Lawson criterion for ignition exceeded in an inertial fusion experiment

For more than half a century, researchers around the world have been engaged in attempts to achieve fusion ignition as a proof of principle of various fusion concepts. Following the Lawson criterion, an ignited plasma is one where the fusion heating power is high enough to overcome all the physical processes that cool the fusion plasma, creating a positive thermodynamic feedback loop with rapidly increasing temperature. In inertially confined fusion, ignition is a state where the fusion plasma can begin "burn propagation" into surrounding cold fuel, enabling the possibility of high energy gain. While "scientific breakeven" (i.e., unity target gain) has not yet been achieved (here target gain is 0.72, 1.37 MJ of fusion for 1.92 MJ of laser energy), this Letter reports the first controlled fusion experiment, using laser indirect drive, on the National Ignition Facility to produce capsule gain (here 5.8) and reach ignition by nine different formulations of the Lawson criterion

Surface volatilization modeling of (semi-)volatile hydrophobic organic compounds: The role of reference compounds

International audienceVolatilization of hazardous hydrophobic organic compounds is often observed in many water, wastewater and soil treatment (bio)processes. Several models have been developed to quantify and predict gas-liquid pollutant transfer, being the proportionality coefficient model (PCM) one of the most commonly used, particularly in wastewater treatment. The PCM is based on the use of oxygen as a reference compound, which has a low resistance to the transfer in the gas phase. However, this resistance might be important for (semi-)volatile organic compounds – or (semi-)VOCs, which may render the use of the PCM model inaccurate. This study proposes an experimental methodology and a modeling approach for the use of the two-reference compound model (2RCM) that considers both the liquid-side and the gas-side resistances, by using water and oxygen as references. Results showed that the 2RCM predicts more accurately the overall mass transfer coefficients than the PCM for a VOC and two semi-VOCs tested in this study. In addition, the 2RCM was found to be a more robust method to estimate mass transfer coefficient of any compound and its use can be extrapolated to all substances. Finally, the relevance and limitations of both models was established

Removal mechanisms in aerobic slurry bioreactors for remediation of soils and sediments polluted with hydrophobic organic compounds: An overview

Hydrophobic organic compound (HOC)-contaminated soils are a great environmental and public health concern nowadays. Further research is necessary to develop environmental friendly biotechnologies that allows public and private sectors to implement efficient and adaptable treatment approaches. Aerobic soil-slurry bioreactor technology has emerged as an effective and feasible technique with a high remediation potential, especially for silt and clay soil fractions, which often contain the highest pollutant concentration levels and are usually difficult to remove by implementing conventional methods. However, the mechanisms involved in the HOC removal in bioslurry reactor are still not completely understood. Gas-liquid and solid-liquid mass transfer, mass transport and biodegradation phenomena are the main known processes taking place in slurry bioreactors. This review compiles the most up-to-date information available about these phenomena and tries to link them, enlightening the possible interactions between parameters. It gathers the basic information needed to understand the complex bioremediation technology and raises awareness of some considerations that should be made

Solid-Liquid and Gas-Liquid Mass Transfer of PAHs in Soil-Slurry Bioreactors.

International audienc

Gas-liquid oxygen transfer in aerated and agitated slurry systems with high solid volume fractions

Oxygen transfer can be a limiting step in aerobic biodegradation processes. Therefore, this process has been widely investigated for wastewater treatment, but only few research works have been done on soil slurry systems. This study focuses on the gas-liquid oxygen mass transfer in clay slurry conditions in an aerated and agitated reactor using a marine propeller. Conversely to most studies on oxygen transfer, pneumatic power input is not negligible compared to mechanical power input. Clay presence has a negative impact on the oxygen transfer. However, the effect of agitation and aeration on this process remains unaffected at the clay concentrations tested. Three different phases explaining the depletion in the oxygen transfer rate are hypothesized. A model to predict the oxygen transfer coefficient in slurry reactors, including the three operational parameters tested within their respective ranges, is proposed

Experimental Analysis and Modeling of the Gas-Liquid Mass Transfer in a Slurry Bioreactor treating PAH-contaminated Soil.

International audienc

Search for high-energy neutrinos from gravitational wave event GW151226 and candidate LVT151012 with ANTARES and IceCube

The Advanced LIGO observatories detected gravitational waves from two binary black hole mergers during their first observation run (O1). We present a high-energy neutrino follow-up search for the second gravitational wave event, GW151226, as well as for gravitational wave candidate LVT151012. We find two and four neutrino candidates detected by IceCube, and one and zero detected by Antares, within ±500 s around the respective gravitational wave signals, consistent with the expected background rate. None of these neutrino candidates are found to be directionally coincident with GW151226 or LVT151012. We use nondetection to constrain isotropic-equivalent high-energy neutrino emission from GW151226, adopting the GW event's 3D localization, to less than 2×1051-2×1054 erg