Sediment contaminant surveillance in Milford Haven Waterway

Sediment contaminants were monitored in Milford Haven Waterway (MHW) since 1978 (hydrocarbons) and 1982 (metals), with the aim of providing surveillance of environmental quality in one of the UK’s busiest oil and gas ports. This aim is particularly important during and after large-scale investment in liquefied natural gas (LNG) facilities. However, methods inevitably have changed over the years, compounding the difficulties of coordinating sampling and analytical programmes. After a review by the MHW Environmental Surveillance Group (MHWESG), sediment hydrocarbon chemistry was investigated in detail in 2010. Natural Resources Wales (NRW) contributed their MHW data for 2007 and 2012, collected to assess the condition of the Special Area of Conservation (SAC) designated under the European Union Habitats Directive. Datasets during 2007-2012 have thus been more comparable. The results showed conclusively that a MHW-wide peak in concentrations of sediment polycyclic aromatic hydrocarbons (PAHs), metals and other contaminants occurred in late 2007. This was corroborated by independent annual monitoring at one centrally-located station with peaks in early 2008 and 2011. The spatial and temporal patterns of recovery from the 2007 peak, shown by MHW-wide surveys in 2010 and 2012, indicate several probable causes of contaminant trends, as follows: atmospheric deposition, catchment runoff, sediment resuspension from dredging, and construction of two LNG terminals and a power station. Adverse biological effects predictable in 2007 using international sediment quality guidelines, were independently tested by data from monitoring schemes of more than a decade duration in MHW (starfish, limpets), and in the wider SAC (grey seals). Although not proving cause and effect, many of these potential biological receptors showed a simultaneous negative response to the elevated 2007 contamination following intense dredging activity in 2006. Wetland bird counts were typically at a peak in the winter of 2005-2006 previous to peak dredging. In the following winter 2006-2007, shelduck in Pembroke River showed their lowest winter count, and spring 2007 was the largest ever drop in numbers of broods across MHW between successive breeding seasons. Wigeon counts in Pembroke River were again low in late 2012 after further dredging nearby. These results are strongly supported by PAH data reported previously from invertebrate bioaccumulation studies in MHW 2007-2010, themselves closely reflecting sedimen

Late Cretaceous hydrothermal vent communities from the Troodos ophiolite, Cyprus: systematics and evolutionary significance

Modern hydrothermal vent communities are based on chemosynthesis by microbial primary producers. Molecular phylogenetic divergence estimates indicate that many of the dominant vent taxa arose during the Cenozoic and Cretaceous; however, the fossil record of vent communities from these time periods is poor. One occurrence of such Cretaceous vent communities pertains to six volcanogenic massive sulphide deposits in the Troodos ophiolite of Cyprus. These deposits represent hydrothermal activity on deep (2500–5000 m) arc-related spreading ridge(s) in the Neotethyan Ocean over several million years during the late Cenomanian and earliest Turonian. The Cyprus vent communities consist of worm tubes, representing possible vestimentiferans and serpulids, together with a moderate diversity of abyssochrysoid gastropods, belonging to eight new species (Desbruyeresia kinousaensis sp. nov., Desbruyeresia memiensis sp. nov., Desbruyeresia kambiaensis sp. nov., Hokkaidoconcha morisseaui sp. nov., Ascheria canni sp. nov., Cyprioconcha robertsoni gen. et sp. nov., Paskentana xenophontosi sp. nov. and Paskentana dixoni sp. nov.) in five genera and three families; none of the species is shared between vent sites. A single gaudryceratid ammonite from one of the vent sites most likely represents a water-logged shell that sank from surface waters. The gastropod fauna contains the first representatives of the genera Desbruyeresia, Hokkaidoconcha, Ascheria and Paskentana from hydrothermal vents, and also the youngest representative of the last-named genus in any environment. The Cypriot vent communities share tube worms with slightly older (Cenomanian) and younger (Turonian–Santonian) vent communities elsewhere in the western part of the Neotethyan Ocean

Emotions and Digital Well-being. The rationalistic bias of social media design in online deliberations

In this chapter we argue that emotions are mediated in an incomplete way in online social media because of the heavy reliance on textual messages which fosters a rationalistic bias and an inclination towards less nuanced emotional expressions. This incompleteness can happen either by obscuring emotions, showing less than the original intensity, misinterpreting emotions, or eliciting emotions without feedback and context. Online interactions and deliberations tend to contribute rather than overcome stalemates and informational bubbles, partially due to prevalence of anti-social emotions. It is tempting to see emotions as being the cause of the problem of online verbal aggression and bullying. However, we argue that social media are actually designed in a predominantly rationalistic way, because of the reliance on text-based communication, thereby filtering out social emotions and leaving space for easily expressed antisocial emotions. Based on research on emotions that sees these as key ingredients to moral interaction and deliberation, as well as on research on text-based versus non-verbal communication, we propose a richer understanding of emotions, requiring different designs of online deliberation platforms. We propose that such designs should move from text-centred designs and should find ways to incorporate the complete expression of the full range of human emotions so that these can play a constructive role in online deliberations

Interpreting and acting upon home blood pressure readings: A qualitative study

This article is made available through the Brunel Open Access Publishing Fund. Copyright @ 2013 Vasileiou et al.; licensee BioMed Central Ltd. This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/2.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.Background: Recent guidelines recognize the importance of home blood pressure monitoring (HBPM) as an adjunct to clinical measurements. We explored how people who have purchased and use a home blood pressure (BP) monitor make sense of, and act upon, readings and how they communicate with their doctor about the practice of home monitoring. Methods: A qualitative study was designed and participants were purposively recruited from several areas in England, UK. Semi-structured in-depth interviews were conducted with 18 users of home BP monitors. The transcribed data were thematically analysed. Results: Interpretation of home BP readings is complex, and is often characterised by uncertainty. People seek to assess value normality using ‘rules of thumb’, and often aim to identify the potential causes of the readings. This is done by drawing on lay models of BP function and by contextualising the readings to personal circumstances. Based on the perceived causes of the problematic readings, actions are initiated, mostly relating to changes in daily routines. Contacting the doctor was more likely when the problematic readings persisted and could not be easily explained, or when participants did not succeed in regulating their BP through their other interventions. Most users had notified their doctor of the practice of home monitoring, but medical involvement varied, with some participants reporting disinterest or reservations by doctors. Conclusions: Involvement from doctors can help people overcome difficulties and resolve uncertainties around the interpretation of home readings, and ensure that the rules of thumb are appropriate. Home monitoring can be used to strengthen the patient-clinician relationship

Does self-monitoring reduce blood pressure? Meta-analysis with meta-regression of randomized controlled trials

Introduction. Self-monitoring of blood pressure (BP) is an increasingly common part of hypertension management. The objectives of this systematic review were to evaluate the systolic and diastolic BP reduction, and achievement of target BP, associated with self-monitoring. Methods. MEDLINE, Embase, Cochrane database of systematic reviews, database of abstracts of clinical effectiveness, the health technology assessment database, the NHS economic evaluation database, and the TRIP database were searched for studies where the intervention included self-monitoring of BP and the outcome was change in office/ambulatory BP or proportion with controlled BP. Two reviewers independently extracted data. Meta-analysis using a random effects model was combined with meta-regression to investigate heterogeneity in effect sizes. Results. A total of 25 eligible randomized controlled trials (RCTs) (27 comparisons) were identified. Office systolic BP (20 RCTs, 21 comparisons, 5,898 patients) and diastolic BP (23 RCTs, 25 comparisons, 6,038 patients) were significantly reduced in those who self-monitored compared to usual care (weighted mean difference (WMD) systolic −3.82 mmHg (95% confidence interval −5.61 to −2.03), diastolic −1.45 mmHg (−1.95 to −0.94)). Self-monitoring increased the chance of meeting office BP targets (12 RCTs, 13 comparisons, 2,260 patients, relative risk = 1.09 (1.02 to 1.16)). There was significant heterogeneity between studies for all three comparisons, which could be partially accounted for by the use of additional co-interventions. Conclusion. Self-monitoring reduces blood pressure by a small but significant amount. Meta-regression could only account for part of the observed heterogeneity

A System Dynamics Approach for Modeling Return on Quality for ECS Industry

The Electronic Components and Systems industry (ECS) is characterized by long lead times and high market volatility. Besides fast technological development within this industry, cyclic market up- and downturns are influencing the semiconductor market. Therefore, adequate capacity and inventory management as well as continuous process improvements are important success factors for semiconductor companies to be competitive. In this study, the authors focus on a manufacturing excellence approach to increase front-end supply reliability and the availability of inventory within the customer order decoupling point. Here, development and manufacturing processes must be designed in a way that highest levels of product quality, flexibility, time and costs are reached. The purpose of this study is to explore the impact of return on quality in manufacturing systems. Therefore, multimethod simulation modelling including discrete-event and system dynamics simulation is applied

Predicting growth and curve progression in the individual patient with adolescent idiopathic scoliosis: design of a prospective longitudinal cohort study

<p>Abstract</p> <p>Background</p> <p>Scoliosis is present in 3-5% of the children in the adolescent age group, with a higher incidence in females. Treatment of adolescent idiopathic scoliosis is mainly dependent on the progression of the scoliotic curve. There is a close relationship between curve progression and rapid (spinal) growth of the patient during puberty. However, until present time no conclusive method was found for predicting the timing and magnitude of the pubertal growth spurt in total body height, or the curve progression of the idiopathic scoliosis.</p> <p>The goal of this study is to determine the predictive value of several maturity indicators that reflect growth or remaining growth potential, in order to predict timing of the peak growth velocity of total body height in the individual patient with adolescent idiopathic scoliosis. Furthermore, different parameters are evaluated for their correlation with curve progression in the individual scoliosis patient.</p> <p>Methods/design</p> <p>This prospective, longitudinal cohort study will be incorporated in the usual care of patients with adolescent idiopathic scoliosis. All new patients between 8 and 17 years with adolescent idiopathic scoliosis (Cobb angle >10 degrees) visiting the outpatient clinic of the University Medical Center Groningen are included in this study. Follow up will take place every 6 months. The present study will use a new ultra-low dose X-ray system which can make total body X-rays. Several maturity indicators are evaluated like different body length dimensions, secondary sexual characteristics, skeletal age in hand and wrist, skeletal age in the elbow, the Risser sign, the status of the triradiate cartilage, and EMG ratios of the paraspinal muscle activity.</p> <p>Correlations of all dimensions will be calculated in relationship to the timing of the pubertal growth spurt, and to the progression of the scoliotic curve. An algorithm will be made for the optimal treatment strategy in the individual patient with adolescent idiopathic scoliosis.</p> <p>Discussion</p> <p>This study will determine the value of many maturity indicators and will be useful as well for other clinicians treating children with disorders of growth. Since not all clinicians have access to the presented new 3D X-ray system or have the time to make EMG's, for example, all indicators will be correlated to the timing of the peak growth velocity of total body height and curve progression in idiopathic scoliosis. Therefore each clinician can chose which indicators can be used best in their practice.</p> <p>Trial registration number</p> <p>NTR2048</p

Predicting the peak growth velocity in the individual child: validation of a new growth model

Predicting the peak growth velocity in an individual patient with adolescent idiopathic scoliosis is essential or determining the prognosis of the disorder and timing of the (surgical) treatment. Until the present time, no accurate method has been found to predict the timing and magnitude of the pubertal growth spurt in the individual child. A mathematical model was developed in which the partial individual growth velocity curve was linked to the generic growth velocity curve. The generic curve was shifted and stretched or shrunk, both along the age axis and the height velocity axis. The individual age and magnitude of the PGV were obtained from the new predicted complete growth velocity curve. Predictions were made using 2, 1.5, 1 and 0.5 years of the available longitudinal data of the individual child, starting at different ages. The predicted values of 210 boys and 162 girls were compared to the child’s own original values of the PGV. The individual differences were compared to differences obtained when using the generic growth velocity curve as a standard. Using 2 years of data as input for the model, all predictions of the age of the PGV in boys and girls were significantly better in comparison to using the generic values. Using only 0.5 years of data as input, the predictions with a starting age from 13 to 15.5 years in boys and from 9.5 to 14.5 years in girls were significantly better. Similar results were found for the predictions of the magnitude of the PGV. This model showed highly accurate results in predicting the individual age and magnitude of the PGV, which can be used in the treatment of patients with adolescent idiopathic scoliosis

DNA Barcoding in the Cycadales: Testing the Potential of Proposed Barcoding Markers for Species Identification of Cycads

Barcodes are short segments of DNA that can be used to uniquely identify an unknown specimen to species, particularly when diagnostic morphological features are absent. These sequences could offer a new forensic tool in plant and animal conservation—especially for endangered species such as members of the Cycadales. Ideally, barcodes could be used to positively identify illegally obtained material even in cases where diagnostic features have been purposefully removed or to release confiscated organisms into the proper breeding population. In order to be useful, a DNA barcode sequence must not only easily PCR amplify with universal or near-universal reaction conditions and primers, but also contain enough variation to generate unique identifiers at either the species or population levels. Chloroplast regions suggested by the Plant Working Group of the Consortium for the Barcode of Life (CBoL), and two alternatives, the chloroplast psbA-trnH intergenic spacer and the nuclear ribosomal internal transcribed spacer (nrITS), were tested for their utility in generating unique identifiers for members of the Cycadales. Ease of amplification and sequence generation with universal primers and reaction conditions was determined for each of the seven proposed markers. While none of the proposed markers provided unique identifiers for all species tested, nrITS showed the most promise in terms of variability, although sequencing difficulties remain a drawback. We suggest a workflow for DNA barcoding, including database generation and management, which will ultimately be necessary if we are to succeed in establishing a universal DNA barcode for plants