641 research outputs found
MRI of the Ankle and Hindfoot
Magnetic Resonance Imaging (MRI) is the diagnostic modality of choice for evaluation of traumatic ligamentous and tendinous injuries of the ankle and hindfoot. MRI is also valuable in the detection of occult bony trauma, osteochondral injuries, avascular necrosis, osteomyelitis, and a variety of other osseous conditions. This unit presents basic protocols for T1â and T2âweighted sequences and short tau inversion recovery (STIR) imaging. Additional imaging following intravenous gadolinium is indicated in selected cases.Peer Reviewedhttps://deepblue.lib.umich.edu/bitstream/2027.42/145234/1/cpmia2501.pd
Avalanche Breakdown Timing Statistics for Silicon Single Photon Avalanche Diodes
CCBY Silicon-based Single Photon Avalanche Diodes (SPADs) are widely used as single photon detectors of visible and near infrared photons. There has however been a lack of models accurately interpreting the physics of impact ionization (the mechanism behind avalanche breakdown) for these devices. In this work, we present a statistical simulation model for silicon SPADs that is capable of predicting breakdown probability, mean time to breakdown and timing jitter. Our model inherently incorporates carriers & #x0027; dead space due to phonon scattering and allows for non-uniform electric fields. Model validation included avalanche gain, excess noise factor, breakdown voltage, breakdown probability, and timing statistics. Simulating an n on-p and a p-on-n SPAD design using our model, we found that the n-on-p design offers significantly improved mean time to breakdown and timing jitter characteristics. For a breakdown probability of 0.5, mean time to breakdown and timing jitter from the n-on-p design were 3 and 4 times smaller compared to those from the p on n design. The data reported in this paper is available from the ORDA digital repository (DOI: 10.15131/shef.data.4823248)
Numerical Portrait of a Relativistic Thin Film BCS Superfluid
We present results of numerical simulations of the 2+1d Nambu - Jona-Lasinio
model with a non-zero baryon chemical potential mu including the effects of a
diquark source term. Diquark condensates, susceptibilities and masses are
measured as functions of source strength j. The results suggest that diquark
condensation does not take place in the high density phase mu>mu_c, but rather
that the condensate scales non-analytically with j implying a line of critical
points and long range phase coherence. Analogies are drawn with the low
temperature phase of the 2d XY model. The spectrum of the spin-1/2 sector is
also studied yielding the quasiparticle dispersion relation. There is no
evidence for a non-zero gap; rather the results are characteristic of a normal
Fermi liquid with Fermi velocity less than that of light. We conclude that the
high density phase of the model describes a relativistic gapless thin film BCS
superfluid.Comment: 37 pages, 16 figure
Computational and experimental studies of the wide bandgap semiconductors NH<sub>4</sub>TiOF<sub>3</sub> and (NH<sub>4</sub>)<sub>2</sub>TiOF<sub>4</sub>
Hazardous near Earth asteroid mitigation campaign planning based on uncertain information on fundamental asteroid characteristics
Given a limited warning time, an asteroid impact mitigation campaign would hinge on uncertainty-based information consisting of remote observational data of the identified Earth-threatening object, general knowledge of near-Earth asteroids (NEAs), and engineering judgment. Due to these ambiguities, the campaign credibility could be profoundly compromised. It is therefore imperative to comprehensively evaluate the inherent uncertainty in deflection and plan the campaign accordingly to ensure successful mitigation. This research demonstrates dual-deflection mitigation campaigns consisting of primary (instantaneous/quasi-instantaneous) and secondary (slow-push) deflection missions, where both deflection efficiency and campaign credibility are taken into account. The results of the dual-deflection campaign analysis show that there are trade-offs between the competing aspects: the launch cost, mission duration, deflection distance, and the confidence in successful deflection. The design approach is found to be useful for multi-deflection campaign planning, allowing us to select the best possible combination of missions from a catalogue of campaign options, without compromising the campaign credibility
Diagnostic accuracy of DXA compared to conventional spine radiographs for the detection of vertebral fractures in children
Objectives
In children, radiography is performed to diagnose vertebral fractures and dual energy x-ray absorptiometry (DXA) to
assess bone density. In adults, DXA assesses both. We aimed to establish whether
DXA can replace spine radiographs in assessment of paediatric vertebral fractures.
Methods
Prospectively, lateral spine radiographs and lateral spine DXA of 250 children
performed on the same day were independently scored by three radiologists using
the simplified algorithm based qualitative technique and blinded to results of the
other modality. Consensus radiograph read and second read of 100 random images
were performed. Diagnostic accuracy, inter/intraobserver and intermodality
agreements, patient/carer experience and radiation dose were assessed.
Results
Average sensitivity and specificity (95% confidence interval) in diagnosing one or
more vertebral fractures requiring treatment was 70% (58%-82%) and 97% (94%-
100%) respectively for DXA and 74% (55%-93%) and 96% (95%-98%) for
radiographs. Fleissâ kappa for interobserver and average kappa for intraobserver
reliability were 0.371 and 0.631 respectively for DXA and 0.418 and 0.621 for
radiographs. Average effective dose was 41.9”Sv for DXA and 232.7”Sv for
radiographs. Image quality was similar.
Conclusion
Given comparable image quality and non-inferior diagnostic accuracy, lateral spine
DXA should replace conventional radiographs for assessment of vertebral fractures
in children
Remote Sensing D/H Ratios in Methane Ice: Temperature-Dependent Absorption Coefficients of CH3D in Methane Ice and in Nitrogen Ice
The existence of strong absorption bands of singly deuterated methane (CH3D)
at wavelengths where normal methane (CH4) absorbs comparatively weakly could
enable remote measurement of D/H ratios in methane ice on outer solar system
bodies. We performed laboratory transmission spectroscopy experiments,
recording spectra at wavelengths from 1 to 6 \mum to study CH3D bands at 2.47,
2.87, and 4.56 \mum, wavelengths where ordinary methane absorption is weak. We
report temperature-dependent absorption coefficients of these bands when the
CH3D is diluted in CH4 ice and also when it is dissolved in N2 ice, and
describe how these absorption coefficients can be combined with data from the
literature to simulate arbitrary D/H ratio absorption coefficients for CH4 ice
and for CH4 in N2 ice. We anticipate these results motivating new telescopic
observations to measure D/H ratios in CH4 ice on Triton, Pluto, Eris, and
Makemake.Comment: 17 pages, 7 figure
Genetic Analysis of High Protein Content in âAC Proteusâ Related Soybean Populations Using SSR, SNP, DArT and DArTseq Markers
Key message: Several AC Proteus derived genomic regions (QTLs, SNPs) have been identified which may prove useful for further development of high yielding high protein cultivars and allele-specific marker developments. High seed protein content is a trait which is typically difficult to introgress into soybean without an accompanying reduction in seed yield. In a previous study, âAC Proteusâ was used as a high protein source and was found to produce populations that did not exhibit the typical association between high protein and low yield. Five high x low protein RIL populations and a high x high protein RIL population were evaluated by either quantitative trait locus (QTL) analysis or bulk segregant analyses (BSA) following phenotyping in the field. QTL analysis in one population using SSR, DArT and DArTseq markers found two QTLs for seed protein content on chromosomes 15 and 20. The BSA analyses suggested multiple genomic regions are involved with high protein content across the five populations, including the two previously mentioned QTLs. In an alternative approach to identify high protein genes, pedigree analysis identified SNPs for which the allele associated with high protein was retained in seven high protein descendants of AC Proteus on chromosomes 2, 17 and 18. Aside from the two identified QTLs (five genomic regions in total considering the two with highly elevated test statistic, but below the statistical threshold and the one with epistatic interactions)Â which were some distance from Meta-QTL regions and which were also supported by our BSA analysis within five populations. These high protein regions may prove useful for further development of high yielding high protein cultivars
Making things happen : a model of proactive motivation
Being proactive is about making things happen, anticipating and preventing problems, and seizing opportunities. It involves self-initiated efforts to bring about change in the work environment and/or oneself to achieve a different future. The authors develop existing perspectives on this topic by identifying proactivity as a goal-driven process involving both the setting of a proactive goal (proactive goal generation) and striving to achieve that proactive goal (proactive goal striving). The authors identify a range of proactive goals that individuals can pursue in organizations. These vary on two dimensions: the future they aim to bring about (achieving a better personal fit within oneâs work environment, improving the organizationâs internal functioning, or enhancing the organizationâs strategic fit with its environment) and whether the self or situation is being changed. The authors then identify âcan do,â âreason to,â and âenergized toâ motivational states that prompt proactive goal generation and sustain goal striving. Can do motivation arises from perceptions of self-efficacy, control, and (low) cost. Reason to motivation relates to why someone is proactive, including reasons flowing from intrinsic, integrated, and identified motivation. Energized to motivation refers to activated positive affective states that prompt proactive goal processes. The authors suggest more distal antecedents, including individual differences (e.g., personality, values, knowledge and ability) as well as contextual variations in leadership, work design, and interpersonal climate, that influence the proactive motivational states and thereby boost or inhibit proactive goal processes. Finally, the authors summarize priorities for future researc
- âŠ