1,655 research outputs found
California Energy Commission Agricultural Peak Load Reduction Program Case Study: Kaweah River Power Authority and Tulare ID
Tulare Irrigation District (TID) is located on the east side of the Central San Joaquin Valley just south of Visalia, CA. The district receives water from Lake Kaweah through Terminus Dam as well as from the Friant-Kern Canal. TID is the single largest partner in the Kaweah River Power Authority (KRPA), which operates Terminus Dam and regulates the discharge from Lake Kaweah
Chemigation and Fertigation Basics for California
Chemigation is the application of any chemical through an irrigation system. Examples of chemicals include insecticides, fungicides, fertilizers, water amendments, soil amendments, and compounds used to reduce plugging of drip emitters. Proper chemigation reduces energy consumption (less fertilizer, chemicals, and tractor travel) and improves crop quality and yields.
Fertigation accounts for the majority of chemigation. The sophistication of fertigation knowledge and practices is at about the same level as drip/microirrigation was in the mid-1970s. A lot of equipment and chemicals exist, and many farmers use fertigation, but only a relatively small percentage of those farmers are sophisticated users
Benchmarking Irrigation
A few performance indicators (e.g., “efficiency”) have been included in irrigation jargon for many decades. However, at the Rome meeting we will have a comprehensive discussion on irrigation benchmarking. It will be easy to fall into a discussion of definitions and specifics. Prior to that, it might be helpful to consider the following aspects that will help to set the stage for the details
Oiler for Vertical Pump Lineshaft Lubrication
This document provides technical advice for controlling the dripping of oil for oil-lubricated vertical lineshaft pumps for irrigation
Irrigation District Observations on Large Diameter, Low Pressure Pipeline Materials
There are approximately 1,400 miles of low pressure non-reinforced cast-in-place ( monolithic or CIP ) concrete pipe in California irrigation districts. Cast-in-place pipe was irrigation districts’ material of choice for large diameter pipelines from 1930 to at least 1980. Many of these pipelines were installed in the early 1900’s. They are predominately found on the east side of the San Joaquin Valley, from Manteca in the north to Visalia in the south. Most of these pipes are deteriorating and will need to be replaced within the next 10-20 years.
Irrigation districts have attempted to find new ways to repair these pipes. However, their uneven dimensions (they were often made with crude local installation equipment), high density of repairs (meaning that the pipe wall thicknesses and cross sections now vary), numerous connections, and non-linear placement have ruled out using available pipe liner technology. The cost to line these pipes is about the same as the cost to completely replace them.
Due to the high replacement cost and need for repair, the last decade has seen a switch away from cast-in-place pipelines to pipelines of other materials. However, up until now there has been no general consensus as to the best replacement option. In November 2002, the California Polytechnic State University (Cal Poly) Irrigation Training and Research Center (ITRC) met at Madera ID with representatives from eight irrigation districts and one engineering firm to discuss reasons for switching types of pipes, and what alternative materials might be available
Where is all that Water Going?
Some have proposed to conserve 4-6 Million AF/yr in Agriculture with pragmatic, economical measures. All we need to do is find the inefficiencies. Then we\u27ll get rid of them
General Irrigation Consumer Bill of Rights
Cal Poly ITRC, together with various irrigation industry leaders and the Irrigation Dealers Association of California, plus with assistance from the California Energy Commission and Pacific Gas & Electric Co., developed the Irrigation Consumer Bill of Rights (ICBR) in 1994
Adjustable Magnetic Coupler
Efficiency in terms of power consumption is vital and continues to be increasingly important. The use of adjustable speed pumps can reduce energy consumption and improve controllability of pressure or flows. One such technology, the MagnaDrive coupler, has been developed for service in a variety of applications
Actuators for Sluice Gates — Alternatives to Commercially Available Products
Gate actuators provide a method of raising and lowering canal gates using electric motors instead of human power. ITRC has investigated four alternatives to commercially available actuators designed specifically for the operation of canal gates
Canal Lining
Larry and I thought that some musings about canal lining might be of some interest for some of you USCID newsletter readers. As you know, there are many canal lining techniques – especially if one considers the wide assortment of internationally used lining methods
- …