Indoor wireless communications and applications

Chapter 3 addresses challenges in radio link and system design in indoor scenarios. Given the fact that most human activities take place in indoor environments, the need for supporting ubiquitous indoor data connectivity and location/tracking service becomes even more important than in the previous decades. Specific technical challenges addressed in this section are(i), modelling complex indoor radio channels for effective antenna deployment, (ii), potential of millimeter-wave (mm-wave) radios for supporting higher data rates, and (iii), feasible indoor localisation and tracking techniques, which are summarised in three dedicated sections of this chapter

Effects of 3D Deployments on Interference and SINR in 5G New Radio Systems

Lately, the extremely high frequency (EHF) band has become one of the factors enabling fifth-generation (5G) mobile cellular technologies. By offering large bandwidth, New Radio (NR) systems operating in the lower part of EHF band, called millimeter waves (mmWave), may satisfy the extreme requirements of future 5G networks in terms of both data transfer rate and latency at the air interface. The use of highly directional antennas in prospective mmWave-based NR communications systems raises an important question: are conventional two-dimensional (2D) cellular network modeling techniques suitable for 5G NR systems? To address this question, we introduced a novel, three-dimensional framework for evaluating the performance of emerging mmWave band wireless networks. The proposed framework explicitly takes into account the blockage effects of propagating mmWave radiation, the vertical and planar directivities at transceiver antennas, and the randomness of user equipment (UE), base station (BS), and blocker heights. The model allows for different levels of accuracy, encompassing a number of models with different levels of computational complexity as special cases. Although the main metric of interest in this thesis is the signal-to-interference-plus-noise ratio (SINR), the model can be extended to obtain the Shannon rate of the channel under investigation. The proposed model was numerically evaluated in different deployment cases and communication scenarios with a wide range of system parameters. We found that randomness of UE and BS heights and vertical directionality of the mmWave antennas are essential for accurate evaluation of system performance. We also showed that the results of traditional 2D models are too optimistic and greatly overestimate the actual SINR. In contrast, fixed-height models that ignore the impact of height on the probability of exposure to interference are too pessimistic. Furthermore, we evaluated the models that provide the best trade-off between computational complexity and accuracy in specific scenarios and provided recommendations regarding their use for practical assessment of mmWave-based NR systems

Cooperative Radio Communications for Green Smart Environments

The demand for mobile connectivity is continuously increasing, and by 2020 Mobile and Wireless Communications will serve not only very dense populations of mobile phones and nomadic computers, but also the expected multiplicity of devices and sensors located in machines, vehicles, health systems and city infrastructures. Future Mobile Networks are then faced with many new scenarios and use cases, which will load the networks with different data traffic patterns, in new or shared spectrum bands, creating new specific requirements. This book addresses both the techniques to model, analyse and optimise the radio links and transmission systems in such scenarios, together with the most advanced radio access, resource management and mobile networking technologies. This text summarises the work performed by more than 500 researchers from more than 120 institutions in Europe, America and Asia, from both academia and industries, within the framework of the COST IC1004 Action on "Cooperative Radio Communications for Green and Smart Environments". The book will have appeal to graduates and researchers in the Radio Communications area, and also to engineers working in the Wireless industry. Topics discussed in this book include: • Radio waves propagation phenomena in diverse urban, indoor, vehicular and body environments• Measurements, characterization, and modelling of radio channels beyond 4G networks• Key issues in Vehicle (V2X) communication• Wireless Body Area Networks, including specific Radio Channel Models for WBANs• Energy efficiency and resource management enhancements in Radio Access Networks• Definitions and models for the virtualised and cloud RAN architectures• Advances on feasible indoor localization and tracking techniques• Recent findings and innovations in antenna systems for communications• Physical Layer Network Coding for next generation wireless systems• Methods and techniques for MIMO Over the Air (OTA) testin

Topology Control, Scheduling, and Spectrum Sensing in 5G Networks

The proliferation of intelligent wireless devices is remarkable. To address phenomenal traffic growth, a key objective of next-generation wireless networks such as 5G is to provide significantly larger bandwidth. To this end, the millimeter wave (mmWave) band (20 GHz -300 GHz) has been identified as a promising candidate for 5G and WiFi networks to support user data rates of multi-gigabits per second. However, path loss at mmWave is significantly higher than today\u27s cellular bands. Fortunately, this higher path loss can be compensated through the antenna beamforming technique-a transmitter focuses a signal towards a specific direction to achieve high signal gain at the receiver. In the beamforming mmWave network, two fundamental challenges are network topology control and user association and scheduling. This dissertation proposes solutions to address these two challenges. We also study a spectrum sensing scheme which is important for spectrum sharing in next-generation wireless networks. Due to beamforming, the network topology control in mmWave networks, i.e., how to determine the number of beams for each base station and the beam coverage, is a great challenge. We present a novel framework to solve this problem, termed Beamforming Oriented tOpology coNtrol (BOON). The objective is to reduce total downlink transmit power of base stations in order to provide coverage of all users with a minimum quality of service. BOON smartly groups nearby user equipment into clusters to dramatically reduce interference between beams and base stations so that we can significantly reduce transmit power from the base station. We have found that on average BOON uses only 10%, 32%, and 25% transmit power of three state-of-the-art schemes in the literature. Another fundamental problem in the mmWave network is the user association and traffic scheduling, i.e., associating users to base stations, and scheduling transmission of user traffic over time slots. This is because base station has a limited power budget and users have very diverse traffic, and also require some minimum quality of service. User association is challenging because it generally does not rely on the user distance to surrounding base stations but depends on if a user is covered by a beam. We develop a novel framework for user association and scheduling in multi-base station mmWave networks, termed the clustering Based dOwnlink user assOciation Scheduling, beamforming with power allocaTion (BOOST). The objective is to reduce the downlink network transmission time of all users\u27 traffic. On average, BOOST reduces the transmission time by 37%, 30%, and 26% compared with the three state-of-the-art user scheduling schemes in the literature. At last, we present a wavelet transform based spectrum sensing scheme that can simultaneously sense multiple subbands, even without knowing how the subbands are divided, i.e., their boundaries. It can adaptively detect all active subband signals and, thus, discover the residual spectrum that can be used by unlicensed devices

Cooperative Radio Communications for Green Smart Environments

The demand for mobile connectivity is continuously increasing, and by 2020 Mobile and Wireless Communications will serve not only very dense populations of mobile phones and nomadic computers, but also the expected multiplicity of devices and sensors located in machines, vehicles, health systems and city infrastructures. Future Mobile Networks are then faced with many new scenarios and use cases, which will load the networks with different data traffic patterns, in new or shared spectrum bands, creating new specific requirements. This book addresses both the techniques to model, analyse and optimise the radio links and transmission systems in such scenarios, together with the most advanced radio access, resource management and mobile networking technologies. This text summarises the work performed by more than 500 researchers from more than 120 institutions in Europe, America and Asia, from both academia and industries, within the framework of the COST IC1004 Action on "Cooperative Radio Communications for Green and Smart Environments". The book will have appeal to graduates and researchers in the Radio Communications area, and also to engineers working in the Wireless industry. Topics discussed in this book include: • Radio waves propagation phenomena in diverse urban, indoor, vehicular and body environments• Measurements, characterization, and modelling of radio channels beyond 4G networks• Key issues in Vehicle (V2X) communication• Wireless Body Area Networks, including specific Radio Channel Models for WBANs• Energy efficiency and resource management enhancements in Radio Access Networks• Definitions and models for the virtualised and cloud RAN architectures• Advances on feasible indoor localization and tracking techniques• Recent findings and innovations in antenna systems for communications• Physical Layer Network Coding for next generation wireless systems• Methods and techniques for MIMO Over the Air (OTA) testin

Improving next-generation wireless network performance and reliability with deep learning

A rudimentary question whether machine learning in general, or deep learning in particular, could add to the well-established field of wireless communications, which has been evolving for close to a century, is often raised. While the use of deep learning based methods is likely to help build intelligent wireless solutions, this use becomes particularly challenging for the lower layers in the wireless communication stack. The introduction of the fifth generation of wireless communications (5G) has triggered the demand for “network intelligence” to support its promises for very high data rates and extremely low latency. Consequently, 5G wireless operators are faced with the challenges of network complexity, diversification of services, and personalized user experience. Industry standards have created enablers (such as the network data analytics function), but these enablers focus on post-mortem analysis at higher stack layers and have a periodicity in the time scale of seconds (or larger). The goal of this dissertation is to show a solution for these challenges and how a data-driven approach using deep learning could add to the field of wireless communications. In particular, I propose intelligent predictive and prescriptive abilities to boost reliability and eliminate performance bottlenecks in 5G cellular networks and beyond, show contributions that justify the value of deep learning in wireless communications across several different layers, and offer in-depth analysis and comparisons with baselines and industry standards. First, to improve multi-antenna network reliability against wireless impairments with power control and interference coordination for both packetized voice and beamformed data bearers, I propose the use of a joint beamforming, power control, and interference coordination algorithm based on deep reinforcement learning. This algorithm uses a string of bits and logic operations to enable simultaneous actions to be performed by the reinforcement learning agent. Consequently, a joint reward function is also proposed. I compare the performance of my proposed algorithm with the brute force approach and show that similar performance is achievable but with faster run-time as the number of transmit antennas increases. Second, in enhancing the performance of coordinated multipoint, I propose the use of deep learning binary classification to learn a surrogate function to trigger a second transmission stream instead of depending on the popular signal to interference plus noise measurement quantity. This surrogate function improves the users' sum-rate through focusing on pre-logarithmic terms in the sum-rate formula, which have larger impact on this rate. Third, performance of band switching can be improved without the need for a full channel estimation. My proposal of using deep learning to classify the quality of two frequency bands prior to granting the band switching leads to a significant improvement in users' throughput. This is due to the elimination of the industry standard measurement gap requirement—a period of silence where no data is sent to the users so they could measure the frequency bands before switching. In this dissertation, a group of algorithms for wireless network performance and reliability for downlink are proposed. My results show that the introduction of user coordinates enhance the accuracy of the predictions made with deep learning. Also, the choice of signal to interference plus noise ratio as the optimization objective may not always be the best choice to improve user throughput rates. Further, exploiting the spatial correlation of channels in different frequency bands can improve certain network procedures without the need for perfect knowledge of the per-band channel state information. Hence, an understanding of these results help develop novel solutions to enhancing these wireless networks at a much smaller time scale compared to the industry standards todayElectrical and Computer Engineerin