11,387 research outputs found
Multiple-Access Bosonic Communications
The maximum rates for reliably transmitting classical information over
Bosonic multiple-access channels (MACs) are derived when the transmitters are
restricted to coherent-state encodings. Inner and outer bounds for the ultimate
capacity region of the Bosonic MAC are also presented. It is shown that the
sum-rate upper bound is achievable with a coherent-state encoding and that the
entire region is asymptotically achievable in the limit of large mean input
photon numbers.Comment: 11 pages, 5 figures, corrected two figures, accepted for publication
in Phys. Rev.
Recommended from our members
The Characteristics and Applications of Ceramic Laser Fusion and Ceramic Laser Sintering
The aim of present study is to investigate the possible application of the ceramic parts
which are fabricated with the process of Ceramic Laser Fusion or Ceramic Laser Sintering.
The experimental results reveal: (1) CLF can lead to a reduction in the porosity of the
ceramic part but also can induce micro-cracks. Therefore, this process cannot produce a part
with the required strength by a post-process of infiltration; (2) CLS is capable of fabricating a
ceramic part with high porosity. By adjusting the slurry formulation and varying the scanning
energy, the open porosity can be over 90vol% of the total porosity. After a post-process of
infiltration, the density can be increased to 95%; therefore, CLS can apply to produce a part
with high strength. Because the high open porosity leads to a good permeability, the process
of CLS is suitable for the fabrication of ceramic shell mold.Mechanical Engineerin
GaAs-GaAlAs distributed-feedback diode lasers with separate optical and carrier confinement
Remarkable reduction of the threshold current density is achieved in GaAs-GaAlAs distributed-feedback diode lasers by adopting a separate-confinement heterostructure. The diodes are lased successfully at temperatures up to 340 °K under pulsed operation. The lowest threshold current density is 3 kA/cm^2 at 300 °K
Plans for phase coherent long baseline interferometry for geophysical applications using the Anik-B communications satellite
A pilot project to establish an operational phase stable very long baseline interferometer (VLBI) for geophysical studies is described. Methods for implementation as well as practical applications are presented
Large strain actuation in barium titanate single crystals under stress and electric field
Large strain actuation in barium titanate (BaTiO3) single crystals subjected to combined uniaxial stress and electric field is examined. A maximum strain of about 0.45% is measured under a combined loading of 2.7 MPa compressive stress and ±1.25 MVm-1 cyclic electric field. Above 2.7 MPa, the crystal does not cycle fully between the in-plane and out-of-plane polarized states due to large compressive stress, and consequently, a considerable reduction in actuation strain is apparent. The hysteresis evolution of the crystal under combined electromechanical loading reveals incomplete switching characteristics and a considerable disproportion of slope gradients at zero electric field for the measured polarization and strain hysteresis curves. A likely cause for the disproportion of slope gradients is the cooperative operation of multiple 90° switching systems by which “polarization-free” strain changes are induced
- …