29,846 research outputs found

    Independent Orbiter Assessment (IOA): FMEA/CIL assessment

    Get PDF
    The McDonnell Douglas Astronautics Company (MDAC) was selected to perform an Independent Orbiter Assessment (IOA) of the Failure Modes and Effects Analysis (FMEA) and Critical Items List (CIL). Direction was given by the Orbiter and GFE Projects Office to perform the hardware analysis and assessment using the instructions and ground rules defined in NSTS 22206. The IOA analysis featured a top-down approach to determine hardware failure modes, criticality, and potential critical items. To preserve independence, the analysis was accomplished without reliance upon the results contained within the NASA and Prime Contractor FMEA/CIL documentation. The assessment process compared the independently derived failure modes and criticality assignments to the proposed NASA post 51-L FMEA/CIL documentation. When possible, assessment issues were discussed and resolved with the NASA subsystem managers. Unresolved issues were elevated to the Orbiter and GFE Projects Office manager, Configuration Control Board (CCB), or Program Requirements Control Board (PRCB) for further resolution. The most important Orbiter assessment finding was the previously unknown stuck autopilot push-button criticality 1/1 failure mode. The worst case effect could cause loss of crew/vehicle when the microwave landing system is not active. It is concluded that NASA and Prime Contractor Post 51-L FMEA/CIL documentation assessed by IOA is believed to be technically accurate and complete. All CIL issues were resolved. No FMEA issues remain that have safety implications. Consideration should be given, however, to upgrading NSTS 22206 with definitive ground rules which more clearly spell out the limits of redundancy

    Independent Orbiter Assessment (IOA): CIL issues resolution report, volume 1

    Get PDF
    The results of the Independent Orbiter Assessment (IOA) of the Failure Modes and Effects Analysis (FMEA) and Critical Items List (CIL) are presented. This report contains IOA assessment worksheets showing resolution of outstanding IOA CIL issues that were summarized in the IOA FMEA/CIL Assessment Interim Report, dated 9 March 1988. Each assessment worksheet has been updated with CIL issue resolution and rationale. The NASA and Prime Contractor post 51-L FMEA/CIL documentation assessed is believed to be technically accurate and complete. No assessment issues remain that has safety implications. Volume 1 contain worksheets for the following sybsystems: Landing and Deceleration Subsystem; Purge, Vent and Drain Subsystem; Active Thermal Control and Life Support Systems; Crew Equipment Subsystem; Instrumentation Subsystem; Data Processing Subsystem; Atmospheric Revitalization Pressure Control Subsystem; Hydraulics and Water Spray Boiler Subsystem; and Mechanical Actuation Subsystem

    High-m Kink/Tearing Modes in Cylindrical Geometry

    Full text link
    The global ideal kink equation, for cylindrical geometry and zero beta, is simplified in the high poloidal mode number limit and used to determine the tearing stability parameter, Δ′\Delta^\prime. In the presence of a steep monotonic current gradient, Δ′\Delta^\prime becomes a function of a parameter, σ0\sigma_0, characterising the ratio of the maximum current gradient to magnetic shear, and xsx_s, characterising the separation of the resonant surface from the maximum of the current gradient. In equilibria containing a current "spike", so that there is a non-monotonic current profile, Δ′\Delta^\prime also depends on two parameters: κ\kappa, related to the ratio of the curvature of the current density at its maximum to the magnetic shear, and xsx_s, which now represents the separation of the resonance from the point of maximum current density. The relation of our results to earlier studies of tearing modes and to recent gyro-kinetic calculations of current driven instabilities, is discussed, together with potential implications for the stability of the tokamak pedestal.Comment: To appear in Plasma Physics and Controlled Fusio

    Vortex density fluctuations in quantum turbulence

    Full text link
    We compute the frequency spectrum of turbulent superfluid vortex density fluctuations and obtain the same Kolmogorov scaling which has been observed in a recent experiment in Helium-4. We show that the scaling can be interpreted in terms of the spectrum of reconnecting material lines. The calculation is performed using a vortex tree algorithm which considerably speeds up the evaluation of Biot-Savart integrals.Comment: 7 Pages, 7 figure

    Heat Capacity Mapping Radiometer (HCMR) data processing algorithm, calibration, and flight performance evaluation

    Get PDF
    The rationale and procedures used in the radiometric calibration and correction of Heat Capacity Mapping Mission (HCMM) data are presented. Instrument-level testing and calibration of the Heat Capacity Mapping Radiometer (HCMR) were performed by the sensor contractor ITT Aerospace/Optical Division. The principal results are included. From the instrumental characteristics and calibration data obtained during ITT acceptance tests, an algorithm for post-launch processing was developed. Integrated spacecraft-level sensor calibration was performed at Goddard Space Flight Center (GSFC) approximately two months before launch. This calibration provided an opportunity to validate the data calibration algorithm. Instrumental parameters and results of the validation are presented and the performances of the instrument and the data system after launch are examined with respect to the radiometric results. Anomalies and their consequences are discussed. Flight data indicates a loss in sensor sensitivity with time. The loss was shown to be recoverable by an outgassing procedure performed approximately 65 days after the infrared channel was turned on. It is planned to repeat this procedure periodically

    Adelic Integrable Systems

    Get PDF
    Incorporating the zonal spherical function (zsf) problems on real and pp-adic hyperbolic planes into a Zakharov-Shabat integrable system setting, we find a wide class of integrable evolutions which respect the number-theoretic properties of the zsf problem. This means that at {\it all} times these real and pp-adic systems can be unified into an adelic system with an SS-matrix which involves (Dirichlet, Langlands, Shimura...) L-functions.Comment: 23 pages, uses plain TE

    On a q-analogue of the multiple gamma functions

    Full text link
    A qq-analogue of the multiple gamma functions is introduced, and is shown to satisfy the generalized Bohr-Morellup theorem. Furthermore we give some expressions of these function.Comment: 8 pages, AMS-Late
    • …
    corecore