Rheology at the micro-scale: new tools for bio-analysis

We present a simple and non-invasive experimental procedure to measure the linear viscoelastic properties of cells by passive particle tracking microrheology. In order to do this, a generalised Langevin equation is adopted to relate the timedependent thermal fluctuations of a probe sensor, immobilised to the cell’s membrane, to the frequency-dependent viscoelastic moduli of the cell. The method has been validated by measuring the linear viscoelastic response of a soft solid and then applied to cell physiology studies. It is shown that the viscoelastic moduli are related to the cell’s cytoskeletal structure, which in this work is modulated either by inhibiting the actin/myosin-II interactions by means of blebbistatin or by varying the solution osmolarity from iso- to hypo-osmotic conditions. The insights gained from this form of rheological analysis promises to be a valuable addition to physiological studies; e.g. cell physiology during pathology and pharmacological response

Discovery of a redshift 6.13 quasar in the UKIRT infrared deep sky survey

Original article can be found at: http://www.aanda.org/ Copyright The European Southern Observatory (ESO) DOI: 10.1051/0004-6361/200811161Optical and near-infrared (NIR) spectra are presented for ULAS J131911.29+095051.4 (hereafter ULAS J1319+0950), a new redshift z = 6.127 0.004 quasar discovered in the Third Data Release (DR3) of the UKIRT Infrared Deep Sky Survey (UKIDSS). The source has = 19.10 0.03, corresponding to = -27.12, which is comparable to the absolute magnitudes of the z 6 quasars discovered in the Sloan Digital Sky Survey (SDSS). ULAS J1319+0950 was, in fact, registered by SDSS as a faint source with = 20.13 0.12, just below the signal-to-noise ratio limit of the SDSS high-redshift quasar survey. The faint z-band magnitude is a consequence of the weak Ly /N V emission line, which has a rest-frame equivalent width of ~20Å and provides only a small boost to the z-band flux. Nevertheless, there is no evidence of a significant new population of high-redshift quasars with weak emission lines from this UKIDSS-based search. The Ly  optical depth to ULAS J1319+0950 is consistent with that measured towards similarly distant SDSS quasars, implying that results from optical- and NIR-selected quasars may be combined in studies of cosmological reionization. Also presented is a new NIR-spectrum of the previously discovered UKIDSS quasar ULAS J020332.38+001229.2, which reveals the object to be a broad absorption line quasar. The new spectrum shows that the emission line initially identified as Ly  is actually N V, leading to a revised redshift of z = 5.72, rather than z = 5.86 as previously estimatedPeer reviewe

Experimental studies of the effect of rapid afterburn on shock development of near-field explosions

Many conventional high explosives do not contain sufficient internal oxygen to fully combust the gaseous products which result from detonation of the explosive material. Because of this, under-oxygenated explosives continue to burn after detonation. This process, called afterburn, is known to influence the late-time pressure and energy released by the explosive, which has particular significance for confined explosives. Recent experimental work at the University of Sheffield, along with a small number of previous studies, has shown that some afterburn occurs at timescales commensurate with the development of the shock wave. This article presents the results from a series of tests measuring the reflected pressure acting on a rigid target following the detonation of small explosive charges. High-speed video is used to capture the emerging structure of the detonation products and air shock, while the spatial and temporal distributions of the reflected pressure are recorded using an array of 17 Hopkinson pressure bars set flush with an effectively rigid target. Tests are conducted in inert atmospheres and oxygen-rich atmospheres in order to assess the contribution of rapid afterburn on the development of the shock front and interaction with a rigid target situated close to the explosive charge. The results show that early-stage afterburn has a significant influence on the reflected shock parameters in the near-field

Development of EM-CCD-based X-ray detector for synchrotron applications

A high speed, low noise camera system for crystallography and X-ray imaging applications is developed and successfully demonstrated. By coupling an electron-multiplying (EM)-CCD to a 3:1 fibre-optic taper and a CsI(Tl) scintillator, it was possible to detect hard X-rays. This novel approach to hard X-ray imaging takes advantage of sub-electron equivalent readout noise performance at high pixel readout frequencies of EM-CCD detectors with the increase in the imaging area that is offered through the use of a fibre-optic taper. Compared with the industry state of the art, based on CCD camera systems, a high frame rate for a full-frame readout (50 ms) and a lower readout noise (<1 electron root mean square) across a range of X-ray energies (6–18 keV) were achieved

Developing sustainable small-scale fisheries livelihoods in Indonesia: Trends, enabling and constraining factors, and future opportunities

Small-scale fisheries (SSF) provide crucial contributions to livelihoods, food and nutrition security, and the well-being of coastal communities worldwide. In Indonesia, 2.5 million households are involved in SSF production, yet these households are characterised by high poverty rates and vulnerability due to declining ecosystem health and climatic change. In this study we applied the Sustainable Livelihoods Framework to analyse the characteristics and immediate and longer-term outcomes of 20 SSF livelihood-focused intervention programs implemented in coastal communities across the Indonesian Archipelago over the last two decades. Projects covered a wide range of spatial scales, funding providers and key participants. Factors supporting positive program outcomes included application of inclusive and holistic approaches to sustainable livelihoods, implemented and supported over appropriate time frames; use of participatory capacity development methodologies and locally-situated project facilitators; and collaborative engagement with local government, non-government organisations and private-sector actors. However, it was impossible to identify evidenced successes from a longer-term sustainability perspective. Short project timeframes, absence of baseline or monitoring data, pressure for satisfactory reports to donors, and limited post-project evaluation, together with invisibility of women’s work and non-commercial exchanges, affected the adequacy of assessments. Given the lack of post-project assessment among projects studied, a thorough review of longer-term project impacts is recommended, guided by the Sustainable Livelihoods Framework, to evaluate sustained improvements in livelihoods outcomes and environmental sustainability. This would support best-practice design and implementation of SSF livelihood-focused interventions, disseminated beyond academia, to influence policy and development to achieve socio-economic equity and environmental goals

Finite element simulation of plates under non-uniform blast loads using a point-load method: Buried explosives

There are two primary challenges associated with assessing the adequacy of a protective structure to resist explosive events: firstly the spatial variation of load acting on a target must be predicted to a sufficient level of accuracy; secondly, the response of the target to this load must also be quantified. When a high explosive is shallowly buried in soil, the added confinement given by the geotechnical material results in a blast which is predominantly directed vertically. This imparts an extremely high magnitude, spatially non-uniform load on the target structure. A recently commissioned experimental rig designed by the authors has enabled direct measurements of the blast load resulting from buried explosive events. These direct measurements have been processed using an in-house interpolation routine which evaluates the load acting over a regular grid of points. These loads can then be applied as the nodal-point loads in a finite element model. This paper presents results from a series of experiments where a free-flying plate was suspended above a shallow buried explosive. Dynamic and residual deformations are compared with finite element simulations of plates using the experimentally recorded, and interpolated, nodal point-loads. The results show very good agreement and highlight the use of this method for evaluating the efficacy of targets subjected to non-uniform blast loads

Healthcare Provider N95 Respirator Contamination Worn Behind Face Shields With SARS-CoV-2 During Routine Clinical Care of Patients With COVID-19

N95 respirator contamination with severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) during clinical care of patients with coronavirus disease 2019 is poorly understood. We performed a prospective observational study on healthcare provider's (HCP's) N95 respirators' and face shields' SARS-CoV-2 contamination during aerosol-generating procedures on SARS-CoV-2- positive patients housed in a COVID-19-specific unit. Medical masks worn on top of HCP's N95 respirators, and under face shields, during study aerosol-generating procedures were used as surrogates to detect contamination to avoid waste. Thirtythree HCPs were studied, and a total of 33 mask and 27 face shields were sampled. Masks were cut into 9 pieces and face shields were sampled twice, front and back, to determine locality of contamination; however, no positive samples were identified using standard polymerase chain reaction techniques with a CT value up to 40. All 9 mask piece samples were then pooled, as were face shield samples, using centrifugal concentration with polyethersulfone membranes. Once pooled and concentrated, overall, 9 (15%) samples were positive via real-time polymerase chain reaction: 5 from masks (15.2%) and 4 from face shields (14.8%)

Ring exchange, the Bose metal, and bosonization in two dimensions

Motivated by the high-T_c cuprates, we consider a model of bosonic Cooper pairs moving on a square lattice via ring exchange. We show that this model offers a natural middle ground between a conventional antiferromagnetic Mott insulator and the fully deconfined fractionalized phase which underlies the spin-charge separation scenario for high-T_c superconductivity. We show that such ring models sustain a stable critical phase in two dimensions, the *Bose metal*. The Bose metal is a compressible state, with gapless but uncondensed boson and ``vortex'' excitations, power-law superconducting and charge-ordering correlations, and broad spectral functions. We characterize the Bose metal with the aid of an exact plaquette duality transformation, which motivates a universal low energy description of the Bose metal. This description is in terms of a pair of dual bosonic phase fields, and is a direct analog of the well-known one-dimensional bosonization approach. We verify the validity of the low energy description by numerical simulations of the ring model in its exact dual form. The relevance to the high-T_c superconductors and a variety of extensions to other systems are discussed, including the bosonization of a two dimensional fermionic ring model

Topology and correlations in structured scale-free networks

We study a recently introduced class of scale-free networks showing a high clustering coefficient and non-trivial connectivity correlations. We find that the connectivity probability distribution strongly depends on the fine details of the model. We solve exactly the case of low average connectivity, providing also exact expressions for the clustering and degree correlation functions. The model also exhibits a lack of small world properties in the whole parameters range. We discuss the physical properties of these networks in the light of the present detailed analysis.Comment: 10 pages, 9 figure

Cross-over behaviour in a communication network

We address the problem of message transfer in a communication network. The network consists of nodes and links, with the nodes lying on a two dimensional lattice. Each node has connections with its nearest neighbours, whereas some special nodes, which are designated as hubs, have connections to all the sites within a certain area of influence. The degree distribution for this network is bimodal in nature and has finite variance. The distribution of travel times between two sites situated at a fixed distance on this lattice shows fat fractal behaviour as a function of hub-density. If extra assortative connections are now introduced between the hubs so that each hub is connected to two or three other hubs, the distribution crosses over to power-law behaviour. Cross-over behaviour is also seen if end-to-end short cuts are introduced between hubs whose areas of influence overlap, but this is much milder in nature. In yet another information transmission process, namely, the spread of infection on the network with assortative connections, we again observed cross-over behaviour of another type, viz. from one power-law to another for the threshold values of disease transmission probability. Our results are relevant for the understanding of the role of network topology in information spread processes.Comment: 12 figure