Numerical investigation on sand erosion phenomenon of coated and uncoated vanes in low-pressure gas turbine

For energy saving and less environmental impact, efficient energy utilization is of importance. In a gas-turbine engine, its performance increases as increasing temperature of the turbine inlet flow. However, turbine components are required to be protected from the high temperature flows. Recently, ceramic matrix composite (referred as CMC, hereafter) is expected to be utilized as protecting the gas-turbine components due to the excellent properties of CMC in high temperature conditions: low density, high strength and high rigidity. Therefore, the CMC allows us to increase the inlet temperature and leads to high performance of gas-turbine engines. On the other hand, sand erosion phenomenon is one of serious problems in gas-turbine engines. Sand particles ingested from the engine inlet impinge and erode the wall surfaces, which can cause engine failure. In order to prevent the sand erosion phenomenon, anti-erosion coatings have been developed and adopted for gas-turbines, although the anti-erosion characteristics of the CMC coating have not completely been clarified. The objective of the present paper is to perform numerical simulations of sand erosion phenomenon on the coated and the uncoated T106 CMC vanes in a low-pressure gas turbine. We investigate the flow field, particle trajectories and the eroded shape of the CMC turbine vanes. The results show that the erosion occurs near the leading edge and at the 90 percent axial chord on the pressure surface in both of the coated and uncoated cases. In the uncoated case, the severe erosion phenomenon is observed especially. Accordingly, we have concluded that the coating obviously played an important role in protecting the CMC vanes from sand erosion

Heat transfer enhancement and torque reduction by traveling wave-like blowing and suction in turbulent Taylor-Couette flow

Direct numerical simulations of turbulent Taylor-Couette flows are performed to investigate the effect of a traveling wave control on torque and heat transfer. In the Taylor-Couette flow, inner and outer cylinders are rotating and immobile, respectively, and the temperature difference between cylinder walls is maintained as constant. The ratio between the inner and outer cylinder is 0.882, and the Reynolds number is set as 84,000. A traveling wave-like blowing and suction is imposed on an inner cylinder wall. A parametric study shows the effect of control parameters on torque and heat transfer. We focused on three characteristic parameter sets: heat transfer enhancement, relaminarization phenomenon, and simultaneous achievement of torque reduction and heat transfer enhancement. We employed identity equations by using three-component decomposition to clarify contributions from advection, turbulence, and diffusion on torque and Stanton number. The results indicated that the traveling wave control affects the turbulence and advection contributions

Smoking and adipose tissue inflammation suppress leptin expression in Japanese obese males: potential mechanism of resistance to weight loss among Japanese obese smokers

<p>Abstract</p> <p>Background</p> <p>The effect of smoking on leptin regulation is controversial. Smoking may induce low-grade inflammation. Recent series of studies indicated the critical role of macrophage migration in the establishment of adipose tissue inflammation. In this study, we aimed to see the effects of smoking and inflammation on leptin regulation both at cellular and epidemiological levels.</p> <p>Methods</p> <p>We compared the concentration of inflammatory markers and serum leptin levels among Japanese male subjects. Additionally, leptin and intercellular adhesion molecule (ICAM) -1 gene expression was assessed in adipocytes co-cultured with or without macrophages in the presence or absence of nicotine and/or lipopolysaccharide (LPS).</p> <p>Results</p> <p>In subjects with BMI below 25 kg/m², both WBC counts and soluble-ICAM-1 levels are significantly higher in smokers than in non-smokers. However, leptin concentration did not differ according to smoking status. However, in subjects with BMI over 25 kg/m², smokers exhibited significantly lower serum leptin level as well as higher WBC counts and s-ICAM-1 concentration as compared with non-smokers. Leptin gene expression was markedly suppressed in adipocytes co-cultured with macrophages than in adipocyte culture alone. Furthermore, nicotine further suppressed leptin gene expression. ICAM-1 gene expression was markedly up-regulated in adipocytes co-cultured with macrophages when stimulated with LPS.</p> <p>Conclusions</p> <p>Adipose tissue inflammation appears to down-regulate leptin expression in adipose tissues. Nicotine further suppresses leptin expression. Thus, both smoking and inflammation may diminish leptin effect in obese subjects. Therefore, obese, but not normal weight, smokers might be more resistant to weight loss than non-smokers.</p

Calibration of Photomultiplier Tubes for the Fluorescence Detector of Telescope Array Experiment using a Rayleigh Scattered Laser Beam

We performed photometric calibration of the PhotoMultiplier Tube (PMT) and readout electronics used for the new fluorescence detectors of the Telescope Array (TA) experiment using Rayleigh scattered photons from a pulsed nitrogen laser beam. The experimental setup, measurement procedure, and results of calibration are described. The total systematic uncertainty of the calibration is estimated to be 7.2%. An additional uncertainty of 3.7% is introduced by the transport of the calibrated PMTs from the laboratory to the TA experimental site.Comment: 43 pages, 15 figure

Fluorogenic derivatization of aryl halides based on the formation of biphenyl by Suzuki coupling reaction with phenylboronic acid.

The fluorogenic derivatization method for aryl halide was developed for the first time. This method was based on the formation of fluorescent biphenyl structure by Suzuki coupling reaction between aryl halides and non-fluorescent phenylboronic acid (PBA). We measured the fluorescence spectra of the products obtained by the reaction of p-substituted aryl bromides (i.e., 4-bromobenzonitrile, 4-bromoanisole, 4-bromobenzoic acid ethyl ester and 4-bromotoluene) with PBA in the presence of palladium (II) acetate as a catalyst. The significant fluorescence at excitation maximum wavelength of 275-290 nm and emission maximum wavelength of 315-350 nm was detected in all the tested aryl bromides. This result demonstrated that non-fluorescent aryl bromides could be converted to the fluorescent biphenyl derivatives by the coupling reaction with non-fluorescent PBA. We tried to determine these aryl bromides by HPLC-fluorescence detection with pre-column derivatization. The aryl bromide derivatives were detected on the chromatogram within 30 min without any interfering peak derived from the reagent blank. The detection limits (S/N=3) for aryl bromides were 13-157 fmol/injection

CD153/CD30 signaling promotes age-dependent tertiary lymphoid tissue expansion and kidney injury

高齢者腎臓病を悪化させる原因細胞・分子の同定に成功. 京都大学プレスリリース. 2021-11-30.A new drug target for kidney disease. 京都大学プレスリリース. 2021-11-30.Tertiary lymphoid tissues (TLTs) facilitate local T- and B-cell interactions in chronically inflamed organs. However, the cells and molecular pathways that govern TLT formation are poorly defined. Here we identify TNF superfamily CD153-CD30 signaling between two unique age-dependent lymphocyte subpopulations, CD153⁺PD-1⁺CD4⁺ senescence-associated T (SAT) cells and CD30+T-bet+ age-associated B cells (ABCs), as a driver for TLT expansion. SAT cells, which produced ABC-inducing factors IL21 and IFNγ, and ABCs progressively accumulated within TLTs in aged kidneys after injury. Notably, in kidney injury models, CD153 or CD30 deficiency impaired functional SAT cell induction, which resulted in reduced ABC numbers and attenuated TLT formation with improved inflammation, fibrosis and renal function. Attenuated TLT formation after transplantation of CD153-deficient bone marrow further supported the importance of CD153 in immune cells. Clonal analysis revealed that SAT cells and ABCs in the kidneys arose from both local differentiation and recruitment from the spleen. In the synovium of aged rheumatoid arthritis patients, T peripheral helper/T follicular helper cells and ABCs also expressed CD153 and CD30, respectively. Together, our data reveal a previously unappreciated function of CD153-CD30 signaling in TLT formation and propose targeting CD153-CD30 signaling pathway as a therapeutic target for slowing kidney disease progression

Risk factors for CAR-T cell manufacturing failure among DLBCL patients: A nationwide survey in Japan

CAR-T細胞製造を成功させるためのレシピ --アフェレーシス前の下ごしらえでの工夫--. 京都大学プレスリリース. 2023-04-27.For successful chimeric antigen receptor T (CAR-T) cell therapy, CAR-T cells must be manufactured without failure caused by suboptimal expansion. In order to determine risk factors for CAR-T cell manufacturing failure, we performed a nationwide cohort study in Japan and analysed patients with diffuse large B-cell lymphoma (DLBCL) who underwent tisagenlecleucel production. We compared clinical factors between 30 cases that failed (7.4%) with those that succeeded (n = 378). Among the failures, the proportion of patients previously treated with bendamustine (43.3% vs. 14.8%; p < 0.001) was significantly higher, and their platelet counts (12.0 vs. 17.0 × 10⁴/μL; p = 0.01) and CD4/CD8 T-cell ratio (0.30 vs. 0.56; p < 0.01) in peripheral blood at apheresis were significantly lower than in the successful group. Multivariate analysis revealed that repeated bendamustine use with short washout periods prior to apheresis (odds ratio [OR], 5.52; p = 0.013 for ≥6 cycles with washout period of 3–24 months; OR, 57.09; p = 0.005 for ≥3 cycles with washout period of <3 months), low platelet counts (OR, 0.495 per 105/μL; p = 0.022) or low CD4/CD8 ratios (<one third) (OR, 3.249; p = 0.011) in peripheral blood at apheresis increased the risk of manufacturing failure. Manufacturing failure remains an obstacle to CAR-T cell therapy for DLBCL patients. Avoiding risk factors, such as repeated bendamustine administration without sufficient washout, and risk-adapted strategies may help to optimize CAR-T cell therapy for DLBCL patients

Labeling of alprenolol with fluorescent aryl iodide as a reagent based on Mizoroki-Heck coupling reaction.

A novel fluorescent labeling method for alprenolol was developed based on Mizoroki-Heck coupling reaction. We designed and synthesized fluorescent aryl iodide, 4-(4,5-diphenyl-1H-imidazol-2-yl)iodobenzene (DIBI) as a labeling reagent. DIBI has a lophine skeleton carrying an iodide atom acting as fluorophore and reactive center, respectively. In order to evaluate the usefulness of DIBI, a high-performance liquid chromatography (HPLC) with fluorescence detection method was developed for the determination of alprenolol as a model compound of terminal double bond. The fluorescent labeling of alprenolol with DIBI was achieved in the presence of palladium acetate as a catalyst, and the labeled alprenolol was detected fluorometrically. In addition, it was found that the fluorescence of DIBI derivative increased and red shifted when compared with that of DIBI. Furthermore, the proposed method could be applied to determine the alprenolol concentration in rat plasma after administration of alprenolol without interferences from biological components. The detection limit (S/N=3) for alprenolol in rat plasma was 0.74 ng/mL (30 fmol on column)