Investigation of wavelength tunable laser modules for use in future optically switched dense wavelength division multiplexed networks

This thesis investigates the use of fast wavelength tunable laser modules in future optically switched dense wavelength division multiplexed networks (DWDM). The worldwide demand for increasingly greater broadband access has thus far been satisfied by the use of DWDM networks, enabled by the development of the erbium doped amplifier. However as this demand continues to grow electronic switching at network nodes will become a limiting factor, creating a potential bandwidth mismatch between the fibre capacities and switching capacity. Optical switching has been proposed to overcome this electronic bottleneck and fully utilize the enormous bandwidth offered by fibre. Fast tunable lasers (TLs) are a key technology in this area, enabling fast wavelength switching. Experimental work involving the fast wavelength switching of sampled grating distributed Bragg reflector TL modules is presented. Spurious mode generation during wavelength tuning is shown to cause severe cross-channel interference on other data channels in a DWDM test bed. Bit error rate (BER) results demonstrate that a integrated semiconductor optical amplifier can greatly reduce system degradation caused by asynchronous switching of multiple TLs. This is achieved by optically blanking the laser output during channel transition for a period of 60 ns. Immediately after the blanking period a wavelength drift due to the TL module wavelength locking is found to cause cross channel interference and introduce an error floor >1 e-4 on the BER performance characteristic of an adjacent channel in a 12.5 GHz spaced DWDM network. This drift is characterised, using a selfheterodyne and a filter based approach – Error free performance is subsequently demonstrated by using an extended blanking period of 260 ns or by using subcarrier multiplexing transmission and phase selective demodulation before detection. A DWDM optical label switching system, utilizing 40 Gbit/s payload data with low data rate labels placed on a 40 GHz sub-carrier and using TL transmitters is presented. Channel performance is monitored on a static channel as a second data channel is tuned into an adjacent channel on a 100 GHz spaced grid. Error free performance is demonstrated only for the channel payload – Time resolved BER results in agreement with the TL wavelength drift are measured and demonstrate a detrimental influence of the drift on the sub-carrier label performance

WDM/TDM PON bidirectional networks single-fiber/wavelength RSOA-based ONUs layer 1/2 optimization

This Thesis proposes the design and the optimization of a hybrid WDM/TDM PON at the L1 (PHY) and L2 (MAC) layers, in terms of minimum deployment cost and enhanced performance for Greenfield NGPON. The particular case of RSOA-based ONUs and ODN using a single-fibre/single-wavelength is deeply analysed. In this WDM/TDM PON relevant parameters are optimized. Special attention has been given at the main noise impairment in this type of networks: the Rayleigh Backscattering effect, which cannot be prevented. To understand its behaviour and mitigate its effects, a novel mathematical model for the Rayleigh Backscattering in burst mode transmission is presented for the first time, and it has been used to optimize the WDM/TDM RSOA based PON. Also, a cost-effective, simple design SCM WDM/TDM PON with rSOA-based ONU, was optimized and implemented. This prototype was successfully tested showing high performance, robustness, versatility and reliability. So, the system is able to give coverage up to 1280 users at 2.5 Gb/s / 1.25 Gb/s downstream/upstream, over 20 Km, and being compatible with the GPON ITU-T recommendation. This precedent has enabled the SARDANA network to extend the design, architecture and capabilities of a WDM/TDM PON for a long reach metro-access network (100 km). A proposal for an agile Transmission Convergence sub-layer is presented as another relevant contribution of this work. It is based on the optimization of the standards GPON and XG-PON (for compatibility), but applied to a long reach metro-access TDM/WDM PON rSOA-based network with higher client count. Finally, a proposal of physical implementation for the SARDANA layer 2 and possible configurations for SARDANA internetworking, with the metro network and core transport network, are presented

Advances in Optical Amplifiers

Optical amplifiers play a central role in all categories of fibre communications systems and networks. By compensating for the losses exerted by the transmission medium and the components through which the signals pass, they reduce the need for expensive and slow optical-electrical-optical conversion. The photonic gain media, which are normally based on glass- or semiconductor-based waveguides, can amplify many high speed wavelength division multiplexed channels simultaneously. Recent research has also concentrated on wavelength conversion, switching, demultiplexing in the time domain and other enhanced functions. Advances in Optical Amplifiers presents up to date results on amplifier performance, along with explanations of their relevance, from leading researchers in the field. Its chapters cover amplifiers based on rare earth doped fibres and waveguides, stimulated Raman scattering, nonlinear parametric processes and semiconductor media. Wavelength conversion and other enhanced signal processing functions are also considered in depth. This book is targeted at research, development and design engineers from teams in manufacturing industry, academia and telecommunications service operators

Optimised Design and Analysis of All-Optical Networks

This PhD thesis presents a suite of methods for optimising design and for analysing blocking probabilities of all-optical networks. It thus contributes methodical knowledge to the field of computer assisted planning of optical networks. A two-stage greenfield optical network design optimiser is developed, based on shortest-path algorithms and a comparatively new metaheuristic called simulated allocation. It is able to handle design of all-optical mesh networks with optical cross-connects, considers duct as well as fibre and node costs, and can also design protected networks. The method is assessed through various experiments and is shown to produce good results and to be able to scale up to networks of realistic sizes. A novel method, subpath wavelength grouping, for routing connections in a multigranular all-optical network where several wavelengths can be grouped and switched at band and fibre level is presented. The method uses an unorthodox routing strategy focusing on common subpaths rather than individual connections, and strives to minimise switch port count as well as fibre usage. It is shown to produce cheaper network designs than previous methods when fibre costs are comparatively high. A new optical network concept, the synchronous optical hierarchy, is proposed, in which wavelengths are subdivided into timeslots to match the traffic granularity. Various theoretical properties of this concept are investigated and compared in simulation studies. An integer linear programming model for optical ring network design is presented. Manually designed real world ring networks are studied and it is found that the model can lead to cheaper network design. Moreover, ring and mesh network architectures are compared using real world costs, and it is found that optical cros..

Key Signal Processing Technologies for High-speed Passive Optical Networks

With emerging technologies such as high-definition video, virtual reality, and cloud computing, bandwidth demand in the access networks is ever-increasing. Passive optical network (PON) has become a promising architecture thanks to its low cost and easy management. IEEE and ITU-T standard organizations have been standardizing the next-generation PON, targeting on increasing the single-channel capacity from 10 Gb/s to 25, 50, and 100 Gb/s as the solution to address the dramatic increase of bandwidth demand. However, since the access network is extremely cost-sensitive, many research problems imposed in the physical layer of PON need to be addressed in a cost-efficient way, which is the primary focus of this thesis. Utilizing the low-cost 10G optics to build up high-speed PON systems is a promising approach, where signal processing techniques are key of importance. Two categories of signal processing techniques have been extensively investigated, namely optical signal processing (OSP) and digital signal processing (DSP). Dispersion-supported equalization (DSE) as a novel OSP scheme is proposed to achieve bit-rate enhancement from 10 Gb/s to 25 Gb/s based on 10G class of optics. Thanks to the bandwidth improved by DSE, the non-return-zero on-off keying which is the simplest modulation format is able to be adopted in the PON system without complex modulation or DSP. Meanwhile, OSP is also proposed to work together with DSP enabling 50G PON while simplifying the DSP complexity. Using both DSE and simple feed-forward equalizer is able to support 50 Gb/s PAM-4 transmission with 10G optics. For C-band 50 Gb/s transmission, injection locking techniques as another OSP approach is proposed to compress the directly modulated laser chirp and increase system bandwidth in the optical domain where a doubled capacity from 25 Gb/s to 50 Gb/s over 20 km fiber can be built on top of 10G optics. For DSP, we investigated the advantages of neural network (NN) on the mitigation of the time-varying nonlinear semiconductor optical amplifier pattern effect. In order to reduce the expense caused by the high computation complexity of NN, a pre- equalizer is introduced at the central office that allows cost sharing for all connected access users. In order to push the PON system line rate to 100 Gb/s, a joint nonlinear Tomlinson- Harashima precoding-Volterra algorithm is proposed to compensate for both linear and nonlinear distortions where 100 Gb/s PAM-4 transmission over 20 km fiber with 15 GHz system bandwidth can be achieved

Técnicas alternativas para amplificação de Raman em telecomunicações

Doutoramento em FísicaO presente trabalho centra-se no estudo dos amplificadores de Raman em fibra ótica e suas aplicações em sistemas modernos de comunicações óticas. Abordaram-se tópicos específicos como a simulação espacial do amplificador de Raman, a equalização e alargamento do ganho, o uso de abordagens híbridas de amplificação através da associação de amplificadores de Raman em fibra ótica com amplificadores de fibra dopada com Érbio (EDFA) e os efeitos transitórios no ganho dos amplificadores. As actividades realizadas basearam-se em modelos teóricos, sendo os resultados validados experimentalmente. De entre as contribuições mais importantes desta tese, destaca-se (i) o desenvolvimento de um simulador eficiente para amplificadores de Raman que suporta arquitecturas de bombeamento contraprogantes e bidirecionais num contexto com multiplexagem no comprimento de onda (WDM); (ii) a implementação de um algoritmo de alocação de sinais de bombeamento usando a combinação do algoritmo genético com o método de Nelder- Mead; (iii) a apreciação de soluções de amplificação híbridas por associação dos amplificadores de Raman com EDFA em cenários de redes óticas passivas, nomeadamente WDM/TDM-PON com extensão a região espectral C+L; e (iv) a avaliação e caracterização de fenómenos transitórios em amplificadores para tráfego em rajadas/pacotes óticos e consequente desenvolvimento de soluções de mitigação baseadas em técnicas de clamping ótico.The present work is based on Raman Fiber Amplifiers and their applications in modern fiber communication systems. Specific topics were approached, namely the spatial simulation of Raman fiber amplifiers, the gain enlargement and equalization the use of hybrid amplification approaches by association of Raman amplifiers with Erbium doped fiber amplifiers (EDFA) and the transient effect on optical amplifiers gain. The work is based on theoretical models, being the obtained results validated experimentally. Among the main contributions, we remark: (i) the development of an efficient simulator for Raman fiber amplifiers that supports backward and bidirectional pumping architectures in a wavelength division multiplexing (WDM) context; (ii) the implementation of an algorithm to obtain enlargement and equalization of gain by allocation of pumps based on the association of the genetic algorithm with the Nelder-Mead method; (iii) the assessment of hybrid amplification solutions using Raman amplifiers and EDFA in the context of passive optical networks, namely WDM/TDM-PON with extension the C+L spectral bands; (iv) the assessment and characterization of transient effects on optical amplifiers with bursty/packeted traffic and the development of mitigation solutions based on optical clamping