity then enable a simple linear readout to generate adequate responses for various applications. RC spans areas far beyond machine learning, since it has been shown that the complex dynamics can be realized in various physical hardware implementations and biological devices. This yields greater flexibility and shorter computation time. Moreover, the neuronal responses triggered by the model's dynamics shed light on understanding brain mechanisms that also exploit similar dynamical processes. While the literature on RC is vast and fragmented, here we conduct a unified review of RC's recent developments from machine learning to physics, biology, and neuroscience. We first review the early RC models, and then survey the state-of-the-art models and their applications. We further introduce studies on modeling the brain's mechanisms by RC. Finally, we offer new perspectives on RC development, including reservoir design, coding frameworks unification, physical RC implementations, and interaction between RC, cognitive neuroscience and evolution.Comment: 51 pages, 19 figures, IEEE Acces

MACHINE LEARNING AUGMENTATION MICRO-SENSORS FOR SMART DEVICE APPLICATIONS

Novel smart technologies such as wearable devices and unconventional robotics have been enabled by advancements in semiconductor technologies, which have miniaturized the sizes of transistors and sensors. These technologies promise great improvements to public health. However, current computational paradigms are ill-suited for use in novel smart technologies as they fail to meet their strict power and size requirements. In this dissertation, we present two bio-inspired colocalized sensing-and-computing schemes performed at the sensor level: continuous-time recurrent neural networks (CTRNNs) and reservoir computers (RCs). These schemes arise from the nonlinear dynamics of micro-electro-mechanical systems (MEMS), which facilitates computing, and the inherent ability of MEMS devices for sensing. Furthermore, this dissertation addresses the high-voltage requirements in electrostatically actuated MEMS devices using a passive amplification scheme. The CTRNN architecture is emulated using a network of bistable MEMS devices. This bistable behavior is shown in the pull-in, the snapthrough, and the feedback regimes, when excited around the electrical resonance frequency. In these regimes, MEMS devices exhibit key behaviors found in biological neuronal populations. When coupled, networks of MEMS are shown to be successful at classification and control tasks. Moreover, MEMS accelerometers are shown to be successful at acceleration waveform classification without the need for external processors. MEMS devices are additionally shown to perform computing by utilizing the RC architecture. Here, a delay-based RC scheme is studied, which uses one MEMS device to simulate the behavior of a large neural network through input modulation. We introduce a modulation scheme that enables colocalized sensing-and-computing by modulating the bias signal. The MEMS RC is tested to successfully perform pure computation and colocalized sensing-and-computing for both classification and regression tasks, even in noisy environments. Finally, we address the high-voltage requirements of electrostatically actuated MEMS devices by proposing a passive amplification scheme utilizing the mechanical and electrical resonances of MEMS devices simultaneously. Using this scheme, an order-of-magnitude of amplification is reported. Moreover, when only electrical resonance is used, we show that the MEMS device exhibits a computationally useful bistable response. Adviser: Dr. Fadi Alsalee

Engineering Education and Research Using MATLAB

MATLAB is a software package used primarily in the field of engineering for signal processing, numerical data analysis, modeling, programming, simulation, and computer graphic visualization. In the last few years, it has become widely accepted as an efficient tool, and, therefore, its use has significantly increased in scientific communities and academic institutions. This book consists of 20 chapters presenting research works using MATLAB tools. Chapters include techniques for programming and developing Graphical User Interfaces (GUIs), dynamic systems, electric machines, signal and image processing, power electronics, mixed signal circuits, genetic programming, digital watermarking, control systems, time-series regression modeling, and artificial neural networks