Optimization of wear loss in silicon nitride (Si3N4)–hexagonal boron nitride (hBN) composite using DoE–Taguchi method

Introduction The contacting surfaces subjected to progressive loss of material known as ‘wear,’ which is unavoidable between contacting surfaces. Similar kind of phenomenon observed in the human body in various joints where sliding/rolling contact takes place in contacting parts, leading to loss of material. This is a serious issue related to replaced joint or artificial joint. Case description Out of the various material combinations proposed for artificial joint or joint replacement Si3N4 against Al2O3 is one of in ceramic on ceramic category. Minimizing the wear loss of Si3N4 is a prime requirement to avoid aseptic loosening of artificial joint and extending life of joint. Discussion and evaluation In this paper, an attempt has been made to investigate the wear loss behavior of Si3N4–hBN composite and evaluate the effect of hBN addition in Si3N4 to minimize the wear loss. DoE–Taguchi technique is used to plan and analyze experiments. Conclusion Analysis of experimental results proposes 15 N load and 8 % of hBN addition in Si3N4 is optimum to minimize wear loss against alumina

Residual stress analysis of drive shafts after induction hardening

Typically, for automotive shafts, shape distortion manifests itself in most cases after the induction hardening by an effect known as bending. The distortion results in a boost of costs, especially due to machining parts in the hardened state to fabricate its final tolerances. In the present study, residual stress measurements were carried out on automotive drive shafts made of DIN 38B3 steel. The samples were selected in consequence of their different distortion properties by an industrial manufacturing line. One tested shaft was straightened, because of the considerable dimensional variation and the other one not. Firstly, the residual stress measurements were carried out by using a portable difractometer, in order to avoid cutting the shafts and evaluate the original state of the stresses, and afterwards a more detailed analysis was realized by a conventional stationary diffractometer. The obtained results presented an overview of the surface residual stress profiles after induction hardening and displayed the influence of the straightening process on the redistribution of residual stresses. They also indicated that the effects of the straightening in the residual stresses cannot be neglecte

Wild boar density data generated by camera trapping in nineteen European areas

This report presents the results of field activities in relation to the generation of reliable wild boar density values by camera trapping (CT) in 19 areas in Europe, mainly in East Europe. Random Encounter Model (REM) densities ranged from 0.35±0.24 to 15.25±2.41 (SE) individuals/km2. No statistical differences in density among bioregions were found. The number of contacts was the component of the trapping rate that determined the coefficient of variation (CV) the most. The daily range (DR) significantly varied as a function of management; the higher values were detected in hunting grounds compared to protected areas, indicating that movement parameters are population specific, and confirming the potential role of hunting activities in increasing wild boar movement and contact rates among individual or groups. The results presented in this report illustrate that a harmonized approach to actual wildlife density estimation (namely for terrestrial mammals) is possible at a European scale, sharing the same protocols, collaboratively designing the study, processing, and analysing the data. This report adds reliable wild boar density values that have the potential to be used for wild boar abundance spatial modelling, both directly or to calibrate outputs of model based on abundance (such as hunting bags) or occurrence data. Future REM developments should focus on improving the precision of estimates (probably through increased survey effort). Next steps require an exhaustive and representative design of a monitoring network to estimate reliable trends of wild boar populations as a function of different factors in Europe. In this regard, the newly created European Observatory of Wildlife will be a network of observation points provided by collaborators from all European countries capable to monitor wildlife population at European level.EFSA-Q-2020-00677Peer reviewe

Numerical Modelling of Crack Path in the Contact Area of Gear Teeth Flanks

ABSTRACT. A two-dimensiona