Microwave tunable laser source: A stable, precision tunable heterodyne local oscillator

The development and capabilities of a tunable laser source utilizing a wideband electro-optic modulator and a CO2 laser are described. The precision tunability and high stability of the device are demonstrated with examples of laboratory spectroscopy. Heterodyne measurements are also presented to demonstrate the performance of the laser source as a heterodyne local oscillator. With the use of five CO2 isotope lasers and the 8 to 18 GHz sideband offset tunability of the modulator, calculations indicate that 50 percent spectral coverage in the 9 to 12 micron region is achievable. The wavelength accuracy and stability of this laser source is limited by the CO2 laser and is more than adequate for the measurement of narrow Doppler-broadened line profiles. The room-temperature operating capability and the programmability of the microwave tunable laser source are attractive features for its in-the-field implementation. Although heterodyne measurements indicated some S/N degradation when using the device as a local oscillator, there does not appear to be any fundamental limitation to the heterodyne efficiency of this laser source. Through the use of a lower noise-figure traveling wave tube amplifier and optical matching of the output beam with the photomixer, a substantial increase in the heterodyne S/N is expected

Non-mechanical optical path switching and its application to dual beam spectroscopy including gas filter correlation radiometry

A non-mechanical optical switch is developed for alternately switching a monochromatic or quasi-monochromatic light beam along two optical paths. A polarizer polarizes light into a single, e.g., vertical component which is then rapidly modulated into vertical and horizontal components by a polarization modulator. A polarization beam splitter then reflects one of these components along one path and transmits the other along the second path. In the specific application of gas filter correlation radiometry, one path is directed through a vacuum cell and one path is directed through a gas correlation cell containing a desired gas. Reflecting mirrors cause these two paths to intersect at a second polarization beam splitter which reflects one component and transmits the other to recombine them into a polarization modulated beam which can be detected by an appropriate single sensor

Novel Approaches for the Ultrasonic NDE of Thick and other Composites

This paper summarizes several recent developments which are facilitating new approaches for both active and passive quantitative ultrasonic measurements in composite materials. These include the development of point sources and point receivers, a theory for analyzing the propagation of transient elastic waves through a bounded, dispersive and attenuative medium, and the development and implementation of appropriate signal processing algorithms. An alternative to these deterministic approaches is a processing scheme based on a simulated intelligent system which processes the signals like a neural network. Examples of applications of these ideas to the NDE of composite materials are shown

Optical path switching based differential absorption radiometry for substance detection

An optical path switch divides sample path radiation into a time series of alternating first polarized components and second polarized components. The first polarized components are transmitted along a first optical path and the second polarized components along a second optical path. A first gasless optical filter train filters the first polarized components to isolate at least a first wavelength band thereby generating first filtered radiation. A second gasless optical filter train filters the second polarized components to isolate at least a second wavelength band thereby generating second filtered radiation. A beam combiner combines the first and second filtered radiation to form a combined beam of radiation. A detector is disposed to monitor magnitude of at least a portion of the combined beam alternately at the first wavelength band and the second wavelength band as an indication of the concentration of the substance in the sample path

Studies of acoustic emission from point and extended sources

The use of simulated and controlled acoustic emission signals forms the basis of a powerful tool for the detailed study of various deformation and wave interaction processes in materials. The results of experiments and signal analyses of acoustic emission resulting from point sources such as various types of indentation-produced cracks in brittle materials and the growth of fatigue cracks in 7075-T6 aluminum panels are discussed. Recent work dealing with the modeling and subsequent signal processing of an extended source of emission in a material is reviewed. Results of the forward problem and the inverse problem are presented with the example of a source distributed through the interior of a specimen

Summary of 1978 Southeastern Virginia Urban Plume study: Aircraft results for carbon monoxide, methane, nonmethane hydrocarbons, and ozone

The characteristics of the Southeastern Virginia urban plume were defined with emphasis on the photon-oxidant species. The measurement area was a rectangle, approximately 150 km by 100 km centered around Cape Charles, Virginia. Included in this area are the cities of Norfolk, Virginia Beach, Chesapeake, Newport News, and Hampton. The area is bounded on the north by Wallops Island, Virginia, and on the south by the Hampton Roads area of Tidewater Virginia. The major axis of the rectangle is oriented in the southwest-northeast direction. The data set includes aircraft measurements for carbon monoxide, methane, nonmethane hydrocarbons, and ozone. The experiment shows that CO can be successfully measured as a tracer gas and used as an index for determining localized and urban plumes. The 1978 data base provided sufficient data to assess an automated chromatograph with flame ionization detection used for measuring methane and nonmethane hydrocarbons in flight

In situ evidence for renitrification in the Arctic lower stratosphere during the polar aura validation experiment (PAVE)

In-situ measurements of nitric acid (HNO3), ozone (O3), and nitrous oxide (N2O) were made from the NASA DC-8 during the Polar Aura Validation Experiment in January/February 2005. In the lower stratosphere (9–12.5 km, potential temperature 300–350 K) characteristic compact relationships were observed between all three gases. The ratio HNO3/O3 averaged 3.5 (±0.7) ppt/ppb. Samples with enhanced HNO3/O3 (\u3e4.0) were most abundant under the edge of the Arctic Polar vortex in airmasses with enhanced mixing ratios of both gases (\u3e400 ppb O3 and \u3e2000 ppt HNO3) and reduced mixing ratios of N2O (\u3c305 ppb), indicating air from higher levels in the stratosphere. Relationships to N2O in the anomalous samples under the vortex edge indicate that increases in HNO3/O3 reflect renitrification at DC-8 flight levels, with no indication of significant O3 loss. Renitrified air was only observed at potential temperatures above 340 K, and was most abundant on the PAVE flights on 27 and 29 January

System and Method for Determining Gas Optical Density Changes in a Non-Linear Measurement Regime

Each of two sensors, positioned to simultaneously detect electromagnetic radiation absorption along a path, is calibrated to define a unique response curve associated therewith that relates a change in voltage output for each sensor to a change in optical density. A ratio-of-responses curve is defined by a ratio of the response curve associated with the first sensor to the response curve associated with the second sensor. A ratio of sensor output changes is generated using outputs from the sensors. An operating point on the ratio-of-responses curve is established using the ratio of sensor output changes. The established operating point is indicative of an optical density. When the operating point is in the non-linear response region of at least one of the sensors, the operating point and optical density corresponding thereto can be used to establish an actual response of at least one of the sensors whereby the actual sensor output can be used in determining changes in the optical density

Distribution of hydrogen peroxide and methylhydroperoxide over the Pacific and South Atlantic Oceans

The gas phase hydrogen peroxide and methylhydroperoxide concentrations were measured in the troposphere over the tropical Pacific Ocean as a component of NASA's Global Tropospheric Experiment/Pacific Exploratory Mission-Tropics A field campaign. Flights on two aircraft covered the Pacific from 70°S to 60°N and 110°E to 80°W and South Atlantic from 40°S to 15°N and 45°W to 70°E, and extending from 76 to 13,000 m altitude. H2O2 and CH3OOH have the highest concentrations at a given altitude at the equator and decrease with increasing latitude in both the northern and southern hemispheres. Above 4 km the gradient is substantially reduced for both H2O2 and CH3OOH with latitude, and at altitudes in excess of 8 km there is no latitudinal dependence. H2O2 and CH3OOH exhibit maximum mixing ratios between 1 and 2 km at all latitudes. The mean mixing ratio of H2O2 at the equator was 1600 ± 600 parts per trillion by volume (pptv) decreasing to 500 ± 250 pptv at latitudes greater than 55° north and south between 1 and 2 km altitude. CH3OOH at the equator was 1400 ± 250 pptv, decreasing to 330 ± 200 pptv at high latitudes at altitudes between 1 and 2 km. The concentration of peroxides at high latitudes in the northern hemisphere was generally a factor of 2 higher than at corresponding latitudes in the southern hemisphere. The ratio of H2O2 to CH3OOH was between 1 and 2 from 45°S to 35°N at altitudes below 4 km. Between 5° to 15°N the ratio is less than 1, due to preferential removal of H2O2 in the Intertropical Convergence Zone. Copyright 1999 by the American Geophysical Union

Impact of multiscale dynamical processes and mixing on the chemical composition of the upper troposphere and lower stratosphere during the Intercontinental Chemical Transport Experiment–North America

We use high-frequency in situ observations made from the DC8 to examine fine-scale tracer structure and correlations observed in the upper troposphere and lower stratosphere during INTEX-NA. Two flights of the NASA DC-8 are compared and contrasted. Chemical data from the DC-8 flight on 18 July show evidence for interleaving and mixing of polluted and stratospheric air masses in the vicinity of the subtropical jet in the upper troposphere, while on 2 August the DC-8 flew through a polluted upper troposphere and a lowermost stratosphere that showed evidence of an intrusion of polluted air. We compare data from both flights with RAQMS 3-D global meteorological and chemical model fields to establish dynamical context and to diagnose processes regulating the degree of mixing on each day. We also use trajectory mapping of the model fields to show that filamentary structure due to upstream strain deformation contributes to tracer variability observed in the upper troposphere. An Eulerian measure of strain versus rotation in the large-scale flow is found useful in predicting filamentary structure in the vicinity of the jet. Higher-frequency (6–24 km) tracer variability is attributed to buoyancy wave oscillations in the vicinity of the jet, whose turbulent dissipation leads to efficient mixing across tracer gradients