4 research outputs found

    Ultra-fast current aided sintering of high coercive magnetic powders and composites

    Get PDF
    The paper refers to pulverization and sintering of the (Fe80Nb6B14)0.88Tb0.12 high coercive alloy. The powder was sintered using the ultra-fast current aided method. It turned out that too long discharge time leads to appearing of a soft magnetic phase and simultaneously, decrease in coercivity of the compacted powder. Nevertheless, it was possible to establish preference technology parameters, preserving magnetic hardness of the alloy. As a final test, an impact of Co-powder addition on magnetic properties was studied. The introduced soft magnetic phase (about 20 wt. %) caused about 30% increase of magnetic remanence, which is a result of direct exchange interactions between the two phases

    Типовая учебная программа по учебной дисциплине для специальности: 1-23 01 08 Журналистика (по направлениям), направление специальности 1-23 01 08-02 Журналистика (аудиовизуальная)

    Get PDF
    Enhancement of soft magnetic properties in the selected group of amorphous alloys was examined by different experimental methods. It was shown that permeability for annealed samples (at Ta for 1 h; 300 K < Ta < 900 K) plotted vs. Ta shows a maximum at which is 700, 725, 725, and 750 K for Fe82Nb2B14Y2, Fe82Nb2B14Gd2, Fe82Nb2B14Tb2 and Fe82Nb2B14Dy2 alloy, respectively. For samples after the optimization annealing permeability is at least 10 times higher than in the as-quenched state. The optimized microstructure is free of iron nanograins and corresponds to so-called relaxed amorphous phase

    Microstructure and magnetism of Co2FeAl Heusler alloy prepared by arc and induction melting compared with planar flow casting

    Get PDF
    This paper is devoted to investigations of the structural and magnetic properties of the Co2FeAl Heusler alloy produced by three technologies. The alloys prepared by arc and induction melting have resulted in coarse-grained samples in contrast to the fine-grained ribbon-type sample prepared by planar flow casting. Scanning electron microscopy completed by energy dispersive X-ray spectroscopy, X-ray diffraction, Mössbauer spectroscopy, and magnetic methods sensitive to both bulk and surface were applied. The chemical composition was slightly different from the nominal only for the ribbon sample. From the viewpoint of magnetic properties, the bulk coercivity and remnant magnetization have followed the structure influenced by the technology used. Saturation magnetization was practically the same for samples prepared by arc and induction melting, whereas the magnetization of ribbon is slightly lower due to a higher Al content at the expense of iron and cobalt. The surface magnetic properties were markedly influenced by anisotropy, grain size, and surface roughness of the samples. The surface roughness and brittleness of the ribbon-type sample did not make domain structure observation possible. The other two samples could be well polished and their highly smooth surface has enabled domain structure visualization by both magneto-optical Kerr microscopy and magnetic force microscopy
    corecore