The Effect of Hot Deformation Parameters on Microstructure Evolution of the α-Phase in Ti-6Al-4V

The effect of high-temperature deformation and the influence of hot working parameters on microstructure evolution during isothermal hot forging of Ti-6Al-4V in the alpha phase field were investigated. A series of hot isothermal axis-symmetric compression tests were carried out at temperatures both low and high in the alpha stability field [(1153 K and 1223 K (880 °C and 950 °C), respectively], using three strain rates (0.01, 0.1 and 1.0/s) relevant to industrial press forging. The microstructures and orientation of the alpha laths were determined using optical microscopy and electron backscatter diffraction techniques. The experimental results show that there is a change in lath morphology of the secondary α phase under the influence of the deformation parameters, and that α lath thickness appears to have little influence on flow behavior

First measurement of direct f0(980)f_0(980) photoproduction on the proton

We report on the results of the first measurement of exclusive $f_0(980)$ meson photoproduction on protons for $E_\gamma=3.0 - 3.8$ GeV and $-t = 0.4-1.0$ GeV$^2$. Data were collected with the CLAS detector at the Thomas Jefferson National Accelerator Facility. The resonance was detected via its decay in the $\pi^+ \pi^-$ channel by performing a partial wave analysis of the reaction $\gamma p \to p \pi^+ \pi^-$. Clear evidence of the $f_0(980)$ meson was found in the interference between $P$ and $S$ waves at $M_{\pi^+ \pi^-}\sim 1$ GeV. The $S$-wave differential cross section integrated in the mass range of the $f_0(980)$ was found to be a factor of 50 smaller than the cross section for the $\rho$ meson. This is the first time the $f_0(980)$ meson has been measured in a photoproduction experiment