653 research outputs found
Physical and microstructural impacts on the hydro-mechanical behaviour of Ypresian clays
International audienceAn experimental characterisation on Ypresian clays that are considered as one of the potential geological host formations for the radioactive waste disposal in Belgium has been carried out. Physical, microstructural, hydraulic and mechanical properties were investigated on the samples taken from a cored borehole at Kallo in the Northern Belgium at 290-400 m depth. Identification tests, scanning electron microscopy (SEM), mercury intrusion porosimetry (MIP) and oedometer tests were performed. The results obtained showed that Ypresian clays are highly plastic (large values of consistence limits, specific surface, blue ethylene value) and of relatively low density, in relation to their high swelling clay content. In addition, their physical and mineralogical properties present significant variations over depth. Two microstructural arrangements, matrix-type and aggregate-type respectively for the depths with higher and lower swelling content, were identified. The former exhibits bi-modal porosity while the latter shows a common deep sediment mono-modal porosity but with a larger dominant pore size. The permeability of the clays with matrix-type microstructure is significantly lower than that with aggregate-type despite their higher void ratio. Moreover, these microstructural features result in the initial unsaturated state of Ypresian clays sample. Typical hysteretic unloading-reloading loops are identified on both low- and high-pressure oedometer tests that can be explained by a microstructure-based swelling stress concept. The variation of this swelling stress with the corresponding initial void ratio over depth perfectly reflects the physical variations and is consistent with that of swelling stress determined from common swelling tests. The yield stress ratios are slightly higher than the over-consolidation ratio, suggesting negligible effects of diagenesis, cambering and valley bulging etc. The variations of compression index, compression and swelling slopes are consistent with the physical and microstructural variations
The CDF dijet excess from intrinsic quarks
The CDF collaboration reported an excess in the production of two jets in
association with a . We discuss constraints on possible new particle state
interpretations of this excess. The fact of no statistically significant
deviation from the SM expectation for {+dijet} events in CDF data disfavors
the new particle explanation. We show that the nucleon intrinsic strange quarks
provide an important contribution to the boson production in association
with a single top quark production. Such {+t} single top quark production
can contribute to the CDF {+dijet} excess, thus the nucleon intrinsic quarks
can provide a possible explanation to the CDF excess in {+dijet} but not in
{+dijet} events.Comment: 4 latex pages, 1 figure. Version for journal publicatio
Pulsar Timing and its Application for Navigation and Gravitational Wave Detection
Pulsars are natural cosmic clocks. On long timescales they rival the
precision of terrestrial atomic clocks. Using a technique called pulsar timing,
the exact measurement of pulse arrival times allows a number of applications,
ranging from testing theories of gravity to detecting gravitational waves. Also
an external reference system suitable for autonomous space navigation can be
defined by pulsars, using them as natural navigation beacons, not unlike the
use of GPS satellites for navigation on Earth. By comparing pulse arrival times
measured on-board a spacecraft with predicted pulse arrivals at a reference
location (e.g. the solar system barycenter), the spacecraft position can be
determined autonomously and with high accuracy everywhere in the solar system
and beyond. We describe the unique properties of pulsars that suggest that such
a navigation system will certainly have its application in future astronautics.
We also describe the on-going experiments to use the clock-like nature of
pulsars to "construct" a galactic-sized gravitational wave detector for
low-frequency (f_GW ~1E-9 - 1E-7 Hz) gravitational waves. We present the
current status and provide an outlook for the future.Comment: 30 pages, 9 figures. To appear in Vol 63: High Performance Clocks,
Springer Space Science Review
Measurements of Cabibbo Suppressed Hadronic Decay Fractions of Charmed D0 and D+ Mesons
Using data collected with the BESII detector at storage ring
Beijing Electron Positron Collider, the measurements of relative branching
fractions for seven Cabibbo suppressed hadronic weak decays ,
, and , , and are presented.Comment: 11 pages, 5 figure
The pole in
Using a sample of 58 million events recorded in the BESII detector,
the decay is studied. There are conspicuous
and signals. At low mass, a large
broad peak due to the is observed, and its pole position is determined
to be - MeV from the mean of six analyses.
The errors are dominated by the systematic errors.Comment: 15 pages, 6 figures, submitted to PL
Direct Measurements of Absolute Branching Fractions for D0 and D+ Inclusive Semimuonic Decays
By analyzing about 33 data sample collected at and around 3.773
GeV with the BES-II detector at the BEPC collider, we directly measure the
branching fractions for the neutral and charged inclusive semimuonic decays
to be and , and determine the ratio of the two branching
fractions to be
A study of charged kappa in
Based on events collected by BESII, the decay
is studied. In the invariant mass
spectrum recoiling against the charged , the charged
particle is found as a low mass enhancement. If a Breit-Wigner function of
constant width is used to parameterize the kappa, its pole locates at MeV/. Also in this channel,
the decay is observed for the first time.
Its branching ratio is .Comment: 14 pages, 4 figure
Measurements of the observed cross sections for exclusive light hadron production in e^+e^- annihilation at \sqrt{s}= 3.773 and 3.650 GeV
By analyzing the data sets of 17.3 pb taken at GeV
and 6.5 pb taken at GeV with the BESII detector at the
BEPC collider, we have measured the observed cross sections for 12 exclusive
light hadron final states produced in annihilation at the two energy
points. We have also set the upper limits on the observed cross sections and
the branching fractions for decay to these final states at 90%
C.L.Comment: 8 pages, 5 figur
A dual-mode mm-wave injection-locked frequency divider with greater than 18% locking range in 65nm CMOS
Only abstrac
Measurements of J/psi Decays into 2(pi+pi-)eta and 3(pi+pi-)eta
Based on a sample of 5.8X 10^7 J/psi events taken with the BESII detector,
the branching fractions of J/psi--> 2(pi+pi-)eta and J/psi-->3(pi+pi-)eta are
measured for the first time to be (2.26+-0.08+-0.27)X10^{-3} and
(7.24+-0.96+-1.11)X10^{-4}, respectively.Comment: 11 pages, 6 figure
- …
