Design of Wheelchair Robot for Active Postural Support (WRAPS) for Users with Trunk Impairments

People with severe trunk impairments cannot maintain or control upright posture during sitting or reaching out with the upper body. Passive orthoses are clinically available to support the trunk and promote the use of upper extremities in this population. However, these orthoses only rigidly position the torso on a wheelchair but do not facilitate movement of the trunk. In this dissertation, we introduce a novel active-assistive torso brace system for upperbody movements by a subject while seated. We have named this system as Wheelchair Robot for Active Postural Support (WRAPS). We propose designs of two robots, one for the pelvis and the other for the trunk. Each of the two devices has a parallel chain architecture to accommodate the range of motion (ROM), respectively for the pelvic and thoracic segments. The first thoracic robot was designed for the upper trunk motion relative to the pelvis. It has a 2[RP]S-2UPS architecture which provides four degrees-of-freedom (DOFs) to the end-effector placed on the upper trunk. The second is a pelvic robot which is designed to orient the pelvic segment relative to the seat. It has a 3-DOF [RRR]U-2[RR]S architecture, coupled with translation to accommodate pelvic movements relative to the seat. These robot architectures are synthesized based on human movement data. WRAPS can modulate the displacement of both the pelvic and the thoracic segments. Additionally, the forces can be applied on the torso through the end-effectors of these robots. Each of the robot prototypes was evaluated with able-bodied subjects to assess the device wearability, kinematic performances, and control system

Pressure Ulcer prediction using ADT

Objective : To develop a prediction model for pressure ulcer cases that continue to occur at an acute care hospital with a low occurrence rate of pressure ulcers. Methods : Analyzing data were collected from patients hospitalized at Tokushima University Hospital during 2012 using an alternating decision tree (ADT) data mining method. Results : The ADT-based analysis revealed transfer activity, operation time, and low body mass index (BMI) as important factors for predicting pressure ulcer development. Discussion : Among the factors identified, only “transfer activity” can be modified by nursing intervention. While shear force and friction are known to lead to pressure ulcers, transfer activity has not been identified as such. Our results suggest that transfer activities creating shear force and friction correlate with pressure ulcer development. The ADT algorithm was effective in determining prediction factors, especially for highly imbalanced data. Our three stumps ADT yielded accuracy, sensitivity, and specificity values of 72.1%±3.7%, 79.3%±18.1%, and 72.1%±3.8%, respectively. Conclusion : Transfer activity, identified as an interventional factor, can be modified through nursing interventions to prevent pressure ulcer formation. The ADT method was effective in identifying factors within largely imbalanced data

The Development of an assistive chair for elderly with sit to stand problems

A thesis submitted to the University of Bedfordshire in partial fulfilment of the requirements for the degree of Doctor of PhilosophyStanding up from a seated position, known as sit-to-stand (STS) movement, is one of the most frequently performed activities of daily living (ADLs). However, the aging generation are often encountered with STS issues owning to their declined motor functions and sensory capacity for postural control. The motivated is rooted from the contemporary market available STS assistive devices that are lack of genuine interaction with elderly users. Prior to the software implementation, the robot chair platform with integrated sensing footmat is developed with STS biomechanical concerns for the elderly. The work has its main emphasis on recognising the personalised behavioural patterns from the elderly users’ STS movements, namely the STS intentions and personalised STS feature prediction. The former is known as intention recognition while the latter is defined as assistance prediction, both achieved by innovative machine learning techniques. The proposed intention recognition performs well in multiple subjects scenarios with different postures involved thanks to its competence of handling these uncertainties. To the provision of providing the assistance needed by the elderly user, a time series prediction model is presented, aiming to configure the personalised ground reaction force (GRF) curve over time which suggests successful movement. This enables the computation of deficits between the predicted oncoming GRF curve and the personalised one. A multiple steps ahead prediction into the future is also implemented so that the completion time of actuation in reality is taken into account

Smart-Future-Living-Bodensee

All the papers in this book correspond to works presented during the workshop ”Smart-Future-Living-Bodensee”, held in Konstanz, Germany, on November 24, 201

Hybrid wheelchair controller for handicapped and quadriplegic patients

In this dissertation, a hybrid wheelchair controller for handicapped and quadriplegic patient is proposed. The system has two sub-controllers which are the voice controller and the head tilt controller. The system aims to help quadriplegic, handicapped, elderly and paralyzed patients to control a robotic wheelchair using voice commands and head movements instead of a traditional joystick controller. The multi-input design makes the system more flexible to adapt to the available body signals. The low-cost design is taken into consideration as it allows more patients to use this system

Biomechatronics: Harmonizing Mechatronic Systems with Human Beings

This eBook provides a comprehensive treatise on modern biomechatronic systems centred around human applications. A particular emphasis is given to exoskeleton designs for assistance and training with advanced interfaces in human-machine interaction. Some of these designs are validated with experimental results which the reader will find very informative as building-blocks for designing such systems. This eBook will be ideally suited to those researching in biomechatronic area with bio-feedback applications or those who are involved in high-end research on manmachine interfaces. This may also serve as a textbook for biomechatronic design at post-graduate level

Muscle activation patterns in shoulder impingement patients

Introduction: Shoulder impingement is one of the most common presentations of shoulder joint problems 1. It appears to be caused by a reduction in the sub-acromial space as the humerus abducts between 60o -120o – the 'painful arc'. Structures between the humeral head and the acromion are thus pinched causing pain and further pathology 2. Shoulder muscle activity can influence this joint space but it is unclear whether this is a cause or effect in impingement patients. This study aimed to observe muscle activation patterns in normal and impingement shoulder patients and determine if there were any significant differences. Method: 19 adult subjects were asked to perform shoulder abduction in their symptomatic arm and non-symptomatic. 10 of these subjects (age 47.9 ± 11.2) were screened for shoulder impingement, and 9 subjects (age 38.9 ± 14.3) had no history of shoulder pathology. Surface EMG was used to collect data for 6 shoulder muscles (Upper, middle and lower trapezius, serratus anterior, infraspinatus, middle deltoids) which was then filtered and fully rectified. Subjects performed 3 smooth unilateral abduction movements at a cadence of 16 beats of a metronome set at 60bpm, and the mean of their results was recorded. T-tests were used to indicate any statistical significance in the data sets. Significance was set at P<0.05. Results: There was a significant difference in muscle activation with serratus anterior in particular showing a very low level of activation throughout the range when compared to normal shoulder activation patterns (<30%). Middle deltoid recruitment was significantly reduced between 60-90o in the impingement group (30:58%).Trends were noted in other muscles with upper trapezius and infraspinatus activating more rapidly and erratically (63:25%; 60:27% respectively), and lower trapezius with less recruitment (13:30%) in the patient group, although these did not quite reach significance. Conclusion: There appears to be some interesting alterations in muscle recruitment patterns in impingement shoulder patients when compared against their own unaffected shoulders and the control group. In particular changes in scapula control (serratus anterior and trapezius) and lateral rotation (infraspinatus), which have direct influence on the sub-acromial space, should be noted. It is still not clear whether these alterations are causative or reactionary, but this finding gives a clear indication to the importance of addressing muscle reeducation as part of a rehabilitation programme in shoulder impingement patients

Spinoff 2015

Topics covered include: 3D Endoscope to Boost Safety, Cut Cost of Surgery; Audio App Brings a Better Night's Sleep Liquid Cooling Technology Increases Exercise Efficiency; Algae-Derived Dietary Ingredients Nourish Animals; Space Grant Research Launches Rehabilitation Chair; Vision Trainer Teaches Focusing Techniques at Home; Aircraft Geared Architecture Reduces Fuel Cost and Noise; Ubiquitous Supercritical Wing Design Cuts Billions in Fuel Costs; Flight Controller Software Protects Lightweight Flexible Aircraft; Cabin Pressure Monitors Notify Pilots to Save Lives; Ionospheric Mapping Software Ensures Accuracy of Pilots' GPS; Water Mapping Technology Rebuilds Lives in Arid Regions; Shock Absorbers Save Structures and Lives during Earthquakes; Software Facilitates Sharing of Water Quality Data Worldwide; Underwater Adhesives Retrofit Pipelines with Advanced Sensors; Laser Imaging Video Camera Sees through Fire, Fog, Smoke; 3D Lasers Increase Efficiency, Safety of Moving Machines; Air Revitalization System Enables Excursions to the Stratosphere; Magnetic Fluids Deliver Better Speaker Sound Quality; Bioreactor Yields Extracts for Skin Cream; Private Astronaut Training Prepares Commercial Crews of Tomorrow; Activity Monitors Help Users Get Optimum Sun Exposure; LEDs Illuminate Bulbs for Better Sleep, Wake Cycles; Charged Particles Kill Pathogens and Round Up Dust; Balance Devices Train Golfers for a Consistent Swing; Landsat Imagery Enables Global Studies of Surface Trends; Ruggedized Spectrometers Are Built for Tough Jobs; Gas Conversion Systems Reclaim Fuel for Industry; Remote Sensing Technologies Mitigate Drought; Satellite Data Inform Forecasts of Crop Growth; Probes Measure Gases for Environmental Research; Cloud Computing Technologies Facilitate Earth Research; Software Cuts Homebuilding Costs, Increases Energy Efficiency; Portable Planetariums Teach Science; Schedule Analysis Software Saves Time for Project Planners; Sound Modeling Simplifies Vehicle Noise Management; Custom 3D Printers Revolutionize Space Supply Chain; Improved Calibration Shows Images' True Colors; Micromachined Parts Advance Medicine, Astrophysics, and More; Metalworking Techniques Unlock a Unique Alloy; Low-Cost Sensors Deliver Nanometer-Accurate Measurements; Electrical Monitoring Devices Save on Time and Cost; Dry Lubricant Smooths the Way for Space Travel, Industry; and Compact Vapor Chamber Cools Critical Components

Federal Register

Daily publication of the U.S. Office of the Federal Register contains rules and regulations, proposed legislation and rule changes, and other notices, including "Presidential proclamations and Executive Orders, Federal agency documents having general applicability and legal effect, documents required to be published by act of Congress, and other Federal agency documents of public interest" (p. ii). Table of Contents starts on page iii

Federal Register

Daily publication of the U.S. Office of the Federal Register contains rules and regulations, proposed legislation and rule changes, and other notices, including "Presidential proclamations and Executive Orders, Federal agency documents having general applicability and legal effect, documents required to be published by act of Congress, and other Federal agency documents of public interest" (p. ii). Table of Contents starts on page iii