Reducing the impacts of intra-class spectral variability on the accuracy of soft classification and super-resolution mapping of shoreline

The main objective of this research is to assess the impact of intra-class spectral variation on the accuracy of soft classification and super-resolution mapping. The accuracy of both analyses was negatively related to the degree of intra-class spectral variation, but the effect could be reduced through use of spectral sub-classes. The latter is illustrated in mapping the shoreline at a sub-pixel scale from Landsat ETM+ data. Reducing the degree of intra-class spectral variation increased the accuracy of soft classification, with the correlation between predicted and actual class coverage rising from 0.87 to 0.94, and super-resolution mapping, with the RMSE in shoreline location decreasing from 41.13 m to 35.22 m

Semi-automated geomorphological mapping applied to landslide hazard analysis

Computer-assisted three-dimensional (3D) mapping using stereo and multi-image (“softcopy”) photogrammetry is shown to enhance the visual interpretation of geomorphology in steep terrain with the direct benefit of greater locational accuracy than traditional manual mapping. This would benefit multi-parameter correlations between terrain attributes and landslide distribution in both direct and indirect forms of landslide hazard assessment. Case studies involve synthetic models of a landslide, and field studies of a rock slope and steep undeveloped hillsides with both recently formed and partly degraded, old landslide scars. Diagnostic 3D morphology was generated semi-automatically both using a terrain-following cursor under stereo-viewing and from high resolution digital elevation models created using area-based image correlation, further processed with curvature algorithms. Laboratory-based studies quantify limitations of area-based image correlation for measurement of 3D points on planar surfaces with varying camera orientations. The accuracy of point measurement is shown to be non-linear with limiting conditions created by both narrow and wide camera angles and moderate obliquity of the target plane. Analysis of the results with the planar surface highlighted problems with the controlling parameters of the area-based image correlation process when used for generating DEMs from images obtained with a low-cost digital camera. Although the specific cause of the phase-wrapped image artefacts identified was not found, the procedure would form a suitable method for testing image correlation software, as these artefacts may not be obvious in DEMs of non-planar surfaces.Modelling of synthetic landslides shows that Fast Fourier Transforms are an efficient method for removing noise, as produced by errors in measurement of individual DEM points, enabling diagnostic morphological terrain elements to be extracted. Component landforms within landslides are complex entities and conversion of the automatically-defined morphology into geomorphology was only achieved with manual interpretation; however, this interpretation was facilitated by softcopy-driven stereo viewing of the morphological entities across the hillsides.In the final case study of a large landslide within a man-made slope, landslide displacements were measured using a photogrammetric model consisting of 79 images captured with a helicopter-borne, hand-held, small format digital camera. Displacement vectors and a thematic geomorphological map were superimposed over an animated, 3D photo-textured model to aid non-stereo visualisation and communication of results

Assessing a temporal change strategy for sub-pixel land cover change mapping from multi-scale remote sensing imagery

Remotely sensed imagery is an attractive source of information for mapping and monitoring land cover. Fine spatial resolution imagery is typically acquired infrequently, but fine temporal resolution systems commonly provide coarse spatial resolution imagery. Sub-pixel land cover change mapping is a method that aims to use the advantages of these multiple spatial and temporal resolution sensing systems. This method produces fine spatial and temporal resolution land cover maps, by updating fine spatial resolution land cover maps using coarse spatial resolution remote sensing imagery. A critical issue for sub-pixel land cover change mapping is downscaling coarse spatial resolution fraction maps estimated by soft classification to a fine spatial resolution land cover map. The relationship between a historic fine spatial resolution map and a contemporary fine spatial resolution map to be estimated at a more recent date plays an important role in the downscaling procedure. A change strategy based on the assumption that the change for each land cover class in a coarse spatial resolution pixel is unidirectional was shown to be a promising means to describe this relationship. This paper aims to assess this change strategy by analyzing the factors that affect the accuracy of the change strategy, using six subsets of the National Land Cover Database (NLCD) of USA. The results show that the spatial resolution of coarse pixels, the time interval of the previous fine resolution land cover map and the current coarse spatial resolution images, and the thematic resolution of the used land cover class scheme have considerable influence on the accuracy of the change strategy. The accuracy of the change strategy decreases with the coarsening of spatial resolution, an increase of time interval, and an increase of thematic resolution. The results also indicate that, when the historic land cover map has a 30 m resolution, like the NLCD, the average accuracy of the change strategy is still as high as 92% when the coarse spatial resolution data used had a resolution of ~1000 m, confirming the effectiveness of the change strategy used in sub-pixel land cover change mapping for use with popular remote sensing systems

Urban Image Classification: Per-Pixel Classifiers, Sub-Pixel Analysis, Object-Based Image Analysis, and Geospatial Methods

Remote sensing methods used to generate base maps to analyze the urban environment rely predominantly on digital sensor data from space-borne platforms. This is due in part from new sources of high spatial resolution data covering the globe, a variety of multispectral and multitemporal sources, sophisticated statistical and geospatial methods, and compatibility with GIS data sources and methods. The goal of this chapter is to review the four groups of classification methods for digital sensor data from space-borne platforms; per-pixel, sub-pixel, object-based (spatial-based), and geospatial methods. Per-pixel methods are widely used methods that classify pixels into distinct categories based solely on the spectral and ancillary information within that pixel. They are used for simple calculations of environmental indices (e.g., NDVI) to sophisticated expert systems to assign urban land covers. Researchers recognize however, that even with the smallest pixel size the spectral information within a pixel is really a combination of multiple urban surfaces. Sub-pixel classification methods therefore aim to statistically quantify the mixture of surfaces to improve overall classification accuracy. While within pixel variations exist, there is also significant evidence that groups of nearby pixels have similar spectral information and therefore belong to the same classification category. Object-oriented methods have emerged that group pixels prior to classification based on spectral similarity and spatial proximity. Classification accuracy using object-based methods show significant success and promise for numerous urban 3 applications. Like the object-oriented methods that recognize the importance of spatial proximity, geospatial methods for urban mapping also utilize neighboring pixels in the classification process. The primary difference though is that geostatistical methods (e.g., spatial autocorrelation methods) are utilized during both the pre- and post-classification steps. Within this chapter, each of the four approaches is described in terms of scale and accuracy classifying urban land use and urban land cover; and for its range of urban applications. We demonstrate the overview of four main classification groups in Figure 1 while Table 1 details the approaches with respect to classification requirements and procedures (e.g., reflectance conversion, steps before training sample selection, training samples, spatial approaches commonly used, classifiers, primary inputs for classification, output structures, number of output layers, and accuracy assessment). The chapter concludes with a brief summary of the methods reviewed and the challenges that remain in developing new classification methods for improving the efficiency and accuracy of mapping urban areas

Remote Sensing Methods and Applications for Detecting Change in Forest Ecosystems

Forest ecosystems are being altered by climate change, invasive species, and additional stressors. Our ability to detect these changes and quantify their impacts relies on detailed data across spatial and temporal scales. This dissertation expands the ecological utility of long-term satellite imagery by developing high quality forest mapping products and examining spatiotemporal changes in tree species abundance and phenology across the northeastern United States (US; the ‘Northeast’). Species/genus-level forest composition maps were developed by integrating field data and Landsat images to model abundance at a sub-pixel scale. These abundance maps were then used to 1) produce a more detailed, accurate forest classification compared to similar products and 2) construct a 30-year time-series of abundance for eight common species/genera. Analyzing the time-series data revealed significant abundance trends in notable species, including increases in American beech (Fagus grandifolia) at the expense of sugar maple (Acer saccharum). Climate was the dominant predictor of abundance trends, indicating climate change may be altering competitive relationships. Spatiotemporal trends in deciduous forest phenology – start and end of the growing season (SOS/EOS) – were examined based on MODIS imagery from 2001-2015. SOS exhibited a slight advancing trend across the Northeast, but with a distinct spatial pattern: eastern ecoregions showed advance and western ecoregions delay. EOS trended substantially later almost everywhere. SOS trends were linked to winter-spring temperature and precipitation trends; areas with higher elevation and fall precipitation anomalies had negative associations with EOS trends. Together, this work demonstrates the value of remote sensing in furthering our understanding of long-term forest responses to changing environmental conditions. By highlighting potential changes in forest composition and function, the research presented here can be used to develop forest conservation and management strategies in the Northeast

GIS-based urban land use characterization and population modeling with subpixel information measured from remote sensing data

This dissertation provides deeper understanding on the application of Vegetation-Impervious Surface-Soil (V-I-S) model in the urban land use characterization and population modeling, focusing on New Orleans area. Previous research on the V-I-S model used in urban land use classification emphasized on the accuracy improvement while ignoring the discussion of the stability of classifiers. I developed an evaluation framework by using randomization techniques and decision tree method to assess and compare the performance of classifiers and input features. The proposed evaluation framework is applied to demonstrate the superiority of V-I-S fractions and LST for urban land use classification. It could also be applied to the assessment of input features and classifiers for other remote sensing image classification context. An innovative urban land use classification based on the V-I-S model is implemented and tested in this dissertation. Due to the shape of the V-I-S bivariate histogram that resembles topological surfaces, a pattern that honors the Lu-Weng’s urban model, the V-I-S feature space is rasterized into grey-scale image and subsequently partitioned by marker-controlled watershed segmentation, leading to an urban land use classification. This new approach is proven to be insensitive to the selection of initial markers as long as they are positioned around the underlying watershed centers. This dissertation links the population distribution of New Orleans with its physiogeographic conditions indicated by the V-I-S sub-pixel composition and the land use information. It shows that the V-I-S fractions cannot be directly used to model the population distribution. Both the OLS and GWR models produced poor model fit. In contrast, the land use information extracted from the V-I-S information and LST significantly improved regression models. A three-class land use model is fitted adequately. The GWR model reveals the spatial nonstationarity as the relationship between the population distribution and the land use is relatively poor in the city center and becomes stronger towards the city fringe, depicting a classic urban concentric pattern. It highlighted that New Orleans is a complex metropolitan area, and its population distribution cannot be fully modeled with the physiogeographic measurements

Principles and methods of scaling geospatial Earth science data

The properties of geographical phenomena vary with changes in the scale of measurement. The information observed at one scale often cannot be directly used as information at another scale. Scaling addresses these changes in properties in relation to the scale of measurement, and plays an important role in Earth sciences by providing information at the scale of interest, which may be required for a range of applications, and may be useful for inferring geographical patterns and processes. This paper presents a review of geospatial scaling methods for Earth science data. Based on spatial properties, we propose a methodological framework for scaling addressing upscaling, downscaling and side-scaling. This framework combines scale-independent and scale-dependent properties of geographical variables. It allows treatment of the varying spatial heterogeneity of geographical phenomena, combines spatial autocorrelation and heterogeneity, addresses scale-independent and scale-dependent factors, explores changes in information, incorporates geospatial Earth surface processes and uncertainties, and identifies the optimal scale(s) of models. This study shows that the classification of scaling methods according to various heterogeneities has great potential utility as an underpinning conceptual basis for advances in many Earth science research domains. © 2019 Elsevier B.V

Generating a series of fine spatial and temporal resolution land cover maps by fusing coarse spatial resolution remotely sensed images and fine spatial resolution land cover maps

Studies of land cover dynamics would benefit greatly from the generation of land cover maps at both fine spatial and temporal resolutions. Fine spatial resolution images are usually acquired relatively infrequently, whereas coarse spatial resolution images may be acquired with a high repetition rate but may not capture the spatial detail of the land cover mosaic of the region of interest. Traditional image spatial–temporal fusion methods focus on the blending of pixel spectra reflectance values and do not directly provide land cover maps or information on land cover dynamics. In this research, a novel Spatial–Temporal remotely sensed Images and land cover Maps Fusion Model (STIMFM) is proposed to produce land cover maps at both fine spatial and temporal resolutions using a series of coarse spatial resolution images together with a few fine spatial resolution land cover maps that pre- and post-date the series of coarse spatial resolution images. STIMFM integrates both the spatial and temporal dependences of fine spatial resolution pixels and outputs a series of fine spatial–temporal resolution land cover maps instead of reflectance images, which can be used directly for studies of land cover dynamics. Here, three experiments based on simulated and real remotely sensed images were undertaken to evaluate the STIMFM for studies of land cover change. These experiments included comparative assessment of methods based on single-date image such as the super-resolution approaches (e.g., pixel swapping-based super-resolution mapping) and the state-of-the-art spatial–temporal fusion approach that used the Enhanced Spatial and Temporal Adaptive Reflectance Fusion Model (ESTARFM) and the Flexible Spatiotemporal DAta Fusion model (FSDAF) to predict the fine-resolution images, in which the maximum likelihood classifier and the automated land cover updating approach based on integrated change detection and classification method were then applied to generate the fine-resolution land cover maps. Results show that the methods based on single-date image failed to predict the pixels of changed and unchanged land cover with high accuracy. The land cover maps that were obtained by classification of the reflectance images outputted from ESTARFM and FSDAF contained substantial misclassification, and the classification accuracy was lower for pixels of changed land cover than for pixels of unchanged land cover. In addition, STIMFM predicted fine spatial–temporal resolution land cover maps from a series of Landsat images and a few Google Earth images, to which ESTARFM and FSDAF that require correlation in reflectance bands in coarse and fine images cannot be applied. Notably, STIMFM generated higher accuracy for pixels of both changed and unchanged land cover in comparison with other methods

General solution to reduce the point spread function effect in subpixel mapping

The point spread function (PSF) effect is ubiquitous in remote sensing images and imposes a fundamental uncertainty on subpixel mapping (SPM). The crucial PSF effect has been neglected in existing SPM methods. This paper proposes a general model to reduce the PSF effect in SPM. The model is applicable to any SPM methods treating spectral unmixing as pre-processing. To demonstrate the advantages of the new technique it was necessary to develop a new approach for accuracy assessment of SPM. To-date, accuracy assessment for SPM has been limited to subpixel classification accuracy, ignoring the performance of reproducing spatial structure in downscaling. In this paper, a new accuracy index is proposed which considers SPM performances in classification and restoration of spatial structure simultaneously. Experimental results show that by considering the PSF effect, more accurate SPM results were produced and small-sized patches and elongated features were restored more satisfactorily. Moreover, using the novel accuracy index, the quantitative evaluation was found to be more consistent with visual evaluation. This paper, thus, addresses directly two of the longest standing challenges in SPM (i.e., the limitations of the PSF effect and accuracy assessment undertaken only on a subpixel-by-subpixel basis). © 2020 Elsevier Inc