Calibration and Evaluation of Fixed and Mobile Relay-Based System Level Simulator

Future wireless communication systems are expected to provide more stable and higher data rate transmissions in the whole OFDMA networks, but the mobile stations (MSs) in the cell boundary experience poor spectral efficiency due to the path loss from the transmitting antenna and interference from adjacent cells. Therefore, satisfying QoS (Quality of Service) requirements of each MS at the cell boundary has been an important issue. To resolve this spectral efficiency problem at the cell boundary, deploying relay stations has been actively considered. As multihop/relay has complex interactions between the routing and medium access control decisions, the extent to which analytical expressions can be used to explore its benefits is limited. Consequently, simulations tend to be the preferred way of assessing the performance of relays. In this paper, we evaluate the performance of relay-assisted OFDMA networks by means of system level simulator (SLS). We consistently observed that the throughput is increased and the outage is decreased in the relay-assisted OFDMA network, which is converted to range extension without any capacity penalty, for the realistic range of values of the propagation and other system parameters investigated

Development and implementation of an adaptive digital beamforming network for satellite communication systems

The use of adaptive digital beamforming techniques has, until recently, been largely restricted to high performance military radar systems. Recent advances in digital technology, however, have enabled the design of single chip digital beamforming networks. This, coupled with advances in digital signal processor technology, enables complete beamforming systems to be constructed at a lower cost, thus making the application of these techniques to commercial communications systems attractive. The design and development of such an adaptative digital beamforming network are described. The system is being developed as a proof of concept laboratory based demonstrator to enable the feasibility of adaptive digital beamforming techniques for communication systems to be determined. Ultimately, digital beamforming could be used in conjunction with large array antennas for communication satellite systems. This will enable the simultaneous steering of high gain antenna beams in the direction of gr...Peer ReviewedPostprint (published version

SDDV: scalable data dissemination in vehicular ad hoc networks

An important challenge in the domain of vehicular ad hoc networks (VANET) is the scalability of data dissemination. Under dense traffic conditions, the large number of communicating vehicles can easily result in a congested wireless channel. In that situation, delays and packet losses increase to a level where the VANET cannot be applied for road safety applications anymore. This paper introduces scalable data dissemination in vehicular ad hoc networks (SDDV), a holistic solution to this problem. It is composed of several techniques spread across the different layers of the protocol stack. Simulation results are presented that illustrate the severity of the scalability problem when applying common state-of-the-art techniques and parameters. Starting from such a baseline solution, optimization techniques are gradually added to SDDV until the scalability problem is entirely solved. Besides the performance evaluation based on simulations, the paper ends with an evaluation of the final SDDV configuration on real hardware. Experiments including 110 nodes are performed on the iMinds w-iLab.t wireless lab. The results of these experiments confirm the results obtained in the corresponding simulations

Practical design of optimal wireless metropolitan area networks: model and algorithms for OFDMA networks

A thesis submitted to the University of Bedfordshire, in partial fulfilment of the requirements for the degree of Ph.D.This thesis contributes to the study of the planning and optimisation of wireless metropolitan area networks, in particular to the access network design of OFDMAbased systems, where different parameters like base station position, antenna tilt and azimuth need to be configured during the early stages of the network life. A practical view for the solution of this problem is presented by means of the development of a novel design framework and the use of multicriteria optimisation. A further consideration of relaying and cooperative communications in the context of the design of this kind of networks is done, an area little researched. With the emergence of new technologies and services, it is very important to accurately identify the factors that affect the design of the wireless access network and define how to take them into account to achieve optimally performing and cost-efficient networks. The new features and flexibility of OFDMA networks seem particularly suited to the provision of different broadband services to metropolitan areas. However, until now, most existing efforts have been focused on the basic access capability networks. This thesis presents a way to deal with the trade-offs generated during the OFDMA access network design, and presents a service-oriented optimization framework that offers a new perspective for this process with consideration of the technical and economic factors. The introduction of relay stations in wireless metropolitan area networks will bring numerous advantages such as coverage extension and capacity enhancement due to the deployment of new cells and the reduction of distance between transmitter and receiver. However, the network designers will also face new challenges with the use of relay stations, since they involve a new source of interference and a complicated air interface; and this need to be carefully evaluated during the network design process. Contrary to the well known procedure of cellular network design over regular or hexagonal scenarios, the wireless network planning and optimization process aims to deal with the non-uniform characteristics of realistic scenarios, where the existence of hotspots, different channel characteristics for the users, or different service requirements will determine the final design of the wireless network. This thesis is structured in three main blocks covering important gaps in the existing literature in planning (efficient simulation) and optimisation. The formulation and ideas proposed in the former case can still be evaluated over regular scenarios, for the sake of simplicity, while the study of latter case needs to be done over specific scenarios that will be described when appropriate. Nevertheless, comments and conclusions are extrapolated to more general cases throughout this work. After an introduction and a description of the related work, this thesis first focuses on the study of models and algorithms for classical point-to-multipoint networks on Chapter 3, where the optimisation framework is proposed. Based on the framework, this work: - Identifies the technology-specific physical factors that affect most importantly the network system level simulation, planning and optimization process. - It demonstrates how to simplify the problem and translate it into a formal optimization routine with consideration of economic factors. - It provides the network provider, a detailed and clear description of different scenarios during the design process so that the most suitable solution can be found. Existing works on this area do not provide such a comprehensive framework. In Chapter 4: - The impact of the relay configuration on the network planning process is analysed. - A new simple and flexible scheme to integrate multihop communications in the Mobile WiMAX frame structure is proposed and evaluated. - Efficient capacity calculations that allow intensive system level simulations in a multihop environment are introduced. In Chapter 5: - An analysis of the optimisation procedure with the addition of relay stations and the derived higher complexity of the process is done. - A frequency plan procedure not found in the existing literature is proposed, which combines it with the use of the necessary frame fragmentation of in-band relay communications and cooperative procedures. - A novel joint two-step process for network planning and optimisation is proposed. Finally, conclusions and open issues are exposed

ADM : A Density And Priority Levels Aware Protocol For Broadcasting In Vehicular Ad-Hoc Networks

The broadcasting communication mode is widely used in Vehicular Ad~hoc Networks (VANETs). It is used for sending emergency messages, road-traffic information or to help routing protocols to determine routes. This communication mode is known to be hard to achieve efficiently since it depends on the network density. Indeed, broadcasting methods may cause network congestion if they are not well designed. This paper introduces a novel Autonomic Dissemination Method (ADM) which delivers messages in accordance with given message classes and network density levels. The proposed approach is based on two steps: an offline optimization process and an online adaptation to the network characteristics. ADM allows each node to dynamically adapt its broadcasting strategy not only with respect to the network density, but also according to the class of the message to send: emergency (high-priority), road-traffic (medium-priority) or either comfort message (low-priority). The ultimate goal of ADM is to make effective use of radio resources when there are many messages to send simultaneously. This approach increases the efficiency of the broadcast process in terms of message delivery ratio, latency and interferences reduction. The autonomic computing paradigm improves the robustness of protocols

Assessing 3GPP LTE-Advanced as IMT-Advanced Technology: The WINNER+ Evaluation Group Approach

[EN] This article describes the WINNER+ approach to performance evaluation of the 3GPP LTE-Advanced proposal as an IMT-Advanced technology candidate. The official registered WINNER+ Independent Evaluation Group evaluated this proposal against ITU-R requirements. The first part of the article gives an overview of the ITU-R evaluation process, criteria, and scenarios. The second part is focused on the working method of the evaluation group, emphasizing the simulator calibration approach. Finally, the article contains exemplary evaluation results based on analytical and simulation approaches. The obtained results allow WINNER+ to confirm that the 3GPP LTE Release 10 & Beyond (LTE-Advanced) proposal satisfies all the IMT-Advanced requirements, and thus qualifies as an IMT-advanced system.This work has been performed in the framework of the CELTIC project CP5-026 WINNER+. The authors would like to acknowledge the contributions of their colleagues in the WINNER+ consortium. The authors wish to thank colleagues from Ericsson, Per Skillermark and Johnan Nystrom, for their effort in leading the simulations part of the WINNER+ evaluation group. The work of David Martin-Sacristan was supported by an FPU grant of the Spanish Ministry of Education.Safjan, K.; D'amico, V.; Bültmann, D.; Martín-Sacristán, D.; Saadani, A.; Schöneich, H. (2011). Assessing 3GPP LTE-Advanced as IMT-Advanced Technology: The WINNER+ Evaluation Group Approach. IEEE Communications Magazine. 49(2):92-100. doi:10.1109/MCOM.2011.5706316S9210049

Resource-efficient strategies for mobile ad-hoc networking

The ubiquity and widespread availability of wireless mobile devices with ever increasing inter-connectivity (e. g. by means of Bluetooth, WiFi or UWB) have led to new and emerging next generation mobile communication paradigms, such as the Mobile Ad-hoc NETworks (MANETs). MANETs are differentiated from traditional mobile systems by their unique properties, e. g. unpredictable nodal location, unstable topology and multi-hop packet relay. The success of on-going research in communications involving MANETs has encouraged their applications in areas with stringent performance requirements such as the e-healthcare, e. g. to connect them with existing systems to deliver e-healthcare services anytime anywhere. However, given that the capacity of mobile devices is restricted by their resource constraints (e. g. computing power, energy supply and bandwidth), a fundamental challenge in MANETs is how to realize the crucial performance/Quality of Service (QoS) expectations of communications in a network of high dynamism without overusing the limited resources. A variety of networking technologies (e. g. routing, mobility estimation and connectivity prediction) have been developed to overcome the topological instability and unpredictability and to enable communications in MANETs with satisfactory performance or QoS. However, these technologies often feature a high consumption of power and/or bandwidth, which makes them unsuitable for resource constrained handheld or embedded mobile devices. In particular, existing strategies of routing and mobility characterization are shown to achieve fairly good performance but at the expense of excessive traffic overhead or energy consumption. For instance, existing hybrid routing protocols in dense MANETs are based in two-dimensional organizations that produce heavy proactive traffic. In sparse MANETs, existing packet delivery strategy often replicates too many copies of a packet for a QoS target. In addition, existing tools for measuring nodal mobility are based on either the GPS or GPS-free positioning systems, which incur intensive communications/computations that are costly for battery-powered terminals. There is a need to develop economical networking strategies (in terms of resource utilization) in delivering the desired performance/soft QoS targets. The main goal of this project is to develop new networking strategies (in particular, for routing and mobility characterization) that are efficient in terms of resource consumptions while being effective in realizing performance expectations for communication services (e. g. in the scenario of e-healthcare emergency) with critical QoS requirements in resource-constrained MANETs. The main contributions of the thesis are threefold: (1) In order to tackle the inefficient bandwidth utilization of hybrid service/routing discovery in dense MANETs, a novel "track-based" scheme is developed. The scheme deploys a one-dimensional track-like structure for hybrid routing and service discovery. In comparison with existing hybrid routing/service discovery protocols that are based on two-dimensional structures, the track-based scheme is more efficient in terms of traffic overhead (e. g. about 60% less in low mobility scenarios as shown in Fig. 3.4). Due to the way "provocative tracks" are established, the scheme has also the capability to adapt to the network traffic and mobility for a better performance. (2) To minimize the resource utilization of packet delivery in sparse MANETs where wireless links are intermittently connected, a store-and-forward based scheme, "adaptive multicopy routing", was developed for packet delivery in sparse mobile ad-hoc networks. Instead of relying on the source to control the delivery overhead as in the conventional multi-copy protocols, the scheme allows each intermediate node to independently decide whether to forward a packet according to the soft QoS target and local network conditions. Therefore, the scheme can adapt to varying networking situations that cannot be anticipated in conventional source-defined strategies and deliver packets for a specific QoS targets using minimum traffic overhead. ii (3) The important issue of mobility measurement that imposes heavy communication/computation burdens on a mobile is addressed with a set of resource-efficient "GPS-free" soluti ons, which provide mobility characterization with minimal resource utilization for ranging and signalling by making use of the information of the time-varying ranges between neighbouring mobile nodes (or groups of mobile nodes). The range-based solutions for mobility characterization consist of a new mobility metric for network-wide performance measurement, two velocity estimators for approximating the inter-node relative speeds, and a new scheme for characterizing the nodal mobility. The new metric and its variants are capable of capturing the mobility of a network as well as predicting the performance. The velocity estimators are used to measure the speed and orientation of a mobile relative to its neighbours, given the presence of a departing node. Based on the velocity estimators, the new scheme for mobility characterization is capable of characterizing the mobility of a node that are associated with topological stability, i. e. the node's speeds, orientations relative to its neighbouring nodes and its past epoch time. iiiBIOPATTERN EU Network of Excellence (EU Contract 508803

Mission Information and Test Systems Summary of Accomplishments, 2011

This annual report covers the activities of the NASA DRFC Mission Information and Test Systems, which includes the Western Aeronautical Test Range, the Simulation Engineering Branch, the Information Services and the Dryden Technical Laboratory (Flight Loads Lab). This report contains highlights, current projects and various awards achieved during in 201