1,235 research outputs found
AirSync: Enabling Distributed Multiuser MIMO with Full Spatial Multiplexing
The enormous success of advanced wireless devices is pushing the demand for
higher wireless data rates. Denser spectrum reuse through the deployment of
more access points per square mile has the potential to successfully meet the
increasing demand for more bandwidth. In theory, the best approach to density
increase is via distributed multiuser MIMO, where several access points are
connected to a central server and operate as a large distributed multi-antenna
access point, ensuring that all transmitted signal power serves the purpose of
data transmission, rather than creating "interference." In practice, while
enterprise networks offer a natural setup in which distributed MIMO might be
possible, there are serious implementation difficulties, the primary one being
the need to eliminate phase and timing offsets between the jointly coordinated
access points.
In this paper we propose AirSync, a novel scheme which provides not only time
but also phase synchronization, thus enabling distributed MIMO with full
spatial multiplexing gains. AirSync locks the phase of all access points using
a common reference broadcasted over the air in conjunction with a Kalman filter
which closely tracks the phase drift. We have implemented AirSync as a digital
circuit in the FPGA of the WARP radio platform. Our experimental testbed,
comprised of two access points and two clients, shows that AirSync is able to
achieve phase synchronization within a few degrees, and allows the system to
nearly achieve the theoretical optimal multiplexing gain. We also discuss MAC
and higher layer aspects of a practical deployment. To the best of our
knowledge, AirSync offers the first ever realization of the full multiuser MIMO
gain, namely the ability to increase the number of wireless clients linearly
with the number of jointly coordinated access points, without reducing the per
client rate.Comment: Submitted to Transactions on Networkin
Simultaneous Transmission and Reception: Algorithm, Design and System Level Performance
Full Duplex or Simultaneous transmission and reception (STR) in the same
frequency at the same time can potentially double the physical layer capacity.
However, high power transmit signal will appear at receive chain as echoes with
powers much higher than the desired received signal. Therefore, in order to
achieve the potential gain, it is imperative to cancel these echoes. As these
high power echoes can saturate low noise amplifier (LNA) and also digital
domain echo cancellation requires unrealistically high resolution
analog-to-digital converter (ADC), the echoes should be cancelled or suppressed
sufficiently before LNA. In this paper we present a closed-loop echo
cancellation technique which can be implemented purely in analogue domain. The
advantages of our method are multiple-fold: it is robust to phase noise, does
not require additional set of antennas, can be applied to wideband signals and
the performance is irrelevant to radio frequency (RF) impairments in transmit
chain. Next, we study a few protocols for STR systems in carrier sense multiple
access (CSMA) network and investigate MAC level throughput with realistic
assumptions in both single cell and multiple cells. We show that STR can reduce
hidden node problem in CSMA network and produce gains of up to 279% in maximum
throughput in such networks. Finally, we investigate the application of STR in
cellular systems and study two new unique interferences introduced to the
system due to STR, namely BS-BS interference and UE-UE interference. We show
that these two new interferences will hugely degrade system performance if not
treated appropriately. We propose novel methods to reduce both interferences
and investigate the performances in system level.Comment: 20 pages. This manuscript will appear in the IEEE Transactions on
Wireless Communication
Design guidelines for spatial modulation
A new class of low-complexity, yet energyefficient Multiple-Input Multiple-Output (MIMO) transmission techniques, namely the family of Spatial Modulation (SM) aided MIMOs (SM-MIMO) has emerged. These systems are capable of exploiting the spatial dimensions (i.e. the antenna indices) as an additional dimension invoked for transmitting information, apart from the traditional Amplitude and Phase Modulation (APM). SM is capable of efficiently operating in diverse MIMO configurations in the context of future communication systems. It constitutes a promising transmission candidate for large-scale MIMO design and for the indoor optical wireless communication whilst relying on a single-Radio Frequency (RF) chain. Moreover, SM may also be viewed as an entirely new hybrid modulation scheme, which is still in its infancy. This paper aims for providing a general survey of the SM design framework as well as of its intrinsic limits. In particular, we focus our attention on the associated transceiver design, on spatial constellation optimization, on link adaptation techniques, on distributed/ cooperative protocol design issues, and on their meritorious variants
A control theoretic approach to achieve proportional fairness in 802.11e EDCA WLANs
This paper considers proportional fairness amongst ACs in an EDCA WLAN for
provision of distinct QoS requirements and priority parameters. A detailed
theoretical analysis is provided to derive the optimal station attempt
probability which leads to a proportional fair allocation of station
throughputs. The desirable fairness can be achieved using a centralised
adaptive control approach. This approach is based on multivariable statespace
control theory and uses the Linear Quadratic Integral (LQI) controller to
periodically update CWmin till the optimal fair point of operation. Performance
evaluation demonstrates that the control approach has high accuracy performance
and fast convergence speed for general network scenarios. To our knowledge this
might be the first time that a closed-loop control system is designed for EDCA
WLANs to achieve proportional fairness
Adaptive Bit Allocation With Reduced Feedback for Wireless Multicarrier Transceivers
With the increasing demand in the wireless mobile applications came a growing need to transmit information quickly and accurately, while consuming more and more bandwidth. To address this need, communication engineers started employing multicarrier modulation in their designs, which is suitable for high data rate transmission. Multicarrier modulation reduces the system's susceptibility to the frequency-selective fading channel, by transforming it into a collection of approximately flat subchannels. As a result, this makes it easier to compensate for the distortion introduced by the channel. This thesis concentrates on techniques for saving bandwidth usage when employing adaptive multicarrier modulation, where subcarrier parameters (bit and energy allocations) are modulated based on the channel state information feedback obtained from previous burst. Although bit and energy allocations can substantially increase error robustness and throughput of the system, the feedback information required at both ends of the transceiver can be large. The objective of this work is to compare different feedback compression techniques that could reduce the amount of feedback information required to perform adaptive bit and energy allocation in multicarrier transceivers. This thesis employs an approach for reducing the number of feedback transmissions by exploiting the time-correlation properties of a wireless channel and placing a threshold check on bit error rate (BER) values. Using quantization and source coding techniques, such as Huffman coding, Run length encoding and LZWalgorithms, the amount of feedback information has been compressed. These calculations have been done for different quantization levels to understand the relationship between quantization levels and system performance. These techniques have been applied to both OFDM and MIMO-OFDM systems
Measurement and Optimization of LTE Performance
4G Long Term Evolution (LTE) mobile system is the fourth generation communication system adopted worldwide to provide high-speed data connections and high-quality voice calls. Given the recent deployment by mobile service providers, unlike GSM and UMTS, LTE can be still considered to be in its early stages and therefore many topics still raise great interest among the international scientific research community: network performance assessment, network optimization, selective scheduling, interference management and coexistence with other communication systems in the unlicensed band, methods to evaluate human exposure to electromagnetic radiation are, as a matter of fact, still open issues.
In this work techniques adopted to increase LTE radio performances are investigated. One of the most wide-spread solutions proposed by the standard is to implement MIMO techniques and within a few years, to overcome the scarcity of spectrum, LTE network operators will offload data traffic by accessing the unlicensed 5 GHz frequency. Our Research deals with an evaluation of 3GPP standard in a real test best scenario to evaluate network behavior and performance
- …