55 research outputs found
Characterisation of Medipix3 Silicon Detectors in a Charged-Particle Beam
While designed primarily for X-ray imaging applications, the Medipix3 ASIC
can also be used for charged-particle tracking. In this work, results from a
beam test at the CERN SPS with irradiated and non-irradiated sensors are
presented and shown to be in agreement with simulation, demonstrating the
suitability of the Medipix3 ASIC as a tool for characterising pixel sensors.Comment: 16 pages, 13 figure
FastIC: a fast integrated circuit for the readout of high performance detectors
This work presents the 8-channel FastIC ASIC developed in CMOS 65 nm technology suitable for the readout of positive and negative polarity sensors in high energy physics experiments, Cherenkov detectors and time-of-flight systems. The front-end can be configured to perform analog summation of up to 4 single-ended channels before discrimination in view of improving time resolution when segmenting a SiPM. The outputs encode the time-of-arrival information and linear energy measurement which captures the peak amplitude of the input signal in the 5 µA–25 mA input peak current range. Power consumption of the ASIC is 12 mW/ch with default settings. Measurements of single photon time resolution with a red-light laser source and a HPK SiPM S13360-3050CS are ≈140 ps FWHM
Studies of the spectral and angular distributions of transition radiation using a silicon pixel sensor on a Timepix3 chip
The studies presented in this paper also show that simultaneous measurements of both the energy and the emission angles of the TR X-rays could be used to enhance the particle identification performances of TRD
Registration of the transition radiation with GaAs detector: Data/MC comparison
New developments of pixel detectors based on GaAs sensors offer effective registration of the transition radiation (TR) X-rays and perform simultaneous measurements of their energies and emission angles. This unique feature opens new possibilities for particle identi cation on the basis of maximum available information about generated TR photons. Results of studies of TR energy-angular distributions using a 500 qm thick GaAs sensor attached to a Timepix3 chip are presente
Identification of particles with Lorentz factor up to with Transition Radiation Detectors based on micro-strip silicon detectors
This work is dedicated to the study of a technique for hadron identification
in the TeV momentum range, based on the simultaneous measurement of the
energies and of the emission angles of the Transition Radiation (TR) X-rays
with respect to the radiating particles. A detector setup has been built and
tested with particles in a wide range of Lorentz factors (from about to
about crossing different types of radiators. The measured
double-differential (in energy and angle) spectra of the TR photons are in a
reasonably good agreement with TR simulation predictions.Comment: 31 pages, 12 figures, paper published on Nuclear Instruments &
Methods
Review of hybrid pixel detector readout ASICs for spectroscopic X-ray imaging
Semiconductor detector readout chips with pulse processing electronics have made possible spectroscopic X-ray imaging, bringing an improvement in the overall image quality and, in the case of medical imaging, a reduction in the X-ray dose delivered to the patient. In this contribution we review the state of the art in semiconductor-detector readout ASICs for spectroscopic X-ray imaging with emphasis on hybrid pixel detector technology. We discuss how some of the key challenges of the technology (such as dealing with high fluxes, maintaining spectral fidelity, power consumption density) are addressed by the various ASICs. In order to understand the fundamental limits of the technology, the physics of the interaction of radiation with the semiconductor detector and the process of signal induction in the input electrodes of the readout circuit are described. Simulations of the process of signal induction are presented that reveal the importance of making use of the small pixel effect to minimize the impact of the slow motion of holes and hole trapping in the induced signal in high-Z sensor materials. This can contribute to preserve fidelity in the measured spectrum with relatively short values of the shaper peaking time. Simulations also show, on the other hand, the distortion in the energy spectrum due to charge sharing and fluorescence photons when the pixel pitch is decreased. However, using recent measurements from the Medipix3 ASIC, we demonstrate that the spectroscopic information contained in the incoming photon beam can be recovered by the implementation in hardware of an algorithm whereby the signal from a single photon is reconstructed and allocated to the pixel with the largest deposition
Infrastructure for Detector Research and Development towards the International Linear Collider
The EUDET-project was launched to create an infrastructure for developing and
testing new and advanced detector technologies to be used at a future linear
collider. The aim was to make possible experimentation and analysis of data for
institutes, which otherwise could not be realized due to lack of resources. The
infrastructure comprised an analysis and software network, and instrumentation
infrastructures for tracking detectors as well as for calorimetry.Comment: 54 pages, 48 picture
Registration of the transition radiation with GaAs detector: Data/MC comparison
New developments of pixel detectors based on GaAs sensors offer effective registration of the transition radiation (TR) X-rays and perform simultaneous measurements of their energies and emission angles. This unique feature opens new possibilities for particle identification on the basis of maximum available information about generated TR photons. Results of studies of TR energy-Angular distributions using a 500 |j.m thick GaAs sensor attached to a Timepix3 chip are presented. Measurements, analysis techniques and a comparison with Monte Carlo (MC) simulations are described and discussed
Detector Technologies for CLIC
The Compact Linear Collider (CLIC) is a high-energy high-luminosity linear
electron-positron collider under development. It is foreseen to be built and
operated in three stages, at centre-of-mass energies of 380 GeV, 1.5 TeV and 3
TeV, respectively. It offers a rich physics program including direct searches
as well as the probing of new physics through a broad set of precision
measurements of Standard Model processes, particularly in the Higgs-boson and
top-quark sectors. The precision required for such measurements and the
specific conditions imposed by the beam dimensions and time structure put
strict requirements on the detector design and technology. This includes
low-mass vertexing and tracking systems with small cells, highly granular
imaging calorimeters, as well as a precise hit-time resolution and power-pulsed
operation for all subsystems. A conceptual design for the CLIC detector system
was published in 2012. Since then, ambitious R&D programmes for silicon vertex
and tracking detectors, as well as for calorimeters have been pursued within
the CLICdp, CALICE and FCAL collaborations, addressing the challenging detector
requirements with innovative technologies. This report introduces the
experimental environment and detector requirements at CLIC and reviews the
current status and future plans for detector technology R&D.Comment: 152 pages, 116 figures; published as CERN Yellow Report Monograph
Vol. 1/2019; corresponding editors: Dominik Dannheim, Katja Kr\"uger, Aharon
Levy, Andreas N\"urnberg, Eva Sickin
- …