Large-area sheet task: Advanced dendritic-web-growth development

Thermally generated stresses in the growing web crystal were reduced. These stresses, which if too high cause the ribbon to degenerate, were reduced by a factor of three, resulting in the demonstrated growth of high-quality web crystals to widths of 5.4 cm. This progress was brought about chiefly by the application of thermal models to the development of low-stress growth configurations. A new temperature model was developed which can analyze the thermal effects of much more complex lid and top shield configurations than was possible with the old lumped shield model. Growth experiments which supplied input data such as actual shield temperature and melt levels were used to verify the modeling results. Desirable modifications in the melt level-sensing circuitry were made in the new experimental web growth furnace, and this furnace has been used to carry out growth experiments under steady-state conditions. New growth configurations were tested in long growth runs at Westinghouse AESD which produced wider, lower stress and higher quality web crystals than designs previously used

Large-area sheet task advanced dendritic web growth development

The computer code for calculating web temperature distribution was expanded to provide a graphics output in addition to numerical and punch card output. The new code was used to examine various modifications of the J419 configuration and, on the basis of the results, a new growth geometry was designed. Additionally, several mathematically defined temperature profiles were evaluated for the effects of the free boundary (growth front) on the thermal stress generation. Experimental growth runs were made with modified J419 configurations to complement the modeling work. A modified J435 configuration was evaluated

Large area sheet task: Advanced dendritic web growth development

The growth of silicon dendritic web for photovoltaic applications was investigated. The application of a thermal model for calculating buckling stresses as a function of temperature profile in the web is discussed. Lid and shield concepts were evaluated to provide the data base for enhancing growth velocity. An experimental web growth machine which embodies in one unit the mechanical and electronic features developed in previous work was developed. In addition, evaluation of a melt level control system was begun, along with preliminary tests of an elongated crucible design. The economic analysis was also updated to incorporate some minor cost changes. The initial applications of the thermal model to a specific configuration gave results consistent with experimental observation in terms of the initiation of buckling vs. width for a given crystal thickness

Large-area sheet task advanced dendritic web growth development

The thermal stress model was used to generate the design of a low stress lid and shield configuration, which was fabricated and tested experimentally. In preliminary tests, the New Experimental Web Growth Facility performed as designed, producing web on the first run. These experiments suggested desirable design modifications in the melt level sensing system to improve further its performance, and these are being implemented

Impact of changes in barometric pressure on landfill methane emission

Citation: Xu, Liukang, Xiaomao Lin, Jim Amen, Karla Welding, and Dayle McDermitt. “Impact of Changes in Barometric Pressure on Landfill Methane Emission.” Global Biogeochemical Cycles 28, no. 7 (2014): 679–95. https://doi.org/10.1002/2013GB004571.Landfill methane emissions were measured continuously using the eddy covariance method from June to December 2010. The study site was located at the Bluff Road Landfill in Lincoln, Nebraska, USA. Our results show that landfill methane emissions strongly depended on changes in barometric pressure; rising barometric pressure suppressed the emission, while falling barometric pressure enhanced the emission, a phenomenon called barometric pumping. There was up to a 35-fold variation in day-to-day methane emissions due to changes in barometric pressure. Wavelet coherence analysis revealed a strong spectral coherency between variations of barometric pressure and methane emission at periodicities ranging from 1 day to 8 days. Power spectrum and ogive analysis showed that at least 10 days of continuous measurements was needed in order to capture 90% of the total variance in the methane emission time series at our landfill site. From our results, it is clear that point-in-time measurements taken at monthly or longer time intervals using techniques such as the trace plume method, the mass balance method, or the closed-chamber method will be subject to large variations in measured emission rates because of the barometric pumping phenomenon. Estimates of long-term integrated methane emissions from landfills based on such measurements could yield uncertainties, ranging from 28.8% underestimation to 32.3% overestimation. Our results demonstrate a need for continuous measurements to quantify annual total landfill emissions. This conclusion may apply to the study of methane emissions from wetlands, peatlands, lakes, and other environmental contexts where emissions are from porous media or ebullition. Other implications from the present study for hazard gas monitoring programs are also discussed

Graph Transformation for Domain-Specific Discrete Event Time Simulation

Proceedings of: Fifth International Conference on Graph Transformation (ICGT 2010). Enschede, The Netherlands, September 27–October 2, 2010.Graph transformation is being increasingly used to express the semantics of domain specific visual languages since its graphical nature makes rules intuitive. However, many application domains require an explicit handling of time in order to represent accurately the behaviour of the real system and to obtain useful simulation metrics. Inspired by the vast knowledge and experience accumulated by the discrete event simulation community, we propose a novel way of adding explicit time to graph transformation rules. In particular, we take the event scheduling discrete simulation world view and incorporate to the rules the ability of scheduling the occurrence of other rules in the future. Hence, our work combines standard, efficient techniques for discrete event simulation (based on the handling of a future event set) and the intuitive, visual nature of graph transformation. Moreover, we show how our formalism can be used to give semantics to other timed approaches.Work partially sponsored by the Spanish Ministry of Science and Innovation, under project “METEORIC” (TIN2008-02081) and mobility grants JC2009-00015 and PR2009-0019, as well as by the R&D programme of the Community of Madrid, project “e-Madrid” (S2009/TIC-1650).Publicad