Data Detection and Channel Estimation of OFDM Systems Using Differential Modulation

Orthogonal Frequency Division Multiplexing (OFDM) is a multicarrier modulation technique which is robust against multipath fading and very easy to implement in transmitters and receivers using the inverse fast Fourier transform and the fast Fourier transform. A guard interval using cyclic prefix is inserted in each OFDM symbol to avoid the inter-symbol interference. This guard interval should be at least equal to, or longer than the maximum delay spread of the channel to combat against inter-symbol interference properly. In coherent detection, channel estimation is required for the data detection of OFDM systems to equalize the channel effects. One of the popular techniques is to insert pilot tones (reference signals) in OFDM symbols. In conventional method, pilot tones are inserted into every OFDM symbols. Channel capacity is wasted due to the transmission of a large number of pilot tones. To overcome this transmission loss, incoherent data detection is introduced in OFDM systems, where it is not needed to estimate the channel at first. We use differential modulation based incoherent detection in this thesis for the data detection of OFDM systems. Data can be encoded in the relative phase of consecutive OFDM symbols (inter-frame modulation) or in the relative phase of an OFDM symbol in adjacent subcarriers (in-frame modulation). We use higher order differential modulation for in-frame modulation to compare the improvement of bit error rate. It should be noted that the single differential modulation scheme uses only one pilot tone, whereas the double differential uses two pilot tones and so on. Thus overhead due to the extra pilot tones in conventional methods are minimized and the detection delay is reduced. It has been observed that the single differential scheme works better in low SNRs (Signal to Noise Ratios) with low channel taps and the double differential works better at higher SNRs. Simulation results show that higher order differential modulation schemes don¡¯t have any further advantages. For inter-frame modulation, we use single differential modulation where only one OFDM symbol is used as a reference symbol. Except the reference symbol, no other overhead is required. We also perform channel estimation using differential modulation. Channel estimation using differential modulation is very easy and channel coefficients can be estimated very accurately without increasing any computational complexity. Our simulation results show that the mean square channel estimation error is about ¡¼10¡½^(-2) at an SNR of 30 dB for double differential in-frame modulation scheme, whereas channel estimation error is about ¡¼10¡½^(-4) for single differential inter-frame modulation. Incoherent data detection using classical DPSK (Differential Phase Shift Keying) causes an SNR loss of approximately 3 dB compared to coherent detection. But in our method, differential detection can estimate the channel coefficients very accurately and our estimated channel can be used in simple coherent detection to improve the system performance and minimize the SNR loss that happens in conventional method

Noise suppression using optimum filtering of OCs generated by a multiport encoder/decoder

We propose a novel receiver configuration using an extreme narrow band-optical band pass filter (ENB-OBPF) to reduce the multiple access interference (MAI) and beat noises in an optical code division multiplexing (OCDM) transmission. We numerically and experimentally demonstrate an enhancement of the code detectability, that allows us to increase the number of users in a passive optical network (PON) from 4 to 8 without any forward error correction (FEC)

Sparse Signal Processing Concepts for Efficient 5G System Design

As it becomes increasingly apparent that 4G will not be able to meet the emerging demands of future mobile communication systems, the question what could make up a 5G system, what are the crucial challenges and what are the key drivers is part of intensive, ongoing discussions. Partly due to the advent of compressive sensing, methods that can optimally exploit sparsity in signals have received tremendous attention in recent years. In this paper we will describe a variety of scenarios in which signal sparsity arises naturally in 5G wireless systems. Signal sparsity and the associated rich collection of tools and algorithms will thus be a viable source for innovation in 5G wireless system design. We will discribe applications of this sparse signal processing paradigm in MIMO random access, cloud radio access networks, compressive channel-source network coding, and embedded security. We will also emphasize important open problem that may arise in 5G system design, for which sparsity will potentially play a key role in their solution.Comment: 18 pages, 5 figures, accepted for publication in IEEE Acces

Recursive receivers for diversity channels with correlated flat fading

Copyright © 2003 IEEEThis paper addresses the design and performance of time-recursive receivers for diversity based communication systems with flat Rayleigh or Ricean fading. The paper introduces a general state-space model for such systems, where there is temporal correlation in the channel gain. Such an approach encompasses a wide range of diversity systems such as spatial diversity, frequency diversity, and code diversity systems which are used in practice. The paper describes a number of noncoherent receiver structures derived from both sequence and a posteriori probability-based cost functions and compares their performance using an orthogonal frequency-division multiplex example. In this example, the paper shows how a standard physical delay-Doppler scattering channel model can be approximated by the proposed state-space model. The simulations show that significant performance gains can be made by exploiting temporal, as well as diversity channel correlations. The paper argues that such time-recursive receivers offer some advantages over block processing schemes such as computational and memory requirement reductions and the easier incorporation of adaptivity in the receiver structures.Nguyen, V.K.; White, L.B.; Jaffrot, E.; Soamiadana, M.; Fijalkow, I

Building up low-complexity spectrally-efficient Terabit superchannels by receiver-side duobinary shaping

Recently, an increasing interest has been put on spectrally-efficient multi-carrier superchannels for beyond 100G. Apart from orthogonal frequency-division multiplexing (OFDM) and Nyquist wavelength-division multiplexing (WDM), another low-complexity WDM approach based on transmitter-side pre-filtering and receiver-side duobinary shaping is proposed to build up multi-carrier superchannels. This approach is referred to as receiver-side duobinary-shaped WDM (RS-DBS-WDM). Generation and transmission of a 1.232-Tbit/s 11-carrier superchannel is experimentally demonstrated. The superchannel signal can be well fit inside the passband of multiple 300-GHz reconfigurable optical add and drop multiplexers (ROADMs). In the superchannel scenario, the proposed RS-DBS-WDM is qualitatively compared with OFDM and Nyquist-WDM in terms of implementation complexity. In sum, the proposed RS-DBS-WDM approach features high transceiver analog-bandwidth efficiency, high spectral-efficiency, the absence of specific spectral manipulation, compatibility with conventional WDM technologies and coherent detection algorithms, and comparable implementation penalty

Underwater acoustic communications in warm shallow water channels

Ph.DDOCTOR OF PHILOSOPH

Space-time-frequency methods for interference-limited communication systems

textTraditionally, noise in communication systems has been modeled as an additive, white Gaussian noise process with independent, identically distributed samples. Although this model accurately reflects thermal noise present in communication system electronics, it fails to capture the statistics of interference and other sources of noise, e.g. in unlicensed communication bands. Modern communication system designers must take into account interference and non-Gaussian noise to maximize efficiencies and capacities of current and future communication networks. In this work, I develop new multi-dimensional signal processing methods to improve performance of communication systems in three applications areas: (i) underwater acoustic, (ii) powerline, and (iii) multi-antenna cellular. In underwater acoustic communications, I address impairments caused by strong, time-varying and Doppler-spread reverberations (self-interference) using adaptive space-time signal processing methods. I apply these methods to array receivers with a large number of elements. In powerline communications, I address impairments caused by non-Gaussian noise arising from devices sharing the powerline. I develop and apply a cyclic adaptive modulation and coding scheme and a factor-graph-based impulsive noise mitigation method to improve signal quality and boost link throughput and robustness. In cellular communications, I develop a low-latency, high-throughput space-time-frequency processing framework used for large scale (up to 128 antenna) MIMO. This framework is used in the world's first 100-antenna MIMO system and processes up to 492 Gbps raw baseband samples in the uplink and downlink directions. My methods prove that multi-dimensional processing methods can be applied to increase communication system performance without sacrificing real-time requirements.Electrical and Computer Engineerin