758 research outputs found
An experimental investigation on the theoretical development of conditioned inhibition
The Hullian Intervening variables, reactive Inhibition (IR) and conditioned inhibition (SIR) have, like many other Hullian intervening variables, generated large amounts of research as reported in the psychological literature. These views of Hull are presented systematically in two of a proposed three-book system
Performance and loads data from a hover test of a full-scale XV-15 rotor
A hover test of a full-scale XV-15 rotor was conducted at the Outdoor Aerodynamic Research Facility at Ames Research Center. The primary objective of the test was to obtain accurate measurements of the hover performance of the original, metal-blade XV-15 rotor system. Data were acquired for rotor tip Mach numbers ranging from 0.60 to 0.73. This report presents data on rotor performance, rotor wake downwash velocities, and rotor loads
Performance and loads data from a hover test of a 0.658-scale V-22 rotor and wing
A hover test of a 0.658-scale model of a V-22 rotor and wing was conducted at the Outdoor Aerodynamic Research Facility at Ames Research Center. The primary objectives of the test were to obtain accurate measurements of the hover performance of the rotor system, and to measure the aerodynamic interactions between the rotor and wing. Data were acquired for rotor tip Mach numbers ranging from 0.1 to 0.73. This report presents data on rotor performance, rotor-wake downwash velocities, rotor system loads, wing forces and moments, and wing surface pressures
Localization of Two-dimensional Electron Gas in LaAlO3/SrTiO3 Heterostructures
We report strong localization of 2D electron gas in LaAlO3 / SrTiO3 epitaxial
thin-film heterostructures grown on (LaAlO3)0.3-(Sr2AlTaO3)0.7 substrates by
using pulsed laser deposition with in-situ reflection high-energy electron
diffraction. Using longitudinal and transverse magnetotransport measurements,
we have determined that disorder at the interface influences the conduction
behavior, and that increasing the carrier concentration by growing at lower
oxygen partial pressure changes the conduction from strongly localized at low
carrier concentration to metallic at higher carrier concentration, with
indications of weak localization. We interpret this behavior in terms of a
changing occupation of Ti 3d bands near the interface, each with a different
spatial extent and susceptibility to localization by disorder, and differences
in carrier confinement due to misfit strain and point defects.Comment: 12 pages, 4 figure
Performance and loads data from a hover test of a full-scale advanced technology XV-15 rotor
A hover test of a full-scale, composite, advanced technology XV-15 rotor was conducted at the Outdoor Aerodynamic Research Facility at Ames Research Center. The primary objective of the test was to obtain accurate measurements of the hover performance of this rotor system. Data were acquired for rotor tip Mach numbers ranging from 0.35 to 0.73. The rotor was tested with several alternate blade root and blade-tip configurations. Data are presented on rotor performance, rotor-wake downwash velocities, and rotor system loads
Improved cache performance in Monte Carlo transport calculations using energy banding
We present an energy banding algorithm for Monte Carlo (MC) neutral particle transport simulations which depend on large cross section lookup tables. In MC codes, read-only cross section data tables are accessed frequently, exhibit poor locality, and are typically too much large to fit in fast memory. Thus, performance is often limited by long latencies to RAM, or by off-node communication latencies when the data footprint is very large and must be decomposed on a distributed memory machine. The proposed energy banding algorithm allows maximal temporal reuse of data in band sizes that can flexibly accommodate different architectural features. The energy banding algorithm is general and has a number of benefits compared to the traditional approach. In the present analysis we explore its potential to achieve improvements in time-to-solution on modern cache-based architectures.United States. Department of Energy. Office of Science (Contract DE-AC02-06CH11357
Liraglutide and weight loss among patients with advanced heart failure and a reduced ejection fraction: Insights from the FIGHT trial
Combined coronary and late-enhanced multidetector-computed tomography for delineation of the etiology of left ventricular dysfunction: comparison with coronary angiography and contrast-enhanced cardiac magnetic resonance imaging
AIMS: To evaluate whether comprehensive evaluation of coronary anatomy and delayed enhancement (DE) by multidetector-computed tomography (MDCT) would allow determination of etiology of left ventricular dysfunction (LVD) as compared with coronary angiography (CA) and DE-magnetic resonance (CMR). METHODS AND RESULTS: Seventy-one consecutive patients (50 males, 59 +/- 16 years) with LVD (ejection fraction: 26 +/- 11%) of unknown etiology underwent MDCT, LGE (late Gd-DTPA-enhanced)-CMR and CA. Patients were classified into four groups according to coronary artery disease (CAD) by CA and LGE-CMR patterns. Patients (n = 24) with CAD and transmural or sub-endocardial DE by CMR were considered having definite ischaemic LVD (group 1). Patients (n = 36) without CAD by CA and with no/atypical LGE-CMR were considered non-ischaemic LVD (group 2). Further we identified four patients with transmural DE but no CAD (group 3) and seven patients with CAD but no DE (group 4). On per-patient basis, combined coronary and DE-MDCT had excellent agreement (kappa = 0.89; P < 0.001) with CA/LGE-CMR to classify patients into the same four groups. Sensitivity, specificity and accuracy of MDCT were 97, 92 and 94%, respectively for detecting patients with definite (group 1) or likely (groups 3 and 4) ischaemic LVD. CONCLUSION: Combined coronary and DE-MDCT can accurately differentiate ischaemic vs. non-ischaemic etiology of LVD
Acute treatment with omecamtiv mecarbil to increase contractility in acute heart failure
Background:
Omecamtiv mecarbil (OM) is a selective cardiac myosin activator that increases myocardial function in healthy volunteers and in patients with chronic heart failure.
Objectives:
This study evaluated the pharmacokinetics, pharmacodynamics, tolerability, safety, and efficacy of OM in patients with acute heart failure (AHF).
Methods:
Patients admitted for AHF with left ventricular ejection fraction ≤40%, dyspnea, and elevated plasma concentrations of natriuretic peptides were randomized to receive a double-blind, 48-h intravenous infusion of placebo or OM in 3 sequential, escalating-dose cohorts.
Results:
In 606 patients, OM did not improve the primary endpoint of dyspnea relief (3 OM dose groups and pooled placebo: placebo, 41%; OM cohort 1, 42%; cohort 2, 47%; cohort 3, 51%; p = 0.33) or any of the secondary outcomes studied. In supplemental, pre-specified analyses, OM resulted in greater dyspnea relief at 48 h (placebo, 37% vs. OM, 51%; p = 0.034) and through 5 days (p = 0.038) in the high-dose cohort. OM exerted plasma concentration-related increases in left ventricular systolic ejection time (p < 0.0001) and decreases in end-systolic dimension (p < 0.05). The adverse event profile and tolerability of OM were similar to those of placebo, without increases in ventricular or supraventricular tachyarrhythmias. Plasma troponin concentrations were higher in OM-treated patients compared with placebo (median difference at 48 h, 0.004 ng/ml), but with no obvious relationship with OM concentration (p = 0.95).
Conclusions:
In patients with AHF, intravenous OM did not meet the primary endpoint of dyspnea improvement, but it was generally well tolerated, it increased systolic ejection time, and it may have improved dyspnea in the high-dose group. (Acute Treatment with Omecamtiv Mecarbil to Increase Contractility in Acute Heart Failure [ATOMIC-AHF]; NCT01300013)
Tailoring a two-dimensional electron gas at the LaAlO3/SrTiO3 (001) interface by epitaxial strain
Recently a metallic state was discovered at the interface between insulating
oxides, most notably LaAlO3 and SrTiO3. Properties of this two-dimensional
electron gas (2DEG) have attracted significant interest due to its potential
applications in nanoelectronics. Control over this carrier density and mobility
of the 2DEG is essential for applications of these novel systems, and may be
achieved by epitaxial strain. However, despite the rich nature of strain
effects on oxide materials properties, such as ferroelectricity, magnetism, and
superconductivity, the relationship between the strain and electrical
properties of the 2DEG at the LaAlO3/SrTiO3 heterointerface remains largely
unexplored. Here, we use different lattice constant single crystal substrates
to produce LaAlO3/SrTiO3 interfaces with controlled levels of biaxial epitaxial
strain. We have found that tensile strained SrTiO3 destroys the conducting
2DEG, while compressively strained SrTiO3 retains the 2DEG, but with a carrier
concentration reduced in comparison to the unstrained LaAlO3/SrTiO3 interface.
We have also found that the critical LaAlO3 overlayer thickness for 2DEG
formation increases with SrTiO3 compressive strain. Our first-principles
calculations suggest that a strain-induced electric polarization in the SrTiO3
layer is responsible for this behavior. It is directed away from the interface
and hence creates a negative polarization charge opposing that of the polar
LaAlO3 layer. This both increases the critical thickness of the LaAlO3 layer,
and reduces carrier concentration above the critical thickness, in agreement
with our experimental results. Our findings suggest that epitaxial strain can
be used to tailor 2DEGs properties of the LaAlO3/SrTiO3 heterointerface
- …