Two-layer LMDS system architecture: DAVIC-based approach and analysis

Despite the growing interest for LMDS systems there have been only a few commercial implementations until now especially outside of the U.S.A. The use of hierarchical structure through two-layer networking has been even rarer. In many cases LMDS systems have strong advantages against their competitors to cover the last mile. In this article, we review and analyze the standards currently available and describe the European two-layer trial system developed in 1996-2000. We show why further development towards IP based LMDS is useful in the future. Most of our recommendations are based on results derived from the European Union supported research project CABSINET. It had the aim of demonstrating the viability of a 40 GHz cellular digital television system with a return channel to offer interactive services. Two systems were tested: a line of sight link using QPSK, and a non-line of sight with COFDM modulation scheme. In the RF-subsystems, the greatest difficulty of any viable LMDS system is to obtain a moderately low price for the user receiver, while fulfilling the hard OFDM requirements in terms of phase noise, stability and spectrum restrictions. Several options have been studied in order to design the subsystems with the smallest cost. This paper will present the architectures of the transmitters, nomadic terminals, and the design of the IF/RF subsystems for both types of modulations. The discussion is focused on system engineering and selections required in order to build a full two-layer LMDS system.This work has been supported in part by European Commission through the ACTS programme (CABSINET project). PM is in part supported by the Academy of Finland (grant 50624). Authors wish to thank the CABSINET research consortium for enjoyable collaboration and useful suggestions

Performance Comparison of Dual Connectivity and Hard Handover for LTE-5G Tight Integration in mmWave Cellular Networks

MmWave communications are expected to play a major role in the Fifth generation of mobile networks. They offer a potential multi-gigabit throughput and an ultra-low radio latency, but at the same time suffer from high isotropic pathloss, and a coverage area much smaller than the one of LTE macrocells. In order to address these issues, highly directional beamforming and a very high-density deployment of mmWave base stations were proposed. This Thesis aims to improve the reliability and performance of the 5G network by studying its tight and seamless integration with the current LTE cellular network. In particular, the LTE base stations can provide a coverage layer for 5G mobile terminals, because they operate on microWave frequencies, which are less sensitive to blockage and have a lower pathloss. This document is a copy of the Master's Thesis carried out by Mr. Michele Polese under the supervision of Dr. Marco Mezzavilla and Prof. Michele Zorzi. It will propose an LTE-5G tight integration architecture, based on mobile terminals' dual connectivity to LTE and 5G radio access networks, and will evaluate which are the new network procedures that will be needed to support it. Moreover, this new architecture will be implemented in the ns-3 simulator, and a thorough simulation campaign will be conducted in order to evaluate its performance, with respect to the baseline of handover between LTE and 5G.Comment: Master's Thesis carried out by Mr. Michele Polese under the supervision of Dr. Marco Mezzavilla and Prof. Michele Zorz

Broadband business and residential radio access

This paper discusses some of the issues associated with broadband wireless access particularly directed at the non Line-of-Sight (nLoS) paths necessary for large scale deployment of Point to Multipoint networks. The paper discusses the modulation choices that can be made and how they affect the deployability of the systems. The au-thor recommends the use of Orthogonal Frequency Divi-sion Multiplex (OFDM). Proprietary and competing sys-tems have held back the promise of wireless access sys-tems, as they become more complex providing greater bandwidths and services, success will only be achieved by standardisation.

The history of WiMAX: a complete survey of the evolution in certification and standarization for IEEE 802.16 and WiMAX

Most researchers are familiar with the technical features of WiMAX technology but the evolution that WiMAX went through, in terms of standardization and certification, is missing and unknown to most people. Knowledge of this historical process would however aid to understand how WiMAX has become the widespread technology that it is today. Furthermore, it would give insight in the steps to undertake for anyone aiming at introducing a new wireless technology on a worldwide scale. Therefore, this article presents a survey on all relevant activities that took place within three important organizations: the 802.16 Working Group of the IEEE (Institute of Electrical and Electronics Engineers) for technology development and standardization, the WiMAX Forum for product certification and the ITU (International Telecommunication Union) for international recognition. An elaborated and comprehensive overview of all those activities is given, which reveals the importance of the willingness to innovate and to continuously incorporate new ideas in the IEEE standardization process and the importance of the WiMAX Forum certification label granting process to ensure interoperability. We also emphasize the steps that were taken in cooperating with the ITU to improve the international esteem of the technology. Finally, a WiMAX trend analysis is made. We showed how industry interest has fluctuated over time and quantified the evolution in WiMAX product certification and deployments. It is shown that most interest went to the 2.5 GHz and 3.5GHz frequencies, that most deployments are in geographic regions with a lot of developing countries and that the highest people coverage is achieved in Asia Pacific. This elaborated description of all standardization and certification activities, from the very start up to now, will make the reader comprehend how past and future steps are taken in the development process of new WiMAX features

Millimetre wave frequency band as a candidate spectrum for 5G network architecture : a survey

In order to meet the huge growth in global mobile data traffic in 2020 and beyond, the development of the 5th Generation (5G) system is required as the current 4G system is expected to fall short of the provision needed for such growth. 5G is anticipated to use a higher carrier frequency in the millimetre wave (mm-wave) band, within the 20 to 90 GHz, due to the availability of a vast amount of unexploited bandwidth. It is a revolutionary step to use these bands because of their different propagation characteristics, severe atmospheric attenuation, and hardware constraints. In this paper, we carry out a survey of 5G research contributions and proposed design architectures based on mm-wave communications. We present and discuss the use of mm-wave as indoor and outdoor mobile access, as a wireless backhaul solution, and as a key enabler for higher order sectorisation. Wireless standards such as IEE802.11ad, which are operating in mm-wave band have been presented. These standards have been designed for short range, ultra high data throughput systems in the 60 GHz band. Furthermore, this survey provides new insights regarding relevant and open issues in adopting mm-wave for 5G networks. This includes increased handoff rate and interference in Ultra-Dense Network (UDN), waveform consideration with higher spectral efficiency, and supporting spatial multiplexing in mm-wave line of sight. This survey also introduces a distributed base station architecture in mm-wave as an approach to address increased handoff rate in UDN, and to provide an alternative way for network densification in a time and cost effective manner

Soluções de broadcast para redes 4G

Mestrado em Engenharia Electrónica e de TelecomunicaçõesA primeira difusão de conteúdos video e audio teve um forte impacto no quotidiano da população que assistiu a uma revolução nos modelos de transmissão de informação e de entretenimento. A evolução desde então foi significativa, e já na era digital, encontramo-nos face a uma nova sub-elevação da metodologia e do conceito subjacentes à transmissão de conteudos multimédia. O mundo actual apresenta, contudo, diferentes requisitos, de entre os quais se destacam a procura pela alta definição e mobilidade. A mobilidade tem sido um particular foco de atenção por parte dos operadores que exploram agora modelos para entregar uma vasta gama de serviços que sejam atractivos para os utilizadores. Esta dissertação apresenta um sumário das tecnologias emergentes de broadcast que se distinguem nas várias partes do mundo com a sua particular incidência geográfica, características e cenários de aplicação. É ainda apresentada uma arquitectura 4G abordando assuntos inerentes à mobilidade e qualidade de serviço com particular incidência nos aspectos relacionados com a integração de uma tecnologia de broadcast particular. Para avaliação da arquitectura proposta foram efectuados estudos com base num equipamento de broadcast na sua versão comercial, permitindo desta forma obter uma análise que ilustra o que os operadores podem esperar do estado actual dos dispositivos. Os resultados permitiram retirar ilações sobre o comportamento de um equipamento considerado como um produto final a disponibilizar aos operadores, quando integrado num ambiente 4G com suporte de mobilidade e QoS. Nomeadamente é discutida a sua aplicabildiade tendo em linha de conta as desvantagens introduzidas pelas características inerentes à própria tecnologia.Broadcast of video and audio through analogical television completely changed the paradigm of information and entertainment divulgation. Today, in the “digital era”, the Analogue Switch Off revolution is being held. Manufacturers and operators already show concerns regarding the support of mobility, quality of experience and of service. Delivering competitive High Definition contents and providing solutions for the average “on-the-move” user are two of the most important issues to be dealt by the service providers, which are also within the analysis scope of this work. This dissertation presents an overview on the most relevant broadcast technologies which are assumed to be of relative acceptance in their respective target market. It presents their main characteristics and applicability. 4G architectural concepts are also analyzed, closely dealing with mobility and quality of service provisioning, with particular focus on the seamless integration of broadcast technologies. As a mean to evaluate the feasibility of integrating broadcast technologies with 4G architectures, a performance evaluation study was performed using commercial equipment. In this way a several set of considerations constructed illustrating the features and functionalities which operators can expect or disregard from professional commercial broadcasting devices. Results allow the withdrawing of conclusions concerning the integration of a final broadcasting solution when incorporated within a 4G environment with QoS and mobility support. Its applicability is evaluated having in mind the performance drawbacks introduced by the specific technology, and generalized towards the gathering of more general conclusions which consider the main characteristics of the commercial broadcasting devices

A new hybrid model of dengue incidence rate using negative binomial generalised additive model and fuzzy c-means model: a case study in Selangor

Dengue is one of the top reason for illness and mortality in the world with beyond one­third of the world's population living in the risk areas of dengue infection. In this study, there are five stages to achieve the research objectives. Firstly, the verification of predetem1ined variables. Secondly, the identification of new datasets after clustered by district and Fuzzy C-Means Model (FCM). Thirdly, the development of models using the existing dataset and the new datasets which clustered by the two different clustering categories. Then, to assess the models developed by using three measurement methods which are deviance (D), Akaike Jnfonnation Criteria (AIC) and Bayesian Infonnation Criteria (BIC} Lastly, the validation of model developed by comparing the value of D, AIC and BIC between the existing model and the new models developed which used the new datasets. There are two different clustering techniques applied which are clustering the data by district and by FCM. This study proposed a new modelling hybrid framework by using two statistical models which are FCM and negative binomial Generalised Additive Model (GAM). This study successfully presents the significant difference in the climatic and non-climatic factors that influenced dengue incidence rate (DIR) in Selangor, Malaysia. Results show that the climatic factors such as rainfall with current month up to 3 months and number of rainy days with current month up to lag 3 months are significant to DIR. Besides, the interaction between rainfall and number of rainy days also shows strong positive relationship to DIR. Meanwhile, non-climatic vaiiables such as population density, number of locality and lag DIR from I month until 3 months also show significant relationship towards DIR For both clustering techniques, there are two clusters fonned and there are four new models developed in this study. After comparing the values of D, AIC ai1d BIC between the existing model and the new models, this study concluded that four new models recorded lower values compared to the existing model. Therefore, the four new models are selected to present the dengue incidence in Selangor