2,786 research outputs found
A multi-sensor system for robotics proximity operations
Robots without sensors can perform only simple repetitive tasks and cannot cope with unplanned events. A multi-sensor system is needed for a robot to locate a target, move into its neighborhood and perform operations in contact with the object. Systems that can be used for such tasks are described
Interpretation of transverse tune spectra in a heavy-ion synchrotron at high intensities
Two different tune measurement systems have been installed in the GSI
heavy-ion synchrotron SIS-18. Tune spectra are obtained with high accuracy
using these fast and sensitive systems. Besides the machine tune, the spectra
contain information about the intensity dependent coherent tune shift and the
incoherent space charge tune shift. The space charge tune shift is derived from
a fit of the observed shifted positions of the synchrotron satellites to an
analytic expression for the head-tail eigenmodes with space charge.
Furthermore, the chromaticity is extracted from the measured head-tail mode
structure. The results of the measurements provide experimental evidence of the
importance of space charge effects and head-tail modes for the interpretation
of transverse beam signals at high intensity
Nonlinear Interactions Between Gravitational Radiation and Modified Alfven Modes in Astrophysical Dusty Plasmas
We present an investigation of nonlinear interactions between Gravitational
Radiation and modified Alfv\'{e}n modes in astrophysical dusty plasmas.
Assuming that stationary charged dust grains form neutralizing background in an
electron-ion-dust plasma, we obtain the three wave coupling coefficients, and
calculate the growth rates for parametrically coupled gravitational radiation
and modified Alfv\'{e}n-Rao modes. The threshold value of the gravitational
wave amplitude associated with convective stabilization is particularly small
if the gravitational frequency is close to twice the modified Alfv\'en
wave-frequency. The implication of our results to astrophysical dusty plasmas
is discussed.Comment: A few typos corrected. Published in Phys. Rev.
Characterization of wood-adhesive bonds in wet conditions by means of nanoindentation and tensile shear strength
The performance of adhesive-hardwood bonds can often be sensitive to humidity and temperature variation. Therefore, it is frequently challenging to achieve standard requirements for structural applications. To gain a better understanding of the wood-adhesive bond, the properties of the individual constituents as well as the local interface of European beech (Fagus sylvatica L.) wood cell walls in contact with structural adhesives were analyzed by means of nanoindentation. These results are compared to classical lap-shear strength. As adhesives two different one-component polyurethane adhesives (1C PUR) and a phenol resorcinol formaldehyde adhesive (PRF) were used. In one case, the beech wood was additionally pre-treated with an adhesion-promoting agent (primer) prior to bonding with 1C PUR. Beech wood joints were analyzed subsequent to several treatments, namely standard climate, after wet storage and in re-dried conditions. In addition, the influence of the primer on the hydroxyl accessibility of beech wood was investigated with dynamic vapor sorption (DVS). The lap-shear strength revealed good performance in dry and re-dried conditions for all adhesives on beech. Both polyurethane adhesives obtained deficits when tested in wet conditions. The use of a primer significantly improved the PUR performance in wet condition. DVS experiment demonstrated a decrease in hydroxyl group accessibility when using a high primer concentration. As novelty, nanoindentation was used for the first time to characterize the local wood–adhesive-interface properties in wet conditions. Nanoindentation showed that all tested 1C PUR perform quite similar in room climate, while PRF achieves considerable higher values for reduced E-modulus and hardness. Wet storage led to a considerable reduction in mechanical properties for all adhesives, while the highest relative change was observed for PRF. After re-drying, the adhesives re-gained a large part of their original mechanical properties in room climate. No distinct effect of the primer on the local micromechanical properties could be detected with nanoindentation in terms of specific work of indentation
Zonal flow generation in collisionless trapped electron mode turbulence
In the present work the generation of zonal flows in collisionless trapped
electron mode (TEM) turbulence is studied analytically. A reduced model for TEM
turbulence is utilized based on an advanced fluid model for reactive drift
waves. An analytical expression for the zonal flow growth rate is derived and
compared with the linear TEM growth, and its scaling with plasma parameters is
examined for typical tokamak parameter values.Comment: 20 pages, 4 figure
Nanoscale broadband transmission lines for spin qubit control
The intense interest in spin-based quantum information processing has caused
an increasing overlap between two traditionally distinct disciplines, such as
magnetic resonance and nanotechnology. In this work we discuss rigourous design
guidelines to integrate microwave circuits with charge-sensitive
nanostructures, and describe how to simulate such structures accurately and
efficiently. We present a new design for an on-chip, broadband, nanoscale
microwave line that optimizes the magnetic field driving a spin qubit, while
minimizing the disturbance on a nearby charge sensor. This new structure was
successfully employed in a single-spin qubit experiment, and shows that the
simulations accurately predict the magnetic field values even at frequencies as
high as 30 GHz.Comment: 18 pages, 8 figures, 1 table, pdflate
Mode signature and stability for a Hamiltonian model of electron temperature gradient turbulence
Stability properties and mode signature for equilibria of a model of electron
temperature gradient (ETG) driven turbulence are investigated by Hamiltonian
techniques. After deriving the infinite families of Casimir invariants,
associated with the noncanonical Poisson bracket of the model, a sufficient
condition for stability is obtained by means of the Energy-Casimir method. Mode
signature is then investigated for linear motions about homogeneous equilibria.
Depending on the sign of the equilibrium "translated" pressure gradient, stable
equilibria can either be energy stable, i.e.\ possess definite linearized
perturbation energy (Hamiltonian), or spectrally stable with the existence of
negative energy modes (NEMs). The ETG instability is then shown to arise
through a Kre\u{\i}n-type bifurcation, due to the merging of a positive and a
negative energy mode, corresponding to two modified drift waves admitted by the
system. The Hamiltonian of the linearized system is then explicitly transformed
into normal form, which unambiguously defines mode signature. In particular,
the fast mode turns out to always be a positive energy mode (PEM), whereas the
energy of the slow mode can have either positive or negative sign
Photon-graviton pair conversion
We consider the conversion of gravitons and photons as a four-wave mixing
process. A nonlinear coupled systems of equations involving two gravitons and
two photons is obtained, and the energy exchange between the different degrees
of freedom is found. The scattering amplitudes are obtained, from which a
crossection for incoherent processes can be found. An analytical example is
given, and applications to the early Universe are discussed.Comment: 5 pages, slightly modified as compared to v1, to appear in Class.
Quantum Grav. as a Letter to the Edito
- …