Comparative study of stress-strain characteristic of peat soil

This paper shows the stress-strain behavior of peat from the perspective of geotechnical engineering based on laboratory test. Stress happens when a load applied to a certain specimen and deformed the specimen while strain is the response from applied stress on a specimen. Peat is known as an ultimate soft soil in engineering terms because it has low shear strength and compressibility. This research is concerned about the stress-strain behavior of hemic peat. The undisturbed samples were collected at Parit Sulong and Parit Nipah, Batu Pahat, Johore, Malaysia. Normal stresses are 12.5kPa, 25kPa, 50kPa and 100kPa. The shear rate to determine the stress-strain on peat is 0.1mm/min. It is a drained condition test. Both results from each method that obtained were compared based on the relationships of stress-strain. Parit Sulong has higher stress-strain than Parit Nipah. If shear stress increased, shear strain also increased. The result shows that, direct simple shear test of stress-strain that tested on hemic is more relevant than a direct shear box because DSS shear the entire specimen of peat while DSB only shear at the center of the specimen. Geotechnical engineers can use the direct simple shear method to understand efficiently about the stress-strain behaviour of pea

Factors that influence marital intimacy: a qualitative analysis of Iranian married couples

Intimacy is a key factor contributing to marriage satisfaction, marriage quality, marriage stability, and marriage functioning. Despite significant attention on marital intimacy, the focus of most research has either centered on the functions of marital intimacy or aspects of the construct in marriage satisfaction. Factors that influence couple intimacy are largely overlooked. Existing studies mainly have used cross-sectional survey data. Very little exists on intimacy factors in non-western cultures. No previous research has explored intimacy through the lens of intimate couples. Therefore, this qualitative study is an attempt to investigate factors that enhance the marital intimacy of Iranian couples and introduce culture-sensitive factors. Using criterion-based purposive sampling, 14 females and males (i.e., seven intimate couples) were selected to participate in the present study, and the con-sensual qualitative research method was utilized to analyze data from the semi-structured interviews and personal diaries. Results demonstrated that factors enhancing marital intimacy were (i) family, (ii) shared time/length of marital relationship , (iii) reciprocity in self-sacrifice (iv) gratitude (v) new shared activity, (vi

An integrated model for solving production planning and production capacity problems using an improved fuzzy model for multiple linear programming according to Angelov's method

Decision making has become a part of our everyday lives. The main apprehension is that almost all decision difficulties include certain criteria, which usually can be multiple or conflicting. Certainly, the production planning and production capacity development includes several parameters uncertainty such as fuzzy resource capacity, fuzzy demand and fuzzy production rate. This situation makes decision maker challenging to describe the objective crisply and at the end the real optimum solution cannot attained correctly. The Fuzzy model for multi-objective linear programming should be an suitable approach for dealing with the production planning and production capacity (PP& PC) problems. The PP& PC problem based on the fuzzy environment becomes even more sophisticated as decision makers try to consider multi-objectives, Therefore, this study attempts to propose a novel scheme which is capable of dealing with these obstacles in PP& PC problem. Intuitionistic Fuzzy Optimization (1FO) by implementing the optimization problem in an Intuitionistic Fuzzy Set (IFS) environment and considered the degrees of rejection of objective(s) and of constraints as the complement of satisfaction degrees. The aim of the research is to propose a new method capable of dealing with these obstacles in the PP & PC problem. It takes into account uncertainty and makes trade-offs between multiple conflicting goals simultaneously. To verify the validity of the proposed method, a case study of the fuzzy multi-objective model of the PP&PC is used. This research takes into account uncertainty and makes a comparison between multiple conflicting goals at the same time. Therefore, this study attempts to propose a new scheme which is the modified Angelov’s approach

Aquifer potential assessment in termites manifested locales using geo-electrical and surface hydraulic measurement parameters

© 2019 by the authors. Licensee MDPI, Basel, Switzerland. In some parts of tropical Africa, termite mound locations are traditionally used to site groundwater structures mainly in the form of hand-dug wells with high success rates. However, the scientific rationale behind the use of mounds as prospective sites for locating groundwater structures has not been thoroughly investigated. In this paper, locations and structural features of termite mounds were mapped with the aim of determining the aquifer potential beneath termite mounds and comparing the same with adjacent areas, 10 m away. Soil and species sampling, field surveys and laboratory analyses to obtain data on physical, hydraulic and geo-electrical parameters from termite mounds and adjacent control areas followed. The physical and hydraulic measurements demonstrated relatively higher infiltration rates and lower soil water content on mound soils compared with the surrounding areas. To assess the aquifer potential, vertical electrical soundings were conducted on 28 termite mounds sites and adjacent control areas. Three (3) important parameters were assessed to compute potential weights for each Vertical Electrical Sounding (VES) point: Depth to bedrock, aquifer layer resistivity and fresh/fractured bedrock resistivity. These weights were then compared between those of termite mound sites and those from control areas. The result revealed that about 43% of mound sites have greater aquifer potential compared to the surrounding areas, whereas 28.5% of mounds have equal and lower potentials compared with the surrounding areas. The study concludes that termite mounds locations are suitable spots for groundwater prospecting owing to the deeper regolith layer beneath them which suggests that termites either have the ability to locate places with a deeper weathering horizon or are themselves agents of biological weathering. Further studies to check how representative our study area is of other areas with similar termite activities are recommended

Deep Learning Approach for Building Detection Using LiDAR-Orthophoto Fusion

© 2018 Faten Hamed Nahhas et al. This paper reports on a building detection approach based on deep learning (DL) using the fusion of Light Detection and Ranging (LiDAR) data and orthophotos. The proposed method utilized object-based analysis to create objects, a feature-level fusion, an autoencoder-based dimensionality reduction to transform low-level features into compressed features, and a convolutional neural network (CNN) to transform compressed features into high-level features, which were used to classify objects into buildings and background. The proposed architecture was optimized for the grid search method, and its sensitivity to hyperparameters was analyzed and discussed. The proposed model was evaluated on two datasets selected from an urban area with different building types. Results show that the dimensionality reduction by the autoencoder approach from 21 features to 10 features can improve detection accuracy from 86.06% to 86.19% in the working area and from 77.92% to 78.26% in the testing area. The sensitivity analysis also shows that the selection of the hyperparameter values of the model significantly affects detection accuracy. The best hyperparameters of the model are 128 filters in the CNN model, the Adamax optimizer, 10 units in the fully connected layer of the CNN model, a batch size of 8, and a dropout of 0.2. These hyperparameters are critical to improving the generalization capacity of the model. Furthermore, comparison experiments with the support vector machine (SVM) show that the proposed model with or without dimensionality reduction outperforms the SVM models in the working area. However, the SVM model achieves better accuracy in the testing area than the proposed model without dimensionality reduction. This study generally shows that the use of an autoencoder in DL models can improve the accuracy of building recognition in fused LiDAR-orthophoto data

Mechanical performance of roselle/sugar palm fiber hybrid reinforced polyurethane composites

The effect of sugar palm fiber (SPF) loading was studied relative to the mechanical properties of roselle (RF)/SPF/thermoplastic polyurethane (TPU) hybrid composites. RF/SPF/TPU hybrid composites were fabricated at different weight ratios (100:0, 75:25, 50:50, 25:75, and 0:100) by melt mixing and hot compression. The mechanical (tensile, flexural, and impact test) and morphological properties of tensile fractured samples were examined using a universal testing machine, impact machine, and scanning electron microscope. It was found that the hybridization of RF/SPF increased its impact strength corresponding to the increases in the SPF content of the composites. The tensile and flexural properties of the hybrid composites decreased due to poor interfacial bonding between the fiber and matrix. Scanning electron micrographs of the tensile fractured surface of the RF/SPF hybrid composites revealed fiber pullouts and poor adhesion bonding. In conclusion, the hybridization of SPF with RF/TPU composites enhanced its impact strength while decreasing the tensile and flexural strength

Performance comparison of distributed generation installation arrangement in transmission system for loss control

Placing Distributed Generation (DG) into a power network should be planned wisely. In this paper, the comparison of having different installation arrangement of real-power DGs in transmission system for loss control is presented. Immune-brainstorm-evolutionary programme (IBSEP) was chosen as the optimization technique. It is found that optimizing fixed-size DGs locations gives the highest loss reduction percentage. Apart from that, scattered small-sized DGs throughout a network minimizes transmission loss more than allocating one biger-sized DG at a location

Pemberian nafkah wajib seorang wanita berpendapatan kepada kerabat dan hubungannya dengan tolakan zakat pendapatan

Tulisan ini adalah berkenaan persoalan nafkah wajib seorang wanita yang memiliki harta sendiri kepada kaum kerabat dan hubungannya dengan tolakan zakat pendapatan. Ia dikemukakan memandangkan isu tolakan zakat merupakan perkara agak baharu dibincangkan di Malaysia dan masih terdapat aspek-aspek tolakan individu yang belum diperincikan dari perspektif fiqh. Oleh kerana itu, tujuan tulisan ini adalah mengkaji isu-isu berkenaan nafkah wajib seorang wanita terhadap kerabat mereka dari sudut fiqh seterusnya mencadangkan bentuk tolakan zakat pendapatan yang bersesuaian. Untuk itu, tulisan ini menggunakan kajian perpustakaan sepenuhnya untuk mencapai objektif yang telah digariskan tersebut. Antara rujukannya adalah bermula dengan kitab-kitab fiqh dalam koleksi fiqh Shafii, seterusnya diikuti dengan tulisan-tulisan fiqh yang menampilkan pandangan pelbagai mazhab serta tulisan-tulisan fiqh kontemporari sebagai perbandingan dan analisis yang lebih mendalam. Tulisan ini juga merujuk tafsir al-Quran dan al-Hadis bagi melihat dengan lebih mendalam nas-nas yang dijadikan rujukan oleh fuqaha’ dalam tulisan-tulisan yang telah dirujuk. Hasil daripada tulisan ini adalah penjelasan tentang tanggungjawab nafkah wajib seorang wanita kepada kerabat dalam kategori usul dan furu’ serta bentuk tolakan zakat yang sepatutnya. Tulisan ini juga mencadangkan pemberian zakat kepada kerabat yang terkeluar daripada kategori wajib nafkah untuk mereka serta cadangan kepada pihak berautoriti agar memudahkan pemberian zakat kepada golongan ini