480 research outputs found

    Identifying the common interaction networks of amoeboid motility and cancer cell metastasis

    Get PDF
    The recently analyzed genome of Naegleria gruberi, a free-living amoeboflagellate of the Heterolobosea clade, revealed a remarkably complex ancestral eukaryote with a rich repertoire of cytoskeletal-, motility- and signaling-genes. This protist, which diverged from other eukaryotic lineages over a billion years ago, possesses the ability for both amoeboid and flagellar motility. In a phylogenomic comparison of two free living eukaryotes with large proteomic datasets of three metastatic tumour entities (malignant melanoma, breast- and prostate-carcinoma), we find common proteins with potential importance for cell motility and cancer cell metastasis. To identify the underlying signaling modules, we constructed for each tumour type a protein-protein interaction network including these common proteins. The connectivity within this interactome revealed specific interactions and pathways which constitute prospective points of intervention for novel anti-metastatic tumour therapies

    Numerical simulation of GE 7001 EA gas turbine using experimental data for compressor inlet air cooling

    Get PDF
    Paper presented to the 10th International Conference on Heat Transfer, Fluid Mechanics and Thermodynamics, Florida, 14-16 July 2014.In this paper computer Simulation of GE 7001 EA gas turbine that widely used in the kingdom of Saudi Arabia is reported. Simulation is done using cooled air data obtained previously from different experiments. These data are used as input to the compressor to see its effect on the output power and efficiency of the gas turbine. GE 7001EA gas turbine, (GE7121EA models) is simulated using THERMOFLEX software. The specifications of this type of turbines are built in this software. This type of gas turbine model is used in Riyadh and Taif power stations. ISO conditions and actual weather conditions are used for simulations. The results show that the maximum increase in the net power output is about 12, 6 and 5.8% depend on the used cooling data. On the other hand, the maximum percentage increase in efficiency is turned to about 2.5, 1.3 and 0.9 respectively.cf201

    Massive sublingual hematoma secondary to anticoagulant therapy complicated by a traumatic denture: a case report

    Get PDF
    <p>Abstract</p> <p>Introduction</p> <p>Sublingual hematoma secondary to excessive anticoagulation is a rare but potentially fatal condition, and few cases have been documented in the literature.</p> <p>Case presentation</p> <p>We report the case of a 73-year-old Caucasian woman who attended our Accident and Emergency department with massive sublingual hematoma causing superior displacement of the tongue. The condition was found to be the result of an elevated international normalized ratio, further complicated by a traumatic mandibular denture.</p> <p>Conclusions</p> <p>In summary, we recommend the immediate reversal of anticoagulation therapy on admission of patients with severe sublingual hematoma. We further advise surgical decompression/drainage if required and to continue meticulous monitoring. In all cases of early recognition of sublingual hematoma, prompt medical treatment and continuous clinical monitoring is essential, and may prevent the need for a surgical airway procedure.</p

    Risk compensation during COVID-19: The impact of face mask usage on social distancing

    Get PDF
    This is the author accepted manuscript. The final version is available from the American Psychological Association via the DOI in this recordTo reduce the spread of COVID-19, governments around the world have recommended or required minimum physical distancing between individuals, as well as either mandating or recommending the use of face coverings (masks) in certain circumstances. When multiple risk reduction activities can be adopted, people may engage in risk compensation by responding to a reduced (perceived) risk exposure due to one activity by increasing risk exposure due to another. We tested for risk compensation in two online experiments that investigated whether either wearing a mask or seeing others wearing masks reduced physical distancing. We presented participants with stylized images of everyday scenarios involving themselves with or without a mask and a stranger with or without a mask. For each scenario, participants indicated the minimum distance they would keep from the stranger. In line with risk compensation, we found that participants indicated they would stand, sit, or walk closer to the stranger if either of them was wearing a mask. This form of risk compensation was stronger for those who believed masks were effective at preventing catching or spreading COVID-19, and for younger (18-40 years) compared to older (over 65 years) participants. (PsycInfo Database Record (c) 2022 APA, all rights reserved).Economic and Social Research Council (ESRC

    Assessment of mitral bioprostheses using cardiovascular magnetic resonance

    Get PDF
    <p>Abstract</p> <p>Background</p> <p>The orifice area of mitral bioprostheses provides important information regarding their hemodynamic performance. It is usually calculated by transthoracic echocardiography (TTE), however, accurate and reproducible determination may be challenging. Cardiovascular magnetic resonance (CMR) has been proven as an accurate alternative for assessing aortic bioprostheses. However, whether CMR can be similarly applied for bioprostheses in the mitral position, particularly in the presence of frequently coincident arrhythmias, is unclear. The aim of the study is to test the feasibility of CMR to evaluate the orifice area of mitral bioprostheses.</p> <p>Methods</p> <p>CMR planimetry was performed in 18 consecutive patients with mitral bioprostheses (n = 13 Hancock<sup>®</sup>, n = 4 Labcore<sup>®</sup>, n = 1 Perimount<sup>®</sup>; mean time since implantation 4.5 ± 3.9 years) in an imaging plane perpendicular to the transprosthetic flow using steady-state free-precession cine imaging under breath-hold conditions on a 1.5T MR system. CMR results were compared with pressure half-time derived orifice areas obtained by TTE.</p> <p>Results</p> <p>Six subjects were in sinus rhythm, 11 in atrial fibrillation, and 1 exhibited frequent ventricular extrasystoles. CMR image quality was rated as good in 10, moderate in 6, and significantly impaired in 2 subjects. In one prosthetic type (Perimount<sup>®</sup>), strong stent artifacts occurred. Orifice areas by CMR (mean 2.1 ± 0.3 cm<sup>2</sup>) and TTE (mean 2.1 ± 0.3 cm<sup>2</sup>) correlated significantly (r = 0.94; p < 0.001). Bland-Altman analysis showed a 95% confidence interval from -0.16 to 0.28 cm<sup>2 </sup>(mean difference 0.06 ± 0.11 cm<sup>2</sup>; range -0.1 to 0.3 cm<sup>2</sup>). Intra- and inter-observer variabilities of CMR planimetry were 4.5 ± 2.9% and 7.9 ± 5.2%.</p> <p>Conclusions</p> <p>The assessment of mitral bioprostheses using CMR is feasible even in those with arrhythmias, providing orifice areas with close agreement to echocardiography and low observer dependency. Larger samples with a greater variety of prosthetic types and more cases of prosthetic dysfunction are required to confirm these preliminary results.</p

    Nanofluid impingement jet heat transfer

    Get PDF
    Experimental investigation to study the heat transfer between a vertical round alumina-water nanofluid jet and a horizontal circular round surface is carried out. Different jet flow rates, jet nozzle diameters, various circular disk diameters and three nanoparticles concentrations (0, 6.6 and 10%, respectively) are used. The experimental results indicate that using nanofluid as a heat transfer carrier can enhance the heat transfer process. For the same Reynolds number, the experimental data show an increase in the Nusselt numbers as the nanoparticle concentration increases. Size of heating disk diameters shows reverse effect on heat transfer. It is also found that presenting the data in terms of Reynolds number at impingement jet diameter can take into account on both effects of jet heights and nozzle diameter. Presenting the data in terms of Peclet numbers, at fixed impingement nozzle diameter, makes the data less sensitive to the percentage change of the nanoparticle concentrations. Finally, general heat transfer correlation is obtained verses Peclet numbers using nanoparticle concentrations and the nozzle diameter ratio as parameters

    Development of a few TW Ti:Sa laser system at 100 Hz for proton acceleration

    Full text link
    [EN] We report the development of a table-top high peak power Titanium:Sapphire (Ti:Sa) CPA laser working at 100 Hz capable of delivering 205 mJ, 55 fs pulses. Every amplification stage is pumped by Nd-doped solid-state lasers and fully powered by diodes. Thermal effects in the Ti:Sa amplifiers are compensated passively with optics. This system is intended to be used for proton acceleration experiments at high repetition rates.Centro para el Desarrollo Tecnológico Industrial (CDTI, Spain) within the INNPRONTA program, Grant no. IPT-20111027.Lera, R.; Bellido-Millán, PJ.; Sánchez, I.; Mur, P.; Seimetz, M.; Benlloch Baviera, JM.; Roso, L.... (2019). Development of a few TW Ti:Sa laser system at 100 Hz for proton acceleration. Applied Physics B. 125(1):1-8. https://doi.org/10.1007/s00340-018-7113-8S181251P. Zeitoun, G. Faivre, S. Sebban, T. Mocek, A. Hallou, M. Fajardo, D. Aubert, P. Balcou, F. Burgy, D. Douillet, S. Kazamias, G. de Lachèze-Murel, T. Lefrou, S. le Pape, P. Mercère, H. Merdji, A.S. Morlens, J.P. Rousseau, C. Valentin, Nature 431(7007), 426–429 (2004)V. Malka, S. Fritzler, E. Lefebvre, M.-M. Aleonard, F. Burgy, J.-P. Chambaret, J.-F. Chemin, K. Krushelnick, G. Malka, S.P.D. Mangles, Z. Najmudin, M. Pittman, J.-P. Rousseau, J.-N. Scheurer, B. Walton, A.E. Dangor, Science 298(5598), 1596–1600 (2002)H. Daido, M. Nishiuchi, A.S. Pirozhkov, Rep. Progress Phys. 75(5), 056401 (2012)A. Macchi, M. Borghesi, M. Passoni, Rev. Mod. Phys. 85, 751–793 (2013)T. Tajima, J.M. Dawson, Phys. Rev. Lett. 43, 267–270 (1979)M. Noaman-ul Haq, H. Ahmed, T. Sokollik, L. Yu, Z. Liu, X. Yuan, F. Yuan, M. Mirzaie, X. Ge, L. Chen, J. Zhang, Phys. Rev. Accel. Beams 20, 041301 (2017)D. Strickland, G. Mourou, Opt. Commun. 53(3), 219–221 (1985)G. Cheriaux, B. Walker, L.F. Dimauro, P. Rousseau, F. Salin, J.P. Chambaret, Opt. Lett. 21(6), 414–416 (1996)P. Tournois, Opt. Commun. 140(4), 245–249 (1997)R. Soulard, A. Brignon, S. Raby, E. Durand, R. Moncorgé, Appl. Phys. B 106(2), 295–300 (2012)J. Liu, L. Ge, L. Feng, H. Jiang, H. Su, T. Zhou, J. Wang, Q. Gao, J. Li, Chin. Opt. Lett. 14(5), 051404 (2016)A. Maleki, M.K. Tehrani, H. Saghafifar, M.H.M. Dindarlu, H. Ebadian, Laser Phys. 26(2), 025003 (2016)R. Lera, F. Valle-Brozas, S. Torres-Peiró, A.R. de-la Cruz, M. Galán, P. Bellido, M. Seimetz, J.M. Benlloch, L. Roso, Appl. Opt. 55(33), 9573–9576 (2016)R. Lausten, P. Balling, J. Opt. Soc. Am. B 20(7), 1479–1485 (2003)I. Nam, M. Kim, T.H. Lee, S.W. Lee, H. Suk, Curr. Appl. Phys. 15(4), 468–472 (2015)E. Treacy, IEEE J. Quantum Electron. 5(9), 454–458 (1969)A. Trisorio, S. Grabielle, M. Divall, N. Forget, C.P. Hauri, Opt. Lett. 37(14), 2892–2894 (2012)Y.-H. Cha, Y.-W. Lee, S.M. Nam, J.M. Han, Y.J. Rhee, B.D. Yoo, B.C. Lee, Y.U. Jeong, Appl. Opt. 46(28), 6854–6858 (2007)P. Bellido, R. Lera, M. Seimetz, A.R. de la Cruz, S. Torres-Peiró, M. Galán, P. Mur, I. Sánchez, R. Zaffino, L. Vidal, A. Soriano, S. Sánchez, F. Sánchez, M. Rodríguez-Álvarez, J. Rigla, L. Moliner, A. Iborra, L. Hernández, D. Grau-Ruiz, A. González, J. García-Garrigos, E. Díaz-Caballero, P. Conde, A. Aguilar, L. Roso, J. Benlloch, J. Instrum. 12(05), T05001 (2017
    corecore