9,388 research outputs found
Deep levels and radiation effects in p-InP
A survey was conducted on past studies of hole traps in InP. An experiment was designed to evaluate hole traps in Zn-doped InP after fabrication, after electron irradiation and after annealing using deep level transient spectroscopy. Data similar to that of Yamaguchi was seen with observation of both radiation-induced hole and electron traps at E sub A=0.45 eV and 0.03 eV, respectively. Both traps are altered by annealing. It is also shown that trap parameters for surface-barrier devices are influenced by many factors such as bias voltage, which probes traps at different depths below the surface. These devices require great care in data evaluation
Acoustic measurement of lubricant-film thickness distribution in ball bearings
An oil-film thickness monitoring system capable of providing an early warning of lubrication failure in rolling element bearings has been developed. The system is used to measure the lubricant-film thickness in a conventional deep groove ball bearing (shaft diameter 80 mm, ball diameter 12.7 mm). The measurement system comprises a 50 MHz broadband ultrasonic focused transducer mounted on the static outer raceway of the bearing. Typically the lubricant-films in rolling element bearings are between 0.1-1.0 μm in thickness and so are significantly smaller than the ultrasonic wavelength. A quasistatic spring model is used to calculate oil-film thickness from the measured reflection coefficient data. An accurate triggering system has been developed to enable multiple reflection coefficient measurements to be made as the contact ellipse sweeps over the measurement location. Experiments are described in which the loading conditions and rotational speed are varied. Lubricant-film thickness distributions measured ultrasonically are described and are shown to agree well with the predictions from classical elastohydrodynamic (EHD) lubrication theory, particularly at high radial loads and low rotary speeds. A range of parameters affecting the performance of the measurement are discussed and the limits of operation of the measurement technique defined. © 2006 Acoustical Society of America
Regional differences and sources of organochlorine pesticides in soils surrounding chemical industrial parks
Concentrations of organochlorine pesticides (OCPs; dichlorodiphenyltrichloroethanes (DDTs), hexachlorocyclohexanes (HCHs), hexachlorobenzene (HCB)) were investigated in 105 soil samples collected in vicinity of the chemical industrial parks in Tianjin, China. OCP concentrations significantly varied in the study area, high HCH and DDT levels were found close to the chemical industrial parks. The intensity of agricultural activity and distance from the potential OCP emitters have important influences on the OCP residue distributions. Principal component analysis indicates that HCH pollution is a mix of historical technical HCH and current lindane pollution and DDT pollution input is only due to technical DDT sources. The significant correlations of OCP compounds reveal that HCHs, DDTs and HCB could have some similar sources of origin
Identification of sources of elevated concentrations of polycyclic aromatic hydrocarbons in an industrial area in Tianjin, China
The concentrations of 16 polycyclic aromatic hydrocarbons (PAHs) were determined by gas chromatography equipped with a mass spectrometry detector in 105 topsoil samples from an industrial area around Bohai Bay, Tianjin in the North of China. Results demonstrated that concentrations of PAHs in 104 soil samples from this area ranged from 68.7 to 5,590 ng g (-aEuro parts per thousand 1) dry weight with a mean of a16PAHs 814 +/- 813 ng g (-aEuro parts per thousand 1), which suggests that there exists mid to high levels of PAH contamination. The concentration of a16PAHs in one soil sample from Tianjin Port was exceptionally high (48,700 ng g (-aEuro parts per thousand 1)). Ninety-three of the 105 soil samples were considered to be contaminated with PAHs (> 200 ng g (-aEuro parts per thousand 1)), and 25 were heavily polluted (> 1,000 ng g (-aEuro parts per thousand 1)). The sites with high PAHs concentration are mainly distributed around chemical industry parks and near highways. Two low molecular weight PAHs, naphthalene and phenanthrene, were the dominant components in the soil samples, which accounted for 22.1% and 10.7% of the a16PAHs concentration, respectively. According to the observed molecular indices, house heating in winter, straw stalk combustion in open areas after harvest, and petroleum input were common sources of PAHs in this area, while factory discharge and vehicle exhaust were the major sources around chemical industrial parks and near highways. Biological processes were probably another main source of low molecular weight PAHs
- …