37 research outputs found
Proceedings of the Second International Mobile Satellite Conference (IMSC 1990)
Presented here are the proceedings of the Second International Mobile Satellite Conference (IMSC), held June 17-20, 1990 in Ottawa, Canada. Topics covered include future mobile satellite communications concepts, aeronautical applications, modulation and coding, propagation and experimental systems, mobile terminal equipment, network architecture and control, regulatory and policy considerations, vehicle antennas, and speech compression
Massive MIMO transmission techniques
Next generation of mobile communication systems must support astounding data traffic increases, higher data rates and lower latency, among other requirements. These requirements should be met while assuring energy efficiency for mobile devices and base stations.
Several technologies are being proposed for 5G, but a consensus begins to emerge. Most likely, the future core 5G technologies will include massive MIMO (Multiple Input Multiple Output) and beamforming schemes operating in the millimeter wave spectrum. As soon as the millimeter wave propagation difficulties are overcome, the full potential of massive MIMO structures can be tapped.
The present work proposes a new transmission system with bi-dimensional antenna arrays working at millimeter wave frequencies, where the multiple antenna configurations can be used to obtain very high gain and directive transmission in point to point communications. A combination of beamforming with a constellation shaping scheme is proposed, that enables good user isolation and protection against eavesdropping, while simultaneously assuring power efficient amplification of multi-level constellations
Proceedings of the Mobile Satellite Conference
A satellite-based mobile communications system provides voice and data communications to mobile users over a vast geographic area. The technical and service characteristics of mobile satellite systems (MSSs) are presented and form an in-depth view of the current MSS status at the system and subsystem levels. Major emphasis is placed on developments, current and future, in the following critical MSS technology areas: vehicle antennas, networking, modulation and coding, speech compression, channel characterization, space segment technology and MSS experiments. Also, the mobile satellite communications needs of government agencies are addressed, as is the MSS potential to fulfill them
Recommended from our members
Study of continuous-phase four-state modulation for cordless telecommunications. Assessment by simulation of CP-QFSK as an alternative modulation scheme for TDMA digital cordless telecommunications systems operating in indoor applications
One of the major driving elements behind the explosive boom in wireless revolution is the advances in the field of modulation which plays a fundamental role in any communication system, and especially in cellular radio systems. Hence, the elaborate choice of an efficient modulation scheme is of paramount importance in the design and employment of any communications system. Work presented in this thesis is an investigation (study) of the feasibility of whether multilevel FSK modulation scheme would provide a viable alternative modem that can be employed in TDMA cordless communications systems. In the thesis the design and performance analysis of a non-coherent multi-level modem that offers a great deal of bandwidth efficiency and hardware simplicity is studied in detail. Simulation results demonstrate that 2RC pre-modulation filter pulse shaping with a modulation index of 0.3, and pre-detection filter normalized equivalent noise bandwidth of 1.5 are optimum system parameter values. Results reported in chapter 5 signify that an adjacent channel rejection factor of around 40 dB has been achieved at channel spacing of 1.5 times the symbol rate while the DECT system standards stipulated a much lower rejection limit criterion (25-30dB), implying that CP-QFSK modulation out-performs the conventional GMSK as it causes significantly less ACI, thus it is more spectrally efficient in a multi-channel system. However, measured system performance in terms of BER indicates that this system does not coexist well with other interferers as at delay spreads between 100ns to 200ns, which are commonly encountered in such indoor environment, a severe degradation in system performance apparently caused by multi-path fading has been noticed, and there exists a noise floor of about 40 dB, i.e. high irreducible error rate of less than 5.10-3. Implementing MRC diversity combiner and BCH codec has brought in a good gain.Higher Education Ministr
Proceedings of the Fifth International Mobile Satellite Conference 1997
Satellite-based mobile communications systems provide voice and data communications to users over a vast geographic area. The users may communicate via mobile or hand-held terminals, which may also provide access to terrestrial communications services. While previous International Mobile Satellite Conferences have concentrated on technical advances and the increasing worldwide commercial activities, this conference focuses on the next generation of mobile satellite services. The approximately 80 papers included here cover sessions in the following areas: networking and protocols; code division multiple access technologies; demand, economics and technology issues; current and planned systems; propagation; terminal technology; modulation and coding advances; spacecraft technology; advanced systems; and applications and experiments
Recommended from our members
A combined PSK/ASK transmission system for commercial telephony via satellite
This study addresses three modulation schemes capable of increasing the voice channel capacity of the INTELSAT TDMA/DSI System operating with INTELSAT V spacecraft. In particular, a combination digital Amplitude-Shift Keying/Phase-Shifting Keying (APK) technique is evaluated with respect to signal design, thermal noise performance, bandwidths limitations, co-channel interference, adjacent channel interference, TWT distortion and modem complexity in an INTELSAT TDMA system environment. In a linear channel some APK signal designs are known to require significantly less average SNR than PSK to achieve the same probability of symbol error. However, when operated through a satellite channel containing at least one TWT, the reduction in average power required to accommodate amplitude variations causes APK performance to fall below that of PSK for the same alphabet size. Signal predistortion and/or TWT linearization can eliminate the effect of TWT distortion and restore the performance advantage, although the overall performance of APK is still inferior to PSK. However, in a heavily interference limited environment, such as INTELSAT V, the lower average power requirements caused an APK system to perform better, in some cases considerably better, than the corresponding PSK case.
Modem implementation considerations include how the signal set can be generated, the type and method of predistortion compensation, the detection method and the equipment required for the reconstruction of phase and amplitude references. The evaluation techniques of APK described include mathematical models, computer simulations (including the development of a unified error performance expression) and logical extrapolation from the QPSK case. Finally, a simple 8 level APK hardware modem was constructed and evaluated. It is concluded that an APK system may be of advantage as a retrofit in the INTELSAT TDMA system operating at 6/4 GHz, but be of significant advantage at 14/11 Ghz where the higher signal/noise ratios can yield an increase in capacity of up to 50 percent
Iterative decoding and detection for physical layer network coding
PhD ThesisWireless networks comprising multiple relays are very common and it is
important that all users are able to exchange messages via relays in the
shortest possible time. A promising technique to achieve this is physical
layer network coding (PNC), where the time taken to exchange messages
between users is achieved by exploiting the interference at the relay due
to the multiple incoming signals from the users. At the relay, the interference
is demapped to a binary sequence representing the exclusive-OR of
both users’ messages. The time to exchange messages is reduced because
the relay broadcasts the network coded message to both users, who can
then acquire the desired message by applying the exclusive-OR of their
original message with the network coded message. However, although
PNC can increase throughput it is at the expense of performance degradation
due to errors resulting from the demapping of the interference to
bits.
A number of papers in the literature have investigated PNC with an iterative
channel coding scheme in order to improve performance. However,
in this thesis the performance of PNC is investigated for end-to-end
(E2E) the three most common iterative coding schemes: turbo codes,
low-density parity-check (LDPC) codes and trellis bit-interleaved coded
modulation with iterative decoding (BICM-ID). It is well known that in
most scenarios turbo and LDPC codes perform similarly and can achieve
near-Shannon limit performance, whereas BICM-ID does not perform
quite as well but has a lower complexity. However, the results in this
thesis show that on a two-way relay channel (TWRC) employing PNC,
LDPC codes do not perform well and BICM-ID actually outperforms
them while also performing comparably with turbo codes. Also presented
in this thesis is an extrinsic information transfer (ExIT) chart
analysis of the iterative decoders for each coding scheme, which is used
to explain this surprising result. Another problem arising from the use
of PNC is the transfer of reliable information from the received signal at
the relay to the destination nodes. The demapping of the interference to
binary bits means that reliability information about the received signal
is lost and this results in a significant degradation in performance when
applying soft-decision decoding at the destination nodes. This thesis
proposes the use of traditional angle modulation (frequency modulation
(FM) and phase modulation (PM)) when broadcasting from the relay,
where the real and imaginary parts of the complex received symbols
at the relay modulate the frequency or phase of a carrier signal, while
maintaining a constant envelope. This is important since the complex
received values at the relay are more likely to be centred around zero and
it undesirable to transmit long sequences of low values due to potential
synchronisation problems at the destination nodes. Furthermore, the
complex received values, obtained after angle demodulation, are used to
derive more reliable log-likelihood ratios (LLRs) of the received symbols
at the destination nodes and consequently improve the performance of
the iterative decoders for each coding scheme compared with conventionally
coded PNC.
This thesis makes several important contributions: investigating the performance
of different iterative channel coding schemes combined with
PNC, presenting an analysis of the behaviour of different iterative decoding
algorithms when PNC is employed using ExIT charts, and proposing
the use of angle modulation at the relay to transfer reliable information
to the destination nodes to improve the performance of the iterative decoding
algorithms. The results from this thesis will also be useful for
future research projects in the areas of PNC that are currently being
addressed, such as synchronisation techniques and receiver design.Iraqi Ministry of Higher
Education and Scientific Research