The VTRE Program: An overview

The Vented Tank Resupply Experiment (VTRE) Program is a NASA In-Space Technology Experiments Program (IN-STEP) that will develop, and fly a small, low cost space experiment to investigate, develop, and acquire needed data to extend and advance the technology of capillary vane fluid management devices to applications requiring direct venting of gas from tanks in low-gravity. GAS venting may be required for control of pressure, or to allow low-g fill of a tank with liquid while holding a constant tank back pressure by gas venting. Future space applications requiring these fluid management capabilities include both cryogenic and Earth storable fluid systems. The experiment is planned as a Shuttle Hitchhiker payload, and will be developed around two transparent tanks equipped with capillary vane devices between which a test liquid can be transferred. Experiments will be conducted for vented transfer, direct venting, stability of liquid positioning to accelerations within and significantly above the design values, and fluid reorientation by capillary wicking of liquid into the vane device following intentional liquid upset

A cohomological proof of Peterson-Kac's theorem of conjugacy of Cartan subalgebras of affine Kac-Moody Lie algebras

This paper deals with the problem of conjugacy of Cartan subalgebras for affine Kac-Moody Lie algebras. Unlike the methods used by Peterson and Kac, our approach is entirely cohomological and geometric. It is deeply rooted on the theory of reductive group schemes developed by Demazure and Grothendieck, and on the work of J. Tits on buildings.Fil: Chernousov, V.. University of Alberta; CanadáFil: Gille, P.. Centre National de la Recherche Scientifique. Ecole Normale Supérieure; FranciaFil: Pianzola, Arturo. University of Alberta; Canadá. Universidad Centro de Altos Estudios en Ciencias Exactas; Argentina. Consejo Nacional de Investigaciones Científicas y Técnicas; ArgentinaFil: Yahorau, U.. University of Alberta; Canad

Growth of Hg1−xCdxTe single crystals by travelling heater method under accelerated crucible rotation conditions

The accelerated crucible rotation technique (ACRT) has been applied to the THM growth of Hg1−xCdxTe crystals to grow the crystals at a higher rate. These higher growth rates, which should be achieved by extending the regions of conventional stirring towards the interfaces, have been used in an attempt to explain the results in terms of simple constitutional supercooling arguments. Some different ACRT cycles which fulfil simple hydrodynamic and geometric criteria have been studied. The grown crystals were investigated with respect to their metallurgical homogeneity and their structural perfection. These properties have not been degraded by increasing the growth rate from 1.5 to 8.5 mm per day

Conjugacy theorems for loop reductive group schemes and Lie algebras

The conjugacy of split Cartan subalgebras in the finite dimensional simple case (Chevalley) and in the symmetrizable Kac-Moody case (Peterson-Kac) are fundamental results of the theory of Lie algebras. Among the Kac-Moody Lie algebras the affine algebras stand out. This paper deals with the problem of conjugacy for a class of algebras --extended affine Lie algebras-- that are in a precise sense higher nullity analogues of the affine algebras. Unlike the methods used by Peterson-Kac, our approach is entirely cohomological and geometric. It is deeply rooted on the theory of reductive group schemes developed by Demazure and Grothendieck, and on the work of J. Tits on buildingsComment: Publi\'e dans Bulletin of Mathematical Sciences 4 (2014), 281-32

A new approach to crystal growth of Hg1−xCdxTe by the travelling heater method (THM)

Crystal growth by the travelling heater method (THM) is reported using a source material preparation process that is different from all methods used before. Non-stoichiometric (Hg, Cd)Te melts were homogenized and quenched to prevent macroscopic segregation effects. Inclusions of excess Te were removed during a first THM pass, resulting in stoichiometric solid alloys with a shift of the mole fraction towards higher CdTe contents. The amount of the shift, dependent on the Te excess and on the equilibrium temperature of the first THM run, was calculated and taken into account in the preparation of x=0.22 and x=0.30 Hg1-xCdxTe single crystals. Source material ingots, as well as THM single crystals, were characterized with special emphasis of the compositional homogeneity. Radial as well as axial homogeneity are comparable with the best results on THM crystals reported so far. The described method can be used in growing all materials for which THM is possible. However, quantitative calculation requires the exact knowledge of the particular ternary phase diagram

Revised reference model for nitric acid

A nearly global set of data on the nitric acid distribution was obtained for seven months by the Limb Infrared Monitor of the Stratosphere (LIMS) experiment on the Nimbus 7 spacecraft. The evaluation of the accuracy, precision, and resolution of these data is described, and a description of the major features of the nitric acid distributions is presented. The zonal mean for nitric acid is distributed in a stratospheric layer that peaks near 30 mb, with the largest mixing ratios occurring in polar regions, especially in winter

On-orbit cryogenic fluid transfer

A number of future NASA and DOD missions have been identified that will require, or could benefit from resupply of cryogenic liquids in orbit. The most promising approach for accomplishing cryogenic fluid transfer in the weightlessness environment of space is to use the thermodynamic filling technique. This approach involves initially reducing the receiver tank temperature by using several charge hold vent cycles followed by filling the tank without venting. Martin Marietta Denver Aerospace, under contract to the NASA Lewis Research Center, is currently developing analytical models to describe the on orbit cryogenic fluid transfer process. A detailed design of a shuttle attached experimental facility, which will provide the data necessary to verify the analytical models, is also being performed

Growth of Tl doped PbTe single crystals by the travelling heater method

Single crystals of Tl doped PbTe were grown using the travelling heater method (THM) and the electrical properties were evaluated at 77 K and found to be p-type

Development of advanced material composites for use as internal insulation for LH2 tanks (gas layer concept)

A program is described that was conducted to develop an internal insulation system for potential application to the liquid hydrogen tanks of a reusable booster, where the tanks would be subjected to repeated high temperatures. The design of the internal insulation is based on a unique gas layer concept, in which capillary or surface tension effects are used to maintain a stable gas layer, within a cellular core structure, between the tank wall and the contained liquid hydrogen. Specific objectives were to select materials for insulation systems that would be compatible with wall temperatures of 350 F and 650 F during reentry into the earth's atmosphere, and to fabricate and test insulation systems under conditions simulating the operating environment. A materials test program was conducted to evaluate the properties of candidate materials at elevated temperatures and at the temperature of liquid hydrogen, and to determine the compatibility of the materials with a hydrogen atmosphere at the appropriate elevated temperature. The materials that were finally selected included Kapton polyimide films, silicone adhesives, fiber glass batting, and in the case of the 350 F system, Teflon film

Development of advanced materials for integrated tank insulation system for the long term storage of cryogens in space Final report

Insulating materials for long term cryogenic storage in spac